Which Lane to Enter When Turning Right?

1 Answers
SanCharles
07/30/25 12:21am
When making a right turn, vehicles should generally enter the rightmost motor vehicle lane, then accelerate and proceed according to the designated lane. Adapt flexibly based on road conditions: Typically, left turns should enter the leftmost lane, while right turns should enter the rightmost motor vehicle lane (the rightmost motor vehicle lane, not the bicycle lane). For U-turns, the vehicle should align with and enter the corresponding lane. However, adjustments may be necessary depending on road conditions. For example, if there is an obstacle in the leftmost lane during a left turn, the vehicle must use another lane; the same applies for right turns. Penalties for wrong-way driving during right turns: According to Article 90 of the Road Traffic Safety Law, penalties for wrong-way driving include: motor vehicle drivers who violate road traffic safety laws and regulations regarding road usage rules will be given a warning or a corresponding fine. If other provisions of this law apply, penalties will be imposed accordingly.
Was this review help?
4
1
Share
More Forum Discussions

Should the clutch be released after shifting to first gear when pulling over?

When pulling over and shifting to first gear, there is no need to release the clutch. Subject 3, which includes the road driving skills test and the safety and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviated name for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's examination. The content of the road driving skills test varies for different types of vehicles eligible for driving. Below is an introduction to the content of Subject 3: Introduction to Subject 3: Subject 3 includes the road driving skills test and the safety and civilized driving knowledge test, which are part of the motor vehicle driver's license assessment. It is the abbreviated name for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's examination. The content of the road driving skills test varies for different types of vehicles eligible for driving. Content of Subject 3: The road driving skills test of Subject 3 generally includes: preparation before starting, simulated lighting test, starting, driving straight, shifting gears up and down, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, crossing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and driving at night. The safety and civilized driving knowledge test generally includes: requirements for safe and civilized driving operations, knowledge of safe driving under adverse weather and complex road conditions, methods for handling emergencies such as tire blowouts, and knowledge of handling procedures after traffic accidents.
15
4
Share

Can the passenger lie down while driving?

Can the passenger lie down while driving? Legally, there is no explicit prohibition against reclining or lying down in the passenger seat while the car is in motion, so it is not considered a violation. However, it is uncertain whether traffic cameras might capture this and potentially interpret it as the passenger not wearing a seatbelt. Additionally, from a safety perspective, lying flat in the passenger seat poses significant risks. Below are some driving precautions to keep in mind: Check the rearview mirrors: Always use turn signals and slow down when turning or changing lanes, and be sure to check the rearview mirrors before turning. Left turns primarily require checking the left mirror, right turns the right mirror, and both turns should include a glance at the interior rearview mirror. Avoid fixating on the front of the car: When driving on clear roads, focus your gaze about 100 meters ahead rather than staring directly in front of the vehicle. Clutch control: Generally, when decelerating at speeds above 40 km/h, there is no need to press the clutch immediately; wait until the speed drops to around 20 km/h before engaging the clutch. Steering: Turn the wheel slowly for high-speed turns and quickly for low-speed turns.
9
3
Share

How to Solve the Airbag Light Being On?

The solutions for the airbag light being on: 1. If it's due to loose or disconnected wiring, check and securely reconnect the airbag wires under the seats one by one; 2. If it's due to a faulty airbag sensor, replace the driver-side airbag sensor; 3. If there's a fault code present, use specialized equipment to clear the fault code; 4. If it's due to a faulty airbag control unit, replace the airbag control unit. The airbag system is a passive safety protection system that, when used in conjunction with seat belts, provides effective collision protection for occupants. It mainly consists of airbag sensors, collision airbags, and electronic control devices. In domestically produced mid-to-low-end cars, the standard number of airbags is 1 to 2, typically located in the driver and front passenger positions.
3
4
Share

Will I receive a text message if I fail to schedule the Subject 2 test?

Normally, you will receive a text message indicating that the Subject 2 test scheduling has failed. However, in practice, it is common not to receive the message. It is recommended to check online or ask your coach for accurate information to better arrange your schedule. Below are some important notes for the Subject 2 test: Fasten your seatbelt: After getting into the car, fasten your seatbelt immediately. Make sure not to buckle it incorrectly or on the passenger side, as this will result in an automatic failure. Do not unfasten the seatbelt during the entire test. Adjust the seat and mirrors: After entering the car, adjust the seat, mirrors, fasten the seatbelt, turn on the left turn signal, shift to first gear, and release the handbrake. These six steps are essential. Ensure all preparations are complete before starting. No stopping during the test: There is no time limit for reversing into the parking space, but you must not stop during the process. If the wheels remain stationary for 3 seconds, the system will judge it as stopping midway, so controlling the speed is crucial. The time limit for starting on a slope is 30 seconds: The system will give a voice prompt every 10 seconds, and exceeding 30 seconds will result in an automatic failure.
9
2
Share

Can You Pass the Driving Test Subject 3 by Finding Someone to Help?

Subject 3 cannot be passed by finding someone to help. Subject 3, which includes the road driving skills test and the safe and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviated term for the road driving skills and safe and civilized driving knowledge test in the motor vehicle driver's examination. The content of the road driving skills test varies depending on the type of vehicle being licensed. Below is an introduction to the content of the Subject 3 test: Introduction to Subject 3: Subject 3 includes the road driving skills test and the safe and civilized driving knowledge test, which are part of the motor vehicle driver's license assessment. It is the abbreviated term for the road driving skills and safe and civilized driving knowledge test in the motor vehicle driver's examination. The content of the road driving skills test varies depending on the type of vehicle being licensed. Content of the Subject 3 Test: The road driving skills test for Subject 3 generally includes: preparation before driving, simulated lighting test, starting, driving straight, shifting gears, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, passing through pedestrian crossings, passing through school zones, passing through bus stops, meeting oncoming vehicles, overtaking, making U-turns, and driving at night. The safe and civilized driving knowledge test generally includes: requirements for safe and civilized driving operations, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations such as tire blowouts, and knowledge of post-accident handling procedures.
19
1
Share

What does the SVS light indicate as a fault?

SVS light is the engine fault indicator light, resembling the shape of an engine. This light will illuminate when the vehicle's ignition key is turned on and will turn off after the vehicle starts. When the engine ECU detects a fault, the SVS light will illuminate. If this light comes on while the vehicle is in motion, it indicates that there is a fault with the vehicle's engine. The SVS fault indicator light is a warning light that appears when the ECU or TCU of an electronically fuel-injected vehicle detects a problem with the engine or automatic transmission. Therefore, all electronically fuel-injected vehicles are equipped with an SVS fault indicator light. For manual transmission vehicles, it indicates an engine fault, while for automatic transmission vehicles, it indicates both engine and automatic transmission faults. It is recommended to visit a repair shop for inspection as soon as possible.
12
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.