Which lane to enter when making a right turn in Subject 3?
4 Answers
In Subject 3, turn left into the fast lane and turn right into the slow lane. The road driving skill test content of Subject 3 generally includes: preparation before getting on the car, light simulation test, starting, driving in a straight line, shifting gears, changing lanes, parking on the side, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stations, meeting vehicles, overtaking, making U-turns, and driving at night. Here are some tips for the Subject 3 test: Follow the prompt instructions: Listen carefully to the voice broadcast instructions of Subject 3, and then follow the prompt instructions. Remember not to perform operations in advance before the voice broadcast ends. You must wait until the voice broadcast ends before proceeding to the next step. Pay attention to special areas: In many areas, the voice broadcast no longer reminds special areas such as school zones, bus stations, and pedestrian crossings, but candidates must make corresponding deceleration or avoidance operations based on the project signs and road markings on the roadside. In school zones, step on the brake 10 meters away from the project sign, and the speed should be below 30km/h. At bus stations, step on the brake 10 meters away from the project sign, and the speed should be below 30km/h. Within 30 meters before a pedestrian crossing, step on the brake to decelerate, and stop to yield if there are pedestrians passing.
When taking the driving test for Subject 3, as a beginner who just started learning to drive, I remember that turning right must be done into the far-right lane, which was a key point repeatedly emphasized by the instructor. On the actual test route, you must strictly follow traffic rules—turning right can only be done into the far-right lane; otherwise, the examiner will deduct major points or even result in failure. The reason is simple: this helps avoid interfering with straight-going or left-turning vehicles and reduces the risk of accidents. During practice, I once made the mistake of turning into the middle lane, and the instructor reminded me that safety comes first—before turning, signal, check the rearview mirror and blind spots, and ensure a smooth turn into the right lane. Watching test videos or simulating road conditions regularly helps build good habits for an easy pass.
Over the years of driving, I've encountered many road sections similar to the Category 3 driving test, where right turns should typically enter the rightmost lane. Traffic rules and examination standards are largely consistent: right turns must not occupy other lanes to avoid congestion or conflicts. During the test, entering the wrong lane will result in immediate failure by the examiner; in reality, some intersections have special signs, but it's best not to take risks during the test. It's recommended that beginners focus on slow-speed turns during practice while checking intersection signals and pedestrians—safety comes first. Once familiar with the test route, these details will become second nature.
In the Subject 3 driving test, turning right into the rightmost lane is a mandatory rule. Safety-wise, this prevents conflicts with straight-going vehicles; failing to comply results in test failure. In actual driving, similar regulations apply to ensure smooth traffic flow. When I was learning to drive, I always remembered to slow down and observe the surroundings before making a turn.
