Which is more fuel-efficient, the Eco mode or Normal mode in Haval H6?

3 Answers
OSebastian
07/29/25 1:50pm
Haval H6 Eco mode is more fuel-efficient. Below is an introduction to the Haval H6: 1. Powertrain: Equipped with 1.5T and 2.0T engines. The 1.5T engine delivers a maximum power of 124kW and peak torque of 285Nm; the 2.0T engine offers a maximum power of 145kW and peak torque of 355Nm. 2. Configuration: The 1.5T engine features CVVL technology. CVVL technology primarily enables adjustment of valve opening and closing timing, valve lift, and duration, ensuring sufficient air intake under various engine operating conditions, thereby improving engine efficiency.
Was this review help?
8
4
Share
MariaDella
08/13/25 5:12am
I've been driving the Haval H6 for several years, and the most frequently used mode is the Eco mode because it's significantly more fuel-efficient than the Standard mode. When commuting in the city, I switch to Eco mode, where the throttle response feels less aggressive, and the engine RPM stays lower, noticeably reducing sudden acceleration and braking frequency. As a result, I save dozens of dollars on fuel every month. In contrast, although the Standard mode feels more powerful and accelerates quicker, the fuel consumption is noticeably higher—I've tested it on the same route, and the fuel consumption per 100 kilometers can be 1-2 liters more. Additionally, activating Eco mode in heavy traffic is particularly effective, as it optimizes the transmission shift timing to avoid unnecessary power output. Just a reminder: if you prefer driving excitement or when climbing hills, the Standard mode might be more suitable, but for fuel savings, Eco mode is unbeatable. I recommend new owners start with Eco mode to gradually adapt to the driving experience.
Was this review help?
11
3
Share
Expand All
DelGage
10/10/25 5:33am
As a car owner with some interest in automotive technology, I must say the Haval H6's Eco mode completely outperforms the standard mode in fuel efficiency. This is primarily because the control unit restricts fuel injection, allowing the engine to run more smoothly and avoid sudden high-load operation, thereby reducing fuel consumption. I conducted a comparison with my own car: during highway cruising, Eco mode consumes about 7.5 liters per 100 kilometers, while the standard mode increases to over 8.5 liters. If you understand some vehicle principles, Eco mode acts like a fuel-saving assistant—it delays gear shifts and optimizes torque output, whereas the standard mode consumes more fuel for quicker response. Additionally, don't overlook the impact of driving habits—when using Eco mode, try to press the accelerator smoothly and maintain proper tire pressure, which can save a significant amount on fuel costs overall. Although acceleration feels slightly slower in Eco mode, the long-term savings of nearly a thousand yuan per year in fuel expenses make it worth trying.
Was this review help?
14
3
Share
Expand All
More Forum Discussions

How to Remove the Crankshaft Pulley on a Mondeo?

Here are the steps to remove the crankshaft pulley on a Ford Mondeo: 1. First, use a Phillips screwdriver and special tools to remove the air filter; use a Phillips screwdriver to remove the front grille; 2. Loosen the bolts on the alternator bracket with tools and release the alternator, then remove the alternator belt; 3. Loosen the bolts on the A/C compressor bracket with tools and remove the compressor belt; 4. Use a flathead screwdriver to lock the flywheel in the small hole at the bottom of the transmission; simultaneously use tools to loosen the crankshaft pulley bolt and remove it. 5. At this point, the pulley should come off easily.
14
3
Share

The Simplest Method to Find 30 Centimeters

The simplest method is to divide the front of the car into three equal parts. When the right one-third of the front aligns with the sideline, the distance between the car body and the sideline is exactly 30cm. During the operation, continuously observe from the rearview mirror. When the reference point coincides with the sideline, immediately press the clutch and brake to stop. The skills for pulling over are as follows: 1. Turn on the light: When hearing the voice prompt "Please pull over ahead," first turn on the right turn signal. 2. Position: Pay attention to observe the right front and find a suitable parking spot. 3. Slow down: It is recommended to slow down to below 10km/h, shift to first gear, and the slower the speed, the more beneficial it is for the next operation.
4
5
Share

Differences Between Ferrari 488 and 458?

Ferrari 488 and 458 differ in the following aspects: 1. The Ferrari 488 is equipped with a 3.9T turbocharged V8 engine, delivering a maximum output of 669 horsepower and a peak torque of 760 Nm; the Ferrari 458 features a 4.5L naturally aspirated V8 engine, producing a maximum output of 570 horsepower and a peak torque of 540 Nm. 2. The Ferrari 488 accelerates from 0 to 100 km/h in 3 seconds; the Ferrari 458 achieves the same in 3.4 seconds. 3. The Ferrari 488 measures 4568/1952/1213 mm in length, width, and height; the Ferrari 458 measures 4527/1937/1213 mm.
7
0
Share

Should Brake Rotors Be Resurfaced or Replaced?

Severely worn brake rotors require replacement with new ones. Below are detailed instructions for brake rotor replacement: 1. Replace brake rotors after two brake pad changes: Replacing brake rotors doesn't necessarily mean replacing brake pads simultaneously. If the brake pads still have sufficient thickness, they can be retained. Generally, brake rotors should be replaced after two brake pad changes. When the combined groove depth on both sides of the rotor exceeds 3mm or the rotor edges become sharp, immediate replacement is necessary. 2. Depends on driving conditions and habits: Brake rotor replacement intervals are significantly influenced by driving environment and habits. Frequent braking in urban or mountainous areas accelerates wear, shortening replacement cycles. Conversely, highway driving with less frequent braking naturally extends service life.
5
4
Share

How to use the parking function in Tiguan L?

Tiguan L's automatic parking usage method is as follows: 1. Near the parking space, activate the automatic parking function. 2. Control the vehicle to move forward at a speed below 30km/h, keeping parallel to the roadside vehicles. 3. When a suitable parking position is detected, the onboard computer will prompt the driver to shift into R gear. 4. After shifting into R gear, the automatic parking assist system will control the vehicle to complete parking into the space. More information about Tiguan L: 1. Tiguan L is equipped with a 2.0T engine, with a maximum power of 137 kW and a peak torque of 320 Nm. 2. The 2019 Tiguan L series comes standard with keyless entry, one-button start, electronic parking brake, and other equipment.
3
4
Share

What is the speed rating of car tires?

Tire speed rating indicates the maximum speed at which a tire can carry a specified load under defined conditions. The representation method and specific classification of tire speed ratings are as follows: Tire speed rating representation method: It is represented by English letters, with different letters corresponding to different speed ratings. For example: a speed rating of W on a tire represents 270KM/h, V represents 240KM/h, H represents 210KM/h, and Y represents 300KM/h. Specific classification of tire speed ratings: Different speed ratings also mean differences in price. For tires of the same size and specification, those marked with W are certainly more expensive than those marked with V, because they have a higher load capacity than V-rated tires.
8
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.