Which is cheaper to learn in a driving school, manual or automatic transmission?

2 Answers
McAlejandro
07/28/25 5:31pm
In driving schools, manual transmission courses are generally cheaper than automatic transmission ones. Here is a brief introduction to manual transmission: 1. Transmission Device: Manual Transmission, also known as manual gearbox, is a type of transmission device and the most basic form of automotive transmission. 2. Function and Characteristics: Its primary function is to alter the gear ratio, also known as the gear ratio. Based on the principle of leverage, it uses the largest diameter gear in the low-speed range to amplify the engine's torque, assisting the vehicle in starting to move forward. With the engine running, the neutral gear interrupts power transmission, which is beneficial for engine startup, warm-up, idling, and facilitates gear shifting, coasting, or temporary stops.
Was this review help?
20
0
Share
KingstonAnn
08/11/25 11:43pm
I've been keeping an eye on driving school fees, and manual transmission courses are usually significantly cheaper than automatic ones. Manual cars are simpler with lower maintenance costs, and driving schools can use standard models for training, saving a lot of expenses. Manual courses are priced lower because these vehicles are more widely available, especially in the used car market where manual transmissions dominate at lower prices. Additionally, the shorter training period means students pick up skills faster and pass quicker, allowing driving schools to better control costs and naturally reduce tuition fees. From what I understand, manual transmission courses are typically 10% to 20% cheaper in most regions, with the exact amount ranging from a few hundred to over a thousand yuan depending on the location and driving school size. If you're on a tight budget, choosing manual transmission is more cost-effective while also helping you master fundamental driving skills—killing two birds with one stone.
Was this review help?
17
2
Share
Expand All
More Forum Discussions

What is the reason for the Scirocco's failure to start when prompted to shift into P/N gear?

The reason for the Scirocco's failure to start when prompted to shift into P/N gear is incorrect gear position. Automatic transmission models: When starting, the gear must be shifted to the P position; some models can also start the engine in the N position. Apart from a dead battery or starter motor failure, sometimes this situation occurs where the engine still doesn't start even when the gear is in the P position. The main reason for this is a problem with the gear sensing circuit at the bottom of the gear lever. You can try pulling the gear lever back and forth, which might restore normal operation. Precautions for starting the car: When starting, you should press the brake, but to protect the transmission, try not to ignite in the P position. It's best to shift directly from the P position to the N position and then ignite, as this can reduce the impact on the gears inside the transmission.
10
5
Share

What Causes the Trunk Rattle in Volkswagen Tayron?

Trunk rattling may be caused by improperly placed items in the trunk or the trunk door not being securely closed. Checking the Trunk: It is necessary to inspect the trunk for any loose or missing screws. Identifying the source of the rattle can help resolve the issue. It is recommended not to place heavy objects in the car trunk and to always ensure the trunk is properly closed before driving. Introduction to Tayron: Tayron is the second SUV launched by FAW-Volkswagen following the compact SUV T-ROC. Positioned as a premium midsize SUV, it targets young consumers. The TAYRON Tayron sets a new benchmark for the latest generation of German premium midsize SUVs in terms of styling design, driving dynamics, comfort, cutting-edge technology, spatial structure, and safety features.
6
4
Share

What are the reasons for a car always having high water temperature?

Car always having high water temperature reasons are: 1. Thermostat damage, coolant only circulates in a small cycle without dissipating heat through the radiator; 2. Cooling fan not working, temperature control switch not opening or water temperature sensor failure; 3. Water pump failure, impeller slipping or jamming causing the belt to break; 4. Insufficient cooling medium, lack of coolant or radiator leakage; 5. Incorrect ignition timing and high oil pressure, water temperature gauge reading differs from actual temperature; 6. Radiator blockage, external dirt clogging, internal water channel blockage affecting coolant circulation; 7. Cylinder erosion, leading to frequent radiator water shortage.
18
5
Share

What are the methods to determine when engine oil needs to be replaced?

Engine oil needs to be replaced when: 1. The vehicle's power decreases and acceleration becomes sluggish; 2. Upon opening the hood and pulling out the dipstick, a strong sour or foul odor is detected; 3. When examining oil droplets on the dipstick under strong light, check for any impurities mixed in; 4. Take a small amount of used oil between your fingers and rub it repeatedly—if it feels less viscous, contains granular impurities, or even feels gritty, it's time for a change. The method for replacing engine oil is: 1. Run the engine until it reaches operating temperature; 2. Place an old oil container under the oil pan and loosen the drain plug; 3. Move the oil container under the oil filter and unscrew the filter element; 4. Apply some new oil to the gasket of the filter element; 5. Pour the new oil into the oil pan.
16
4
Share

Does the Audi A6L have tire pressure monitoring?

Audi A6L has tire pressure monitoring. Tire Pressure Monitoring System: It is a system that can automatically monitor various conditions of the tires in real-time, providing effective safety protection for driving. If the Audi A6L is equipped with a tire pressure monitoring system, it can not only alert the Audi A6L owner to pay attention to driving safety when the tire has high pressure, low pressure, or high temperature but also help the Audi A6L owner save fuel and money. Audi A6L: It is a car series developed by FAW-Volkswagen Audi on the basis of the new A6 in Germany and is the successor to the A6. In June 2012, the new generation Audi A6L was launched, equipped with 35TFSI power, and its appearance seems to resemble the new version of the A4L a bit.
14
3
Share

How to Remove a Static Cling Sticker?

Static cling stickers can be peeled off directly by hand without leaving any traces. If it's difficult to peel off, you can use your fingernail to push the edge of the film horizontally. The film will then lift due to the pressure, allowing you to pull it off easily. Here are the steps for using a car static cling sticker: 1. Peel off the separation paper from the front of the sticker. 2. Attach the adhesive side of the sticker to the car static cling sticker. 3. Remove the protective paper from the static cling sticker. 4. Place the sticker with the static cling on the correct position of the windshield. Here are some precautions when applying a static cling sticker: 1. During application: Be careful when attaching the sticker to avoid getting it dirty, and ensure there are no air bubbles, as this can affect the overall adhesion. 2. Before application: Before sticking it to the glass, clean the glass with a soft, dry or damp cloth to remove any impurities. For stubborn stains, use a neutral detergent to assist in cleaning.
11
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.