Which Gear is Reverse in an Automatic Transmission?

What does rail pressure positive deviation exceeding the limit mean?

Rail pressure positive deviation exceeding the limit means one of the most common fault nominal terms in the electronically controlled high-pressure common rail system. In addition, there are rail pressure negative deviation, rail pressure too low, and rail pressure too high. Below is a detailed introduction to rail pressure positive deviation exceeding the limit: The deviation of rail pressure equals the set rail pressure minus the actual rail pressure. If the resulting value is positive, it is a positive deviation; if negative, it is a negative deviation. A positive deviation means the actual rail pressure is low, while a negative deviation means the actual rail pressure is high. For rail pressure positive deviation exceeding the limit, factors such as fuel pump pressure, whether the nozzle is leaking or blocked, and rail pressure sensor failure should be considered. It is recommended that the owner promptly go to a repair station for inspection and take corresponding solutions to avoid affecting vehicle use.

11

1

Share

What is the difference between displacement with T and L?

T stands for Turbo, which refers to an engine equipped with a turbocharging device. L is the unit of volume, representing the displacement of the car engine, corresponding to a naturally aspirated engine. The following are the differences between displacement with T and L: 1. Working principle: The difference between these two engines lies in their working principles. Cars with the same displacement but with T have more power. If you prefer more powerful cars, you can choose those with T displacement, while L is generally sufficient for household use. 2. Fuel consumption: Since T-displacement engines require turbocharging, they need more fuel for the process. Therefore, cars with T displacement consume more fuel than those with L displacement, which is also a point to consider. 3. Failure rate: Due to the turbocharging in T-displacement cars, the wear and tear on the engine becomes more severe, leading to a higher failure rate compared to L-displacement cars.

15

0

Share

What is the recommended speed for the Civic during the break-in period?

The Civic break-in period covers 2000 to 3000 kilometers. The break-in period refers to the initial driving phase after a new car leaves the factory, during which the engine components gradually wear in smoothly. The first maintenance cycle for the car is around 5000 kilometers. The Civic is a compact 5-door, 5-seat hatchback with body dimensions of 4517mm in length, 1799mm in width, 1434mm in height, and a wheelbase of 2700mm. It is equipped with a 1.5T turbocharged engine and a CVT continuously variable transmission, delivering a maximum power of 130 kilowatts and a maximum torque of 220 Newton-meters. The front suspension features a MacPherson independent suspension, while the rear suspension uses a multi-link independent suspension.

8

4

Share

Which light is the hazard warning light?

The hazard warning light, also known as the emergency flasher or warning light, is the same type of light. There is a red triangle button on the vehicle's dashboard, pressing it will activate the hazard lights. More information about hazard warning lights is as follows: Hazard lights can typically be used in the following situations: (1) When pulling over due to a malfunction, turn on the hazard lights to warn approaching vehicles from behind. (2) They can be activated when the vehicle is being towed. (3) If a car breaks down on the highway, turning on the hazard lights alerts passing vehicles to slow down and be cautious. (4) They can also be used by convoys to make other vehicles aware while making it easier for their own vehicles to identify each other.

9

4

Share

Should the handbrake be released before or after shifting gears in a manual transmission?

In a manual transmission, the handbrake should be released after shifting gears. The correct starting procedure for a manual transmission car is: 1. Fully depress the clutch pedal with your left foot; 2. Shift the gear lever into 1st gear; 3. Turn on the left turn signal and sound the horn to alert vehicles and pedestrians in front and behind; 4. Release the handbrake and gently lift the clutch with your left foot; 5. Lightly press the accelerator with the ball of your right foot. The gears in a manual transmission car are: 1. 1st gear is the starting gear: used for vehicle starting; 2. 2nd gear is the passing gear: used for navigating complex road surfaces and handling complex situations; 3. 3rd gear is the transition gear: used for low-speed driving in urban roads; 4. 4th gear is the driving gear: used for prolonged high-speed driving; 5. 5th gear is the high-speed gear: used for long-distance highway driving.

11

1

Share

Is gasoline additive useful?

Using gasoline additive is useful. The functions of gasoline additive are: 1. Remove carbon deposits and clean the fuel system; 2. Enhance power performance; 3. Improve atomization and increase thermal efficiency; 4. Prevent corrosion, rust, and lubricate to protect the engine; 5. Reduce noise, decrease wear, and extend engine life; 6. Eliminate black smoke and reduce emissions. The method of adding gasoline additive is: 1. Before adding gasoline additive, confirm the gasoline content in the tank, and add it when gasoline needs to be added; 2. Park the car next to the fuel dispenser and open the gasoline cap; 3. Open the cap of the gasoline additive bottle and pour it into the gasoline tank; 4. Fill up the tank to disperse the additive with the impact of gasoline and mix it with gasoline.

13

4

Share

Which Gear is Reverse in an Automatic Transmission?

What does rail pressure positive deviation exceeding the limit mean?

What is the difference between displacement with T and L?

What is the recommended speed for the Civic during the break-in period?

Which light is the hazard warning light?

Should the handbrake be released before or after shifting gears in a manual transmission?

Is gasoline additive useful?

What is the reason for fully depressing the clutch when shifting gears in the Haval H6?

Can an Automatic Transmission Car Move When the Brake is Released?

Is It Normal for the Car to Idle at 1500 RPM When Starting in Summer?

Which gear to use for long downhill slopes?