Which fuse is for the cigarette lighter in the Livia car?

2 Answers
LaMaverick
07/28/25 6:01pm
The fuse for the cigarette lighter in the Livia car is located in the fuse box on the left side of the instrument panel. Open the fuse box cover, and you will see only three blue 15A fuses, with the one on the far right being the cigarette lighter fuse. If the cigarette lighter fuse frequently blows, you should take the car to a 4S shop or repair shop to check for any electrical damage. Remember not to replace it with a fuse larger than 15A to avoid burning out the wiring. In terms of power, the Livia is equipped with an HR16DE all-aluminum DOHC engine, which allows the Livia to reach a maximum power of 77kW at 5200 rpm and a maximum torque of 150Nm at 4400 rpm, with a top speed of 180 km/h. The engine is paired with a 4-speed automatic transmission or a 5-speed manual transmission.
Was this review help?
2
1
Share
VonBrianna
08/11/25 11:54pm
Last time when I was driving my Livina on a road trip, the cigarette lighter suddenly lost power, and I specifically looked into this issue. The cigarette lighter fuse is generally located in the fuse box under the lower left side of the steering wheel, and the specific number depends on your model year. For my 2015 Livina, it's the 18th position, a 15-amp blue mini fuse. I recommend opening that plastic cover first—there's a complete fuse layout diagram on the back of the cover. If you're replacing it yourself, be sure to use needle-nose pliers; don't pull it out directly by hand, as it could damage other circuits. Remember to turn off the engine and disconnect the power before operating. If replacing the fuse doesn't work, you'll need to check the contact tabs on the cigarette lighter socket. I once encountered a situation where the spring tab was deformed, causing poor contact.
Was this review help?
16
5
Share
Expand All
More Forum Discussions

How to deal with air leakage from the tubeless tire valve?

Before installation, clean the debris at the valve installation hole position on the steel rim and polish it smooth. Cut a section from the old inner tube with the valve, and then cut out a circle with a radius of 2 cm around the valve. Place one circle on the valve and install it on the steel rim, then fit the other rubber ring over the valve outside the steel rim.
13
3
Share

How to Remove Poor DIY Paint Touch-Ups?

You can use a clean cloth dipped in alcohol to wipe it off. Use gasoline to remove it, and remember to wipe it clean afterwards, then rinse with water several times. Other methods for repairing small dents or scratches on cars include toothpaste, touch-up paint pens, and polishing wax.
13
2
Share

How often should engine oil be changed?

Engine oil should be changed once a year or every 5,000 kilometers. The functions of engine oil are: 1. To cushion the impact load on pistons, piston rings, connecting rods, and crankshaft bearings; 2. To form a sealing ring between the piston rings and pistons, reducing gas leakage and preventing the entry of external contaminants. Precautions for changing engine oil include: 1. Perform the change when the engine is warm to ensure the old oil is drained as thoroughly as possible; 2. Add oil and ensure the amount is appropriate; 3. After adding oil, start the engine and check for any leaks. Run the engine for 3 minutes to confirm the oil level is at the normal mark.
9
5
Share

What to Do If Something Falls into the Window Gap?

If something falls into the gap between the window glass and the car door, you can find a suitable thin metal sheet and wrap it with a dry cloth. Wrap the metal sheet with a rag and gently insert it into the gap between the window glass and the car door. Use the rag-wrapped metal sheet to wipe back and forth between the window glass and the car door. Repeat the scrubbing, changing the cloth when it gets dirty, until the object is completely removed.
4
3
Share

How to Connect a Phone to Lexus ES200 via Bluetooth?

Start the car, then select the Bluetooth settings on the ES200 screen. Next, open the settings option on your phone in the car. After entering the settings interface, click on the Bluetooth option. Click to connect to the CAR Bluetooth signal and pair it with the ES200's onboard Bluetooth.
15
1
Share

How to Get Rid of Ants in the Car?

You can find a piece of paper, place milk candy under the sun to melt it, then put the melted milk candy on a newspaper and place both the newspaper and candy in the area of the car where ants are most active. Sprinkle some sugar in the center of a glue trap and place the trap in the corners of the car where ants are entering or exiting. Use a cloth to thoroughly wipe the interior of the car, spray insecticide, and then close all doors and windows.
8
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.