Which engine is used in the Roewe i5?

1 Answers
DelVictoria
07/29/25 11:10pm
Roewe i5 is equipped with two engines, one is a 1.5-liter naturally aspirated engine, and the other is a 1.5-liter turbocharged engine. The 1.5-liter naturally aspirated engine has a maximum horsepower of 120 hp, a maximum torque of 150 Nm, a maximum power speed of 6000 rpm, and a maximum torque speed of 4500 rpm. The 1.5-liter turbocharged engine has a maximum horsepower of 169 hp, a maximum torque of 250 Nm, a maximum power speed of 5500 rpm, and a maximum torque speed ranging from 1700 to 4300 rpm. The front suspension of the Roewe i5 uses a MacPherson independent suspension, while the rear suspension uses a torsion beam non-independent suspension.
Was this review help?
2
4
Share
More Forum Discussions

Which version of Xiali uses a Toyota engine?

Xiali's new model N5 is equipped with an older Toyota engine that has performance superior to the 8A. Engine usage precautions: After the engine operates at full load, it must idle for 3 to 5 minutes before shutting down. This allows sufficient cooling for the pistons, cylinders, bearings, and turbocharger components. Fuel must be clean: High impurity content in fuel can accelerate the wear of the electric fuel pump and reduce its service life. Additionally, unclean fuel can lead to clogging of the fuel filter and fuel injectors, affecting fuel supply pressure and normal injection volume, thereby reducing the engine's performance.
11
5
Share

What does the battery specification 55d23l mean?

Battery 55d23l is a specification for car batteries. The number 55 represents the ampere-hour rating of the battery, 'd' indicates the battery size, specifically a width of 17.3 cm and a height of 20.2 cm. The number 23 refers to the length of the front side of the battery, which is 23 cm, and 'l' means the positive terminal is located on the left side. Car batteries are consumable parts that typically last 3 to 4 years under normal conditions. As the number of charge and discharge cycles increases, the battery's performance will decline, which is why regular replacement is necessary. If the battery's charging capacity is poor, it can lead to difficulties in starting the engine or even complete failure to start.
13
2
Share

What Causes Difficulty in Starting a Cold Engine?

Reasons for difficulty in starting a cold engine: 1. Low engine temperature; 2. Excessive carbon buildup in the throttle and idle valve: Too much carbon deposit can easily clog the idle air passage, leading to poor air intake. Carbon deposits primarily form due to incomplete combustion during engine operation, combined with gummy substances produced when impurities in fuel and engine oil burn, resulting in carbon buildup. Carbon deposits can cause various issues such as engine shaking when cold, idle engine vibration, reduced power, increased fuel consumption, difficulty in starting, unstable idle, poor acceleration, excessive exhaust emissions, and higher fuel consumption. The solution can be alleviated by cleaning the carbon deposits.
4
1
Share

How Often Should the Timing Chain of the Elantra Be Replaced?

The timing chain of the Elantra generally needs to be replaced every 150,000 to 200,000 kilometers. During replacement, ensure to use reliable lubricating oil for proper lubrication. Introduction to Timing Chains: Compared to timing belts, timing chains have a longer service life and lower failure rates. However, timing chains rely on lubricating oil for lubrication. If the engine oil is not changed for an extended period or is of poor quality, it can accelerate wear and reduce the lifespan of the timing chain. Precautions for Timing Chains: Pay attention to the meshing of the sprocket teeth and the chain. Before installing the chain, conduct a meshing test. If the chain rollers do not seat properly or are too loose during meshing, the chain should not be installed. Check the pitch of the chain and sprocket to identify the cause. Additionally, ensure coplanarity and check for any axial movement. Any misalignment or tilting is unacceptable, as it can lead to premature damage to the transmission mechanism and the chain. The retaining clip on the chain link pin must be securely seated in the groove of the pin to ensure safe operation. For open-type retaining clips, the installation direction must be such that the clip's opening faces opposite to the chain's movement direction. This prevents the clip from dislodging due to impact during operation.
12
5
Share

How many cylinders does the Lingpai engine have?

The Lingpai engine comes in both three-cylinder and four-cylinder configurations. The current model lineup exclusively uses a 1.8L four-cylinder naturally aspirated engine, initially paired with a 5AT transmission and later upgraded to a CVT. The all-new Lingpai is equipped with a 1.0T three-cylinder engine (coded P10A3) mated to a CVT transmission. The Lingpai's body dimensions measure 4756mm in length, 1804mm in width, and 1509mm in height, with a wheelbase of 2730mm. It features front-wheel drive, MacPherson strut front suspension, torsion beam rear suspension, and a unibody construction.
11
2
Share

Where is the position of the MG6 cylinder wires?

MG6 cylinder wires are connected to the engine block of the car. Automotive cylinder wires: Cylinder wires are an essential part of the traditional ignition system, serving as the medium through which the ignition coil transmits energy to the spark plugs. Cylinder wires, also known as ignition wires, distribute the ignition sequence and deliver the high-voltage spark from the distributor to the spark plugs, enabling ignition and combustion in the cylinders to drive the engine. Structure of cylinder wires: Cylinder wires generally consist of four parts. First is the conductive material, second is the insulating rubber, third is the ignition coil connector, and fourth is the spark plug connector. (Some cylinder wires are additionally wrapped with a layer of heat-resistant material to prevent damage from heat.) The number of cylinder wires corresponds to the number of engine cylinders, commonly four, six, or eight cylinders. Three-cylinder and twelve-cylinder configurations are rare, and some special vehicles may have varying numbers of cylinders.
2
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.