Which direction is the Honda XRV air filter installed?

What is the standard width of a slow lane?

The standard width for a slow lane is 2×7.5 meters for a four-lane bidirectional road; 2×11.25 meters for a six-lane bidirectional road; and 2×15 meters for an eight-lane bidirectional road. The national standard for the width of each motor vehicle lane on highways is as follows: For multi-lane highways above Level III, the width of each motor vehicle lane is 3.5-3.75 meters. There is no uniform standard for the central divider, which is adapted to local conditions. A simple cement central divider is one meter wide, while for a central green divider, there is no uniform standard. Some 'image project' roads can have dividers as wide as several dozen meters. Classification of urban roads: Urban roads are categorized into three levels: expressways, arterial roads, and secondary roads, with the following red line width controls: expressways should be no less than 40 meters, arterial roads 30-40 meters, secondary roads 20-24 meters, and branch roads 14-18 meters.

20

0

Share

Can a motorcycle run with too much engine oil?

Motorcycle cannot run with too much engine oil. Engine burning oil: The main reason why excessive oil causes the engine to burn oil is that the excess lubricant enters the cylinder piston rings and cannot be completely scraped back into the crankcase, thus entering the combustion chamber and burning along with the combustible mixture. Precautions when adding oil: Too much oil leads to weak driving performance. The main reason for this phenomenon is that excessive lubricant increases the operating resistance of the engine, thereby affecting the engine's power. Therefore, it is best to add the appropriate amount of lubricant when changing the oil, otherwise it will not only be a waste but also cause various problems with the engine.

9

2

Share

What Type of Insurance Does Motorcycle Insurance Belong To?

Motorcycle insurance is similar to regular auto insurance, requiring the purchase of compulsory traffic insurance (CTL) and other commercial insurance policies. Among these, CTL is mandatory, while commercial insurance typically includes motorcycle damage insurance and third-party liability insurance, among others. Motorcycle Damage Insurance: This refers to coverage for the insured motorcycle against losses caused by natural disasters (excluding earthquakes) or accidents within the scope of the insurance policy. The insurer compensates according to the terms of the insurance contract. If you value your motorcycle, this insurance is recommended. Third-Party Liability Insurance: In the past, most local governments classified third-party liability insurance as a compulsory insurance type. Without this insurance, motor vehicles could not be registered or undergo annual inspections. After the introduction of Compulsory Traffic Liability Insurance (CTL), third-party liability insurance became non-mandatory.

5

1

Share

How many kilometers should rear axle gear oil be changed?

Rear axle gear oil should be changed every 50,000 kilometers, with regular maintenance also required. Taking car maintenance as an example, here is a detailed introduction about vehicle maintenance: Overview: Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting or replacing certain parts of automobile-related components, also known as automobile servicing. Currently, car maintenance mainly includes the maintenance scope of engine systems (engines), transmission systems, air conditioning systems, cooling systems, fuel systems, power steering systems, etc. Purpose: The purpose of car maintenance is to keep the vehicle clean and in normal technical condition, eliminate hidden dangers, prevent failures, slow down the deterioration process, and extend the service life.

5

3

Share

Why is the China VI vehicle speed limited to 20 km/h?

Vehicle torque and speed limitations are not implemented by manufacturers by choice, but are regulatory requirements for China VI models to ensure compliance with emission standards. Here are the specific details: Torque Limitation: Torque limitation, also known as primary driving performance restriction, is activated when issues such as exceeding OBD emission limits persist for more than 10-36 hours without resolution. This reduces the vehicle's torque output by 25%, limiting its power. Speed Limitation: Speed limitation, or severe driving performance restriction, is enforced when emission issues exceed OBD limits and remain unresolved for more than 20-100 hours. The vehicle's speed is then restricted to within 20 km/h.

5

4

Share

Is it dangerous for cold tire pressure to increase from 2.5 to 2.9 on the highway?

It is normal for cold tire pressure to increase from 2.5 to 2.9 when driving on the highway, as the heat generated inside the tires during driving causes the tire pressure to rise. Typically, the pressure will be about 0.3 bar higher than the cold tire pressure. A tire pressure of 2.9 will not directly cause a blowout, as tires are not extremely fragile and can withstand a maximum pressure of 3.5-2.4 bar. Generally, for front-wheel-drive vehicles, it is recommended to have higher front tire pressure and lower rear tire pressure, meaning the front tire pressure should be 0.1~0.2 bar higher than the rear tire pressure. This is because the front-heavy design of the engine makes the vehicle heavier in the front. If the vehicle is fully loaded, the tire pressure can be appropriately increased, especially for the rear tires. The tire pressure label can usually be found on the edge of the driver's door frame, the fuel tank cap, or in the user manual. The manufacturer's recommended tire pressure values, unless otherwise specified, are suitable for both winter and summer and do not require special adjustments. Excessive tire pressure can cause the following issues: When driving on bumpy roads, high tire pressure will cause noticeable vibrations in the vehicle body. Excessive tire pressure concentrates the vehicle's weight on the center of the tire tread, leading to rapid wear in the central part of the tire and affecting its lifespan. Additionally, excessive tire pressure reduces the tire's contact area with the road, which can increase braking distance on low-traction surfaces during emergency braking, raising the risk of rear-end collisions.

20

2

Share

Which direction is the Honda XRV air filter installed?

What is the standard width of a slow lane?

Can a motorcycle run with too much engine oil?

What Type of Insurance Does Motorcycle Insurance Belong To?

How many kilometers should rear axle gear oil be changed?

Why is the China VI vehicle speed limited to 20 km/h?

Is it dangerous for cold tire pressure to increase from 2.5 to 2.9 on the highway?

Can fog lights and hazard lights be turned on simultaneously?

What are the essential items that come with a new car?

What is the speed limit for vehicles at construction sites?

How to Use Turn Signals When Driving Around a Roundabout?