Which car is Porshe?

Should the Lynk & Co 02 Use 92 or 95 Octane Gasoline?

According to the official vehicle user manual recommendation, the Lynk & Co 02 should use 95 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle user manual, you can also find it on the fuel tank cap, which will be clearly marked. Typically, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of some new technologies, the gasoline grade cannot be solely determined by the compression ratio. A high compression ratio can also be adjusted to use lower octane gasoline because, apart from the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline grade, the higher the octane number, and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Lynk & Co 02 occasionally uses the wrong gasoline grade, simply switch back to the correct grade after consumption. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage, but the increase in octane number will alter the fuel's ignition point, leading to delayed combustion in the engine. This means both the engine's power output and thermal efficiency will decrease, resulting in a noticeable decline in performance. For vehicles recommended to use higher octane gasoline, using lower octane gasoline can cause engine knocking. Due to the significantly lower octane number, the gasoline's ignition point decreases, causing premature ignition during the compression stroke. If detonation occurs before the spark plug fires during the compression stroke, resistance will arise in the upward stroke. This resistance makes the engine run very unstably. If the knocking is imperceptible, it only increases noise without significant damage to the engine. However, noticeable knocking indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.

14

4

Share

What engine does the Eado use?

The Eado is equipped with two types of engines: a 1.6-liter naturally aspirated engine and a 1.4-liter turbocharged engine. The 1.4-liter turbocharged engine delivers 158 horsepower and a maximum torque of 260 Nm, while the 1.6-liter naturally aspirated engine produces 128 horsepower and a maximum torque of 161 Nm. In terms of exterior design, the Eado's front fascia and grille feature abundant lines that exude a fashionable vibe. The elongated headlights, with their slightly upward-tilted lines, give the car a very dynamic appearance. Regarding dimensions, the Eado measures 4620mm in length, 1820mm in width, and 1490mm in height, with a wheelbase of 2660mm.

5

0

Share

Do Pure Electric Vehicles Have Engines?

Pure electric vehicles do not have engines, but they do have electric motors. The working principle of pure electric vehicles is as follows: electric vehicles complete their operation by driving the car through the battery current, power regulator, electric motor, and power transmission system. The electric motor is a device that converts electrical energy provided by the power source into mechanical energy. The power source supplies electrical energy to the driving mechanism—the electric motor—of the electric vehicle. The electric motor then converts the electrical energy from the power source into mechanical energy, which drives the wheels and working devices either through a transmission system or directly. The most widely used power source in electric vehicles is the lead-acid battery. However, with advancements in electric vehicle technology, lead-acid batteries are gradually being replaced by other types of batteries due to their lower energy density, slower charging speed, and shorter lifespan.

4

Share

What does it mean when the engine warning light comes on?

Reasons for the engine warning light to illuminate: 1. Poor combustion of the engine's air-fuel mixture caused by faulty spark plugs, ignition coils, fuel pump issues, or clogged fuel lines; 2. Lack of regular maintenance; 3. Oxygen sensor problems; 4. Engine oil issues; 5. Loose fuel tank cap; 6. Dirty air filter; 7. Faulty anti-theft system wiring. Solutions when the engine warning light comes on: 1. A yellow light indicates an engine fault that does not affect normal operation but requires inspection and repair; 2. A red light signifies a serious engine fault that normally requires immediate repair, though emergency driving may be possible in special road conditions while closely monitoring the engine's performance.

10

5

Share

Where is the cabin air filter located in the Haima S5?

The cabin air filter of the Haima S5 is located at the bottom of the glove compartment on the passenger side. You can access it by removing the rectangular cover plate. Functions of the car cabin air filter: 1. Minimize the entry of unfiltered air into the cabin; 2. Adsorb harmful substances and moisture in the air; 3. Filter out solid impurities such as dust, pollen, and abrasive particles in the air; 4. Effectively block pollen to ensure that drivers and passengers are not affected by allergies, thereby maintaining driving safety. In terms of exterior design, the Haima S5 features a trapezoidal chrome-plated central air intake grille with a strong three-dimensional effect, complemented by gull-wing-style chrome-plated headlights and high-brightness LED daytime running lights, highlighting its free-spirited external temperament. Regarding body dimensions, the Haima S5 measures 4418 mm in length, 1823 mm in width, and 1630 mm in height, with a wheelbase of 2630 mm.

9

2

Share

Should the License Plate Be Removed When Selling a Car?

Selling a car requires the license plate to be removed, as the plate cannot be transferred with the vehicle. After selling the car, the new owner must select a new license plate number. However, if the original owner meets certain conditions, they can apply to retain the old license plate. Retaining the original plate allows the owner to skip the lottery process for a new plate when purchasing another vehicle. Instead, they simply need to apply for an update at the vehicle management office within six months of obtaining the renewal quota. Requirements for retaining the original license plate: 1. The application must be submitted within six months after the transfer or cancellation of registration; 2. The original owner must have owned the vehicle for at least three years; 3. All traffic violations and accidents related to the original vehicle must be resolved.

1

0

Share

Which car is Porshe?

Should the Lynk & Co 02 Use 92 or 95 Octane Gasoline?

What engine does the Eado use?

Do Pure Electric Vehicles Have Engines?

What does it mean when the engine warning light comes on?

Where is the cabin air filter located in the Haima S5?

Should the License Plate Be Removed When Selling a Car?

What to Do If You Don't Have Enough Driver's License Points?

What brand is haval?

How to Adjust the Time on Lavida?

Where is the activated charcoal canister located in a car?