Which car brand has a diamond-shaped logo?

1 Answers
KatherineFitz
07/30/25 7:49am
The diamond-shaped logo belongs to Renault, a French automobile manufacturer that produces vehicles including racing cars, compact cars, mid-size cars, SUVs, and large cars. Taking the Renault City K-ZE as an example: it is a compact SUV with an electric motor producing a maximum horsepower of 45, a maximum power of 33 kilowatts, and a maximum torque of 125 Newton-meters. The Renault City K-ZE has dimensions of 3735mm in length, 1579mm in width, and 1484mm in height, with a wheelbase of 2423mm, and is equipped with a fixed gear ratio transmission. The car's trunk capacity is 300L, featuring MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear, with tire specifications of 165/70R14.
Was this review help?
17
4
Share
More Forum Discussions

Which side is the accelerator and which side is the brake in a car?

In an automatic transmission car, both the brake and accelerator are located at the foot area. The accelerator is on the far right, and the brake is to the left of the accelerator, both controlled by the right foot. Below is additional information about automatic transmission cars: 1. Automatic transmission cars use a hydraulic transmission device to replace the mechanical clutch in manual transmission cars, hence there is no clutch pedal. 2. When the engine speed is low, the torque transmitted by the fluid is limited and insufficient to propel the car forward. 3. Place the gear lever in the drive position, release the brake pedal, and as you accelerate and the engine speed increases, the transmitted torque grows, pushing the car forward. 4. The cost of an automatic transmission is higher than that of a manual transmission in the same model. The advantage of a manual transmission lies in its ease of driving.
3
0
Share

What is the Truth About Wasabi Green Fuel Additive?

Wasabi Green Fuel Additive is considered a legitimate brand of fuel additive. Some car enthusiasts have conducted specific tests and found that Wasabi Green Fuel Additive has a certain effect on cleaning carbon deposits in vehicles, but the actual results are not as impressive as claimed by the merchants. Fuel Additives: 1. Classification: Fuel additives can be categorized by target use into gasoline additives and diesel additives, and by function into three main types: cleaning, maintenance, and performance-enhancing. 2. Reasons for Use: Traditional solutions involve disassembling the engine for cleaning, which is not only time-consuming but also risky, especially with advanced turbocharging and GDI technologies making engines more precise. Disassembly and cleaning may lead to numerous subsequent issues. Therefore, carbon removers for fuel systems (fuel additives) that allow cleaning without disassembly have gradually become a necessary method for removing carbon deposits.
14
3
Share

How to Adjust the Needle Valve of a Carburetor?

Carburetor adjustment involves tuning the idle screw or the fuel adjustment screw. A carburetor is a mechanical device that mixes a certain proportion of gasoline with air under the vacuum created by the engine's operation. The steps for cleaning a carburetor are as follows: 1. Remove the air filter and start the engine, allowing it to reach maximum RPM. 2. Quickly cover the carburetor's air intake with a gloved hand or a clean cloth. You should feel a strong suction, and the engine RPM will gradually decrease. When the RPM is sufficiently low, remove your hand to allow the engine to return to normal operation. 3. Repeat the above steps several times until the engine operates normally. Using carburetor cleaner available in the vehicle can help reduce the number of repetitions needed.
18
2
Share

Are traffic violation points deducted from the driver's license immediately?

Traffic violation points are not deducted from the driver's license immediately. Here is extended information about violation points: 1. On-site violations: For traffic violations detected on-site by traffic police, the police penalize the driver. If the violation warrants point deduction according to regulations, the points will be recorded on the driver's license. 2. Camera-recorded violations: For traffic violations recorded by surveillance equipment, the vehicle information is recorded. Until the vehicle owner or actual driver goes to the traffic management department of the public security authority to handle the violation, the points will not be recorded on the driver's license. Within ten days from the date the traffic surveillance equipment collects the violation records, the traffic management department at the location of the violation should review the records. After verification, the information will be entered into the traffic violation management system as evidence of the violation.
10
5
Share

Where is the fuel tank cap switch located in a Buick?

Buick's fuel tank cap switch is located in the main driver's compartment. There are many models of Buick vehicles, and not all models have the same method for opening the fuel tank cap. For most models, when the vehicle is unlocked, pressing the fuel tank cap will open it, and then there is an internal knob that can be twisted to open. Buick fuel tank caps are divided into an inner cap and an outer cap, as follows: 1. The outer cap is generally controlled by an electric or cable-operated mechanism to open the fuel door. The electric button or cable-operated lever is usually located on either side of the driver's seat, marked with a fuel pump icon. Simply press or pull it, and the fuel door will open automatically. 2. The inner cap can only be seen after opening the outer cap. The inner cap is made of plastic material; turning it to the right tightens it, and turning it to the left opens it.
9
0
Share

What Are the Consequences of a Damaged Door Waterproof Membrane?

After the door waterproof membrane is damaged, the door cannot remain sealed. Below is an introduction to waterproof membranes: 1. Introduction: A waterproof membrane is a top layer with oil and water resistance properties, thin and does not alter the optical performance of the anti-reflective coating. 2. Function: After multiple layers of anti-reflective coating are applied to the lens surface, the lens becomes particularly prone to stains, which can damage the anti-reflective effect of the coating. Under a microscope, it can be observed that the anti-reflective coating has a porous structure, making it especially susceptible to oil infiltration. The solution is to apply an additional top layer with oil and water resistance properties over the anti-reflective coating, commonly referred to as the waterproof membrane. Moreover, this layer must be extremely thin to ensure it does not change the optical performance of the anti-reflective coating.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.