Which Auman LMH model is for heavy-duty loads?

What are the reasons for the Honda Avancier's reverse radar not making sound?

Introduction to the reasons why the Honda Avancier's reverse radar does not make sound: Check whether the reverse radar wiring at the rear bumper is properly connected; See if the reverse light turns on when shifting to reverse gear. If not, check the reverse light switch; Remove the right lining panel of the trunk and test the continuity of the wires to the radar; Open the fuse box and use a multimeter to check the continuity of the fuses related to the reverse radar; The reverse radar module or buzzer is damaged and needs to be replaced. Apart from malfunctions, the reverse radar will not respond in the following situations: Obstacles that are too low: Generally, obstacles that are 10~15cm below the center of the probe may be ignored by the probe. Moreover, the closer the obstacle is to the parking space, the lower this height value becomes, and the greater the danger. Obstacles that are too thin:

20

5

Share

How to Drive Over Speed Bumps?

Methods for driving over speed bumps: 1. Observe the road conditions ahead in advance, especially when the vehicle has entered a speed-limited section. Reduce speed and apply linear braking upon spotting a speed bump to slow down beforehand, maintaining a speed of approximately 10 to 20 km/h; 2. Having both left and right wheels contact the speed bump simultaneously can distribute the impact force evenly across both wheels, balancing the load on the suspension systems on both sides and minimizing damage to the greatest extent; 3. Release the brakes before the wheels are about to pass over the speed bump. This shifts the vehicle's center of gravity backward, relieving the load on the front shock absorbers and allowing them to be in optimal condition to absorb the impact of the speed bump.

7

5

Share

How to Identify the Quality of an Ignition Coil?

Identifying the quality of an ignition coil can be done through the following methods: 1. Feel the temperature of the ignition coil casing by hand; it should feel warm under normal conditions, but if it feels too hot to touch, it indicates an inter-turn short circuit fault in the ignition coil. 2. Use a multimeter to measure the resistance of the primary and secondary windings. If the resistance is infinite, it means there is an open circuit fault in the winding. If the resistance is too high or too low, it indicates poor contact or an inter-turn short circuit in the winding. 3. Use the substitution method with a comparative spark test. Compare the spark intensity of the ignition coil being tested with that of a known good ignition coil to see if they are the same. Faults in the ignition coil can lead to: 1. No secondary voltage being generated or the secondary voltage being too low to ignite. 2. Although a spark may occur, the reduced secondary voltage results in insufficient ignition energy, causing high-speed misfires, incomplete combustion, difficulty in starting the engine, unstable idle, reduced power, increased exhaust pollution, and higher fuel consumption.

6

0

Share

What Happens When Transmission Fluid Gets Dirty?

Dirty transmission fluid can cause various malfunctions, including filter blockage, stuck valves in the oil circuit plate, and clogged transmission oil pipes. Regardless of the specific cause, any of these issues may lead to a major transmission overhaul. It is recommended to replace the transmission fluid regularly to ensure the proper functioning of the transmission. Transmission fluid serves as a cleaning agent for the transmission system, maintaining its normal operation and extending the lifespan of the vehicle's transmission components. Depending on the transmission structure, transmission fluid can be categorized into manual transmission fluid and automatic transmission fluid (ATF). Automatic transmission fluid not only acts as a lubricant but also functions as hydraulic oil, serving different parts within the vehicle.

20

4

Share

How to Determine a Vehicle's Emission Standard (National Standard)

Methods to check a vehicle's emission standard: 1. Look at the windshield of the car, where the environmental compliance label is usually attached. The emission standard can be found on the back of this label; 2. Vehicle owners can bring the vehicle registration certificate to the local vehicle management office for inquiry, where the emission standard can also be checked; 3. Newer vehicles will have the emission standard marked on the vehicle license, allowing owners to identify the emission standard this way; 4. There are some professional websites online where you can check the vehicle's emission standard. Enter "motor vehicle environmental protection" in the search box, then click on the "Environmental Compliance Vehicle Query System," input the vehicle information, and the emission standard will be displayed.

19

3

Share

How to Reset the Vehicle Maintenance Reminder?

There are two methods to reset the vehicle maintenance reminder. The first is to visit a 4S shop and use their computer system to cancel it. The second method involves canceling it through the vehicle settings. The procedure for resetting the maintenance reminder varies among different car models, so it is recommended to visit a 4S shop for assistance. To ensure the normal operation of the vehicle, manufacturers have installed certain reminder indicators during production. Once the vehicle reaches a certain mileage, the owner should promptly replace the necessary parts. The purpose of the maintenance light is to remind the owner to perform maintenance as soon as possible. Therefore, the owner should visit a 4S shop for maintenance without delay. After the maintenance is completed, the 4S shop will use a fault diagnostic tool to reset the maintenance light to zero.

3

0

Share

Which Auman LMH model is for heavy-duty loads?

What are the reasons for the Honda Avancier's reverse radar not making sound?

How to Drive Over Speed Bumps?

How to Identify the Quality of an Ignition Coil?

What Happens When Transmission Fluid Gets Dirty?

How to Determine a Vehicle's Emission Standard (National Standard)

How to Reset the Vehicle Maintenance Reminder?

How to Remove the Original Car Floor Mat Clips?

What to Do When the Original Owner Tows Away a Repossessed Vehicle?

How to Use Reference Points and Steer for Right-Angle S-Turns

How to Choose Between T-Cross and Tacqua?