Where to Place the ETC on a Truck?

[DelKaylee]

For large vehicles such as trucks and buses, the installation position should be in the middle to lower part. The suitable installation height is no less than 1.2 meters and no more than 2.5 meters, with an installation angle between 30 to 90 degrees. If the vehicle has anti-explosion film or is later fitted with one, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the owner must provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is made by a non-owner, the agent must also provide their valid ID card. The photocopy of the vehicle registration certificate must include the page with the most recent annual inspection seal. A bank card for deducting highway toll fees is required, and the vehicle must be registered under an individual aged between 18 and 60. Here are some precautions for installing ETC: Do not obstruct the view; it is best to install it behind the rearview mirror: Many vehicle models have a steeply inclined windshield, which can reduce the driver's field of vision. If this is not considered during ETC installation, it may increase the driver's blind spots. Install it on the right side behind the rearview mirror to avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a solar panel on the back for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-tamper lever connected to a switch. After installation, the windshield will press the anti-tamper lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle in front, maintain a distance of more than 10 meters from the vehicle ahead to avoid automatic toll deduction for the wrong vehicle. The ETC lane recognizes vehicles at a speed of 20 km/h; driving too fast may result in failure to read the vehicle's device information and toll deduction failure. If using a debit card linked to ETC, insufficient balance will also cause toll deduction failure.