Where to Place ETC in the Car?

[CalvinLynn]

The ETC device is generally installed on the upper middle part of the front windshield for passenger vehicles, while for large vehicles like trucks and buses, it is installed on the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect microwave signal transmission, the ETC should be installed in the microwave window area. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the vehicle owner needs to provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is handled by a non-owner, the agent's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. Additionally, a bank card under the owner's name for deducting highway tolls is needed, and the owner must be between 18 to 60 years old. For company-owned vehicles, the required documents include: An introduction letter from the vehicle owner (with company seal); Photocopy of the organization code certificate or business license (with company seal); Original ID card of the agent; Original vehicle registration certificate; The vehicle that needs ETC installation. Here are some precautions for ETC installation: Do not obstruct the driver's view. It's best to install it behind the rearview mirror: Many car models have windshields with a steep angle, which can reduce the driver's field of vision. Installing the ETC without considering this may increase blind spots. Installing it on the right side behind the rearview mirror can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a built-in solar panel for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Do not remove the device once installed: The adhesive in the middle has an anti-tamper lever connected to a switch. Once installed, the windshield presses the lever in. If removed, the lever will pop out, triggering the switch and locking the electronic tag, rendering it unusable. In such cases, you will need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device.