Where to Park Your Car During Heavy Rain?

2 Answers
JosiahLynn
09/04/25 8:38am
During heavy rain, it is advisable to park your car in an open area on relatively higher ground. Below are the impacts of heavy rain on vehicles: 1. Damage to the car body: When rainwater mixes with dirt and grime, it forms contaminants that adhere to crevices. If not cleaned thoroughly, this can lead to rust on the car body. 2. Damage to the paintwork: Rainwater in urban areas generally has high acidity. The acidic components in rainwater can severely corrode the car's paint, causing irreparable damage. 3. Damage to the interior: As the vehicle ages, the sealing strips at the joints of the car body will gradually deteriorate. 4. Damage to the ignition system: On rainy days, when cold air outside meets the hot air in the engine compartment, condensation forms on the ignition system. If the moisture does not evaporate in time, it can affect the operation of the ignition system, leading to difficulty in starting the vehicle.
Was this review help?
16
3
Share
VonJuliet
09/17/25 2:40am
When a heavy storm hits, I immediately look for elevated parking spots, such as hilltops or the rooftop platform of a garage's second floor, avoiding low-lying areas like riverbanks or sunken parking lots to prevent water from submerging the car. As an experienced long-time driver, I know that urban flooding often occurs in areas with poor drainage systems, so when parking, it's essential to observe the terrain's elevation and preferably park in open shopping malls or protected parking lots. Strong winds can cause branches or billboards to fall and damage the car body, so I always avoid parking near large trees or utility poles. For regular car maintenance, I also check the tire tread for water drainage. After a heavy storm, it's crucial to inspect whether water has entered the undercarriage and address it promptly to prevent electrical circuit short circuits from escalating, as this is a matter of personal safety.
Was this review help?
17
5
Share
Expand All
More Forum Discussions

Where is the wiper relay in Lavida?

It may be in the control box under the hood. Car relays are generally similar, so you can try following the control line of the wiper to locate it. Introduction to wipers: Wipers are blade structures installed in front of the windshield, composed of a motor, reducer, four-bar linkage, wiper arm spindle, wiper blade assembly, etc. Their main function is to clear rain, snow, and dust from the windshield that obstruct the driver's view, thereby improving visibility and enhancing driving safety. Due to legal requirements, almost all cars worldwide are equipped with wipers. Regular cleaning of wipers: Use a dedicated cleaning solution to wipe and clean the wipers during each car wash. During maintenance, also pay attention to the condition of the wipers. Avoid pulling or tugging them too forcefully, as this can easily damage the wipers.
16
5
Share

Is the Haval H4 automatic transmission fuel-consuming?

Haval H4-1.5T automatic transmission has a MIIT comprehensive fuel consumption of 6.9L/100km, which is slightly higher compared to other vehicles. Maintain normal tire pressure levels: If the tire pressure is insufficient, rolling resistance will significantly increase. According to tests, if the tire pressure is 2psi (unit of pressure: pounds per square foot) below the specified value, fuel consumption will increase by 1%. Repair faults promptly: Abnormalities in the engine ignition system also have a significant impact on fuel consumption. Issues such as inaccurate ignition timing, leakage in high-voltage wires, and weak ignition caused by spark plug carbon deposits can all reduce engine combustion efficiency and increase fuel consumption.
18
2
Share

Where is the VIN located on the Compass?

JEEP Compass VIN is located under the hood of the JEEP Compass, inside the JEEP Compass engine compartment, on the nameplate directly above the JEEP Compass engine. Introduction to VIN: The VIN is the Vehicle Identification Number, an abbreviation for Vehicle-Identification-Number in English. Regulations regarding VIN: According to SAE standards: The VIN consists of 17 characters, hence it is commonly referred to as the 17-digit code. It contains information about the vehicle's manufacturer, year, model, body type and code, engine code, and assembly location, among others. Correctly interpreting the VIN is crucial for owners to accurately identify the vehicle model and for proper diagnosis and maintenance.
2
1
Share

How Many Times is the Pajero's Torque Amplified?

Pajero's torque can be amplified up to 1.9 times. The Mitsubishi Pajero V97, with a 3.8L engine, has a maximum horsepower of 250 HP and a maximum torque of 329 Nm. Introduction to Torque: Engine torque refers to the moment output from the crankshaft end of the engine. Under fixed power conditions, it is inversely proportional to the engine speed. The faster the speed, the smaller the torque, and vice versa. It reflects the vehicle's load capacity within a certain range. Method of Expressing Torque: Torque is expressed in N.m/r/min. The maximum torque generally appears in the medium to low-speed range of the engine. For example, ordinary motorcycles can achieve maximum torque at medium speeds (around five to six thousand RPM).
16
4
Share

Why is the suspension of the new Santana so stiff?

The reasons for the stiff suspension of the new Santana: shock absorber oil leakage, shock absorber malfunction. Shock absorber oil leakage: First, check if the shock absorber is leaking oil. Look directly at the shock absorber housing or dust cover when it's not raining or the car hasn't been washed. It's very obvious and can be seen at a glance. Shock absorber malfunction: When driving at low speed, if there is a "thud" sound when the wheels pass over bumps or slight vibrations on the road, it indicates a shock absorber malfunction. The abnormal noise from the shock absorber is different from other chassis noises—it's very dull. If it's the front shock absorber, there will also be noticeable vibration felt on the steering wheel.
3
3
Share

What causes the transmission failure in Geely Vision X3?

Reasons for transmission failure in Geely Vision X3: failure of the control module, malfunction of the shift solenoid valve, wear of internal gears in the transmission, failure of internal friction plates in the transmission, etc. Excessive transmission oil temperature: The transmission warning light may come on due to excessively high transmission oil temperature, such as overfilling of transmission oil, internal or external blockage of the transmission cooler. These situations mostly occur during high-temperature seasons, as well as due to transmission high-temperature protection caused by slippage of the torque converter lock-up. How to deal with the transmission warning light: If the transmission warning light comes on but no other abnormalities are detected, and the engine speed and vehicle speed are normal as usual, you can continue driving in this case. Then, arrange to check the cause of the transmission failure as soon as possible.
2
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.