Where to Handle Traffic Violation Points Deduction for Motor Vehicles?

How to Use the Handbrake When the Automatic Transmission Brakes Fail?

When you find that the vehicle's brakes have failed, first release the accelerator pedal and shift the gear to manual mode, then downshift from high gear to low gear. Automatic transmission vehicles generally do not have as noticeable braking effects as manual transmission vehicles when downshifting. Some models may even prohibit downshifting to protect the transmission. Therefore, you should downshift one gear at a time while using the handbrake to reduce speed before further downshifting. When pulling the handbrake, hold the release button and pull it intermittently, avoiding pulling it all the way at once. Below are the methods to handle brake failure while driving: 1. Identify the problem and slow down in time: It is crucial to develop good driving habits. Even when driving on flat roads, pay attention to the braking condition. Once you notice that the braking distance has increased or the brakes are not working properly, pull over or slow down immediately instead of continuing to drive at high speed. Vehicles on highways should stop in the emergency lane and call for assistance. 2. Use the handbrake wisely to control the vehicle: Before encountering continuous downhill or steep downhill sections, it is advisable to lightly tap the brakes to check their functionality. If the brakes fail, try using the handbrake to stop the car. When pulling the handbrake, avoid yanking it all the way or too quickly, as this may damage the handbrake or cause it to fail. Instead, apply gradual force and pull it slowly to the end. 3. Downshift appropriately to control speed: If the handbrake is slow to reduce speed or fails, promptly attempt to use forced downshifting (commonly known as "gear grabbing") to slow the vehicle with a lower gear. Once the speed decreases, combine it with the handbrake to bring the car to a gradual stop.

8

0

Share

Can You Still Drive When the Tire Pressure Monitoring Alarm Goes Off?

Tire pressure monitoring alarm is not recommended to continue driving after. Here are the reasons for the tire pressure monitoring alarm: 1. Tire puncture: A tire puncture usually results in very slow air leakage, which can be measured with a tire pressure gauge. If the tire is low on air, immediately replenish it and then observe the tire pressure warning light. 2. Excessive tire pressure: The standard inflation pressure for passenger car tires is typically specified as follows: standard tires: 2.4-2.5 bar; reinforced tires: 2.8-2.9 bar; the maximum pressure should not exceed 3.5 bar. Therefore, when the tire pressure of any tire exceeds 3.0 bar, it will trigger the tire pressure monitoring light to illuminate.

9

3

Share

Should You Shift to N or Keep in D When Waiting at a Red Light with an Automatic Transmission?

Shift to N gear when waiting at a red light with an automatic transmission. Here are specific details about automatic transmissions: 1. Starting and Initial Movement: When starting the engine of an automatic transmission car, the gear selector must be placed in the P or N position, and the handbrake must be engaged or the brake pedal depressed. 2. Driving on Flat Roads: While driving, the gear selector can be placed in the D position, and the transmission will automatically shift gears based on throttle input and vehicle speed. It is not the case that 'simply increasing the throttle opening from a D start will automatically shift to higher gears.' For novice drivers, the recommended technique is to ease off the throttle to prompt an upshift once the vehicle reaches a certain speed, and to press the throttle to prompt a downshift. 3. Driving on Slopes: For minor slopes, the D position can be used with the accelerator and brake pedals to control the vehicle's speed uphill and downhill. For longer or steeper slopes, novice drivers should shift the gear selector from D to S or L position.

13

3

Share

How often should front and rear tires be replaced?

Car tires generally need to be replaced every 5 years or approximately 60,000 to 80,000 kilometers. If the tires are severely worn, they must be replaced earlier. In cases where the tires show no issues, if the mileage reaches 80,000 kilometers, replacement is necessary even if the usage period hasn't reached 5 years. Tires may also be considered for replacement under the following conditions: 1. Wear level: Check the tread pattern on the tire surface. If the tread depth is less than 1.6 mm or aligns with the wear limit indicator, replacement is required. 2. Mileage: Generally, car tires need to be replaced every 60,000 to 80,000 kilometers. 3. Age: Tires older than 5 years will age at an increasingly faster rate. Even if the wear is not severe, replacement should still be considered.

9

2

Share

Which statement about using lights in rainy weather is correct?

If it rains during the daytime but the rainfall is not heavy and visibility remains relatively high, you only need to turn on the position lights. In heavy rain with very low visibility, you should turn on the fog lights. Here are some precautions regarding light usage in rainy weather: 1. Do not use hazard warning lights while driving. The so-called "hazard warning lights" (also known as emergency flashers) are available in every vehicle, with the switch typically featuring two interlocking triangles. These lights are generally not used during normal driving. Misusing hazard lights may send wrong signals to surrounding vehicles, potentially leading to dangerous situations. 2. As rain intensity changes gradually, it's incorrect to use only position lights throughout. You should reasonably switch between different lights according to the intensity of the rainfall.

2

Share

What Are the Reasons Why a Car Cannot Start in the Morning?

There are several reasons why a car may fail to start in the morning: insufficient battery charge, battery depletion; battery failure; excessive carbon buildup in the car. Below are detailed explanations and solutions: Insufficient Battery Charge: In the morning, if the output voltage is less than 12 volts, the starter motor may not reach the required speed. Check if the battery electrolyte needs to be replenished. It is generally recommended to replace the battery every 2 years. Battery Failure: In the morning, when the engine temperature is low, the viscosity of the lubricating oil increases, fuel volatility deteriorates, and the battery's working capacity weakens, leading to difficulty in starting. It is advisable to park the car in a garage with heating facilities. If parked outdoors, frequent starting of the vehicle can easily damage the battery due to prolonged high-load discharge, resulting in failure to start. Excessive Carbon Buildup: This can prevent the car from starting. Regularly driving at high speeds can help reduce carbon buildup. After starting the car, wait 30 seconds to a minute before driving. However, avoid driving at high RPMs during this time. Maintain a low speed for about 3-5 minutes, keeping the RPM generally below 2000. Once the engine temperature rises to the normal operating temperature, resume normal driving.

10

2

Share

Where to Handle Traffic Violation Points Deduction for Motor Vehicles?

How to Use the Handbrake When the Automatic Transmission Brakes Fail?

Can You Still Drive When the Tire Pressure Monitoring Alarm Goes Off?

Should You Shift to N or Keep in D When Waiting at a Red Light with an Automatic Transmission?

How often should front and rear tires be replaced?

Which statement about using lights in rainy weather is correct?

What Are the Reasons Why a Car Cannot Start in the Morning?

What's the reason for poor air conditioning cooling in BMW 3 Series?

Do Cars Need to Display Insurance Stickers Now?

What to Do When Your Driver's License Expires in Another City?

Why are pickup trucks not allowed in urban areas?