···
Log in / Register

Where to Check the Tire Pressure of Haval F7?

4 Answers
HavenRose
07/29/25 1:28pm
The tire pressure of Haval F7 is displayed on the dashboard. Here are the detailed instructions: 1. Specific operation to check the tire pressure of Haval F7: Press and hold the OK button on the steering wheel for five seconds, then use the up and down adjustment buttons to switch to the tire pressure display interface, where you can view the pressure and temperature information of all four tires in real-time. 2. The tire pressure display function of Haval F7 allows you to visually monitor the tire pressure: Both too low and too high tire pressure are undesirable, and they may trigger the tire pressure display or tire pressure warning system. Insufficient tire inflation pressure can also lead to excessive tire wear, poor vehicle control, reduced fuel economy, and may even cause wheel deformation. Therefore, it is essential to maintain the tire inflation pressure within the specified range. 3. Hazards of excessive tire inflation pressure: Excessive tire inflation pressure will result in an uncomfortable ride, excessive wear in the center of the tire tread, and increase the possibility of tire damage on hazardous road surfaces.
Was this review help?
13
1
Share
LeAdriana
08/14/25 4:05am
I drive a Haval F7 and usually check the tire pressure myself. After sitting in the driver's seat, I start the car and press the button with a symbol on the left side of the steering wheel—usually the one that displays icons or menus. Then, using the scroll buttons on the steering wheel, I navigate to the vehicle status option and find the tire pressure display screen. It shows the real-time pressure for each tire in units of bar or kPa. If the numbers are too low, like below 2.2, or too high, exceeding 2.8, I immediately inflate or deflate the tires. I check every two weeks, especially when the weather changes, as temperature drops can reduce tire pressure. I always check before long trips. This not only saves fuel but also prevents blowouts, making driving much safer. The car's tire pressure monitoring system is very handy—no extra devices needed, just check it on the dashboard. It’s quite convenient, and once you get used to it, the process becomes quick and easy.
Was this review help?
5
0
Share
Expand All
AmaraFitz
10/10/25 3:21am
I often drive a Haval F7, and checking the tire pressure is quite straightforward. On the right side of the steering wheel, there's a set of buttons. Press the menu button (usually labeled 'OK' or with a dashboard icon), and a list of options will appear on the screen. Use the left and right buttons to navigate to the tire pressure or vehicle information section. Once selected, you can see the pressure of each tire. The numbers are clear at a glance, and if there's an issue with any tire, a warning will flash. This feature is designed intuitively, making it easy even for beginners to use. Normal tire pressure is around 2.3-2.5 bar. Significant deviations can affect fuel consumption and tire lifespan, so I always take a quick look when refueling. Developing this habit helps avoid risks on the road. Don't forget regular tire maintenance—keeping the pressure even is a small but important tip for driving safety.
Was this review help?
2
5
Share
Expand All
WyattAnn
11/23/25 4:32am
I'm quite familiar with the Haval F7, and checking tire pressure can be done directly on the dashboard. After starting the vehicle, use the multifunction buttons on the steering wheel: press the menu button, locate the vehicle status or settings section in the display interface, and switch to the tire pressure reading page, which shows the real-time pressure values of all four tires. The unit may be bar or psi, depending on the model. If the pressure is abnormally low, the system will also issue an alert. I find this built-in monitoring system quite practical for timely issue detection. It's advisable to adjust tire pressure according to the season—slightly higher in summer and lower in winter for better safety. The key is to develop a habit of checking it regularly.
Was this review help?
11
5
Share
Expand All
More Forum Discussions

What car has tires that are 3.75 meters tall?

Having tires that are 3.75 meters tall is the Northern Heavy Duty TR100. Here are the specific details about the tires: 1. Tire function: Tires support the entire weight of the vehicle, bear the load of the car, transmit traction and braking torque, ensure the adhesion between the wheels and the road surface, reduce and absorb the vibrations and impact forces during driving, prevent severe vibrations and early damage to car components, adapt to the high-speed performance of the vehicle and reduce driving noise, ensuring safety, handling stability, comfort, and energy efficiency. 2. Tire maintenance methods: Tire maintenance methods include regularly cleaning stones from the tire treads, reducing exposure to sunlight, frequently checking tire pressure, paying attention to suspension maintenance, regularly inspecting front wheel alignment, and being mindful of driving habits.
19
1
Share

Will the Transmission Get Waterlogged After Wading?

Wading can cause water to enter the transmission. Here are the specific details about the transmission: 1. Definition: The transmission mainly refers to the vehicle's gearbox, which is divided into manual and automatic types. A manual transmission primarily consists of gears and shafts, achieving speed and torque changes through different gear combinations. An automatic transmission (AT) is composed of a torque converter, planetary gears, a hydraulic torque variation system, and a hydraulic control system, achieving speed and torque changes through hydraulic transmission and gear combinations. 2. Maintenance Methods: Correctly replace the transmission fluid. A better method is dynamic fluid replacement, which uses specialized transmission cleaning equipment to fully circulate the old fluid during operation, drain it completely, and then add new transmission fluid, achieving a replacement rate of over 90% and ensuring good results. Check the automatic transmission fluid level properly. The method for checking automatic transmission fluid differs from engine oil. Engine oil is checked when the vehicle is cold, while transmission fluid needs to be preheated to about 50°C. Then, after shifting the gear lever through each position for 2 seconds and placing it in park, the fluid level on the dipstick should be between the maximum and minimum marks. If it is insufficient, add the same quality fluid promptly.
16
3
Share

Can Wet Dual-Clutch Transmissions Wade Through Water?

Wet dual-clutch transmissions can wade through water, but it's important to pay attention to the water depth. Here are some precautions for using wet dual-clutch transmissions: 1. Avoid stomping on the accelerator in traffic jams: When driving a car with a dual-clutch transmission, if you encounter a traffic jam or need to stop at a traffic light, try to avoid stomping on the accelerator. This can cause the transmission to shift gears frequently, not only creating a jerky sensation but also causing the transmission to overheat too quickly, potentially leading to damage. 2. Press the brake pedal firmly or shift to N gear when temporarily stopping: When temporarily stopping, the brake pedal should be pressed more firmly. If the waiting time is long, you can also shift directly to N gear. If your foot slips on the brake, it might cause the transmission to remain in a semi-engaged state.
11
5
Share

i for intake or e for exhaust?

I stands for intake, which means IN in English, referring to the air entering the engine. E represents exhaust, also the first letter abbreviation of the English word for exhaust. Below are specific details about automotive exhaust pipes: 1. Overview: The exhaust pipe is part of the engine's exhaust system, which mainly includes the exhaust manifold, exhaust pipe, and muffler. Typically, the three-way catalytic converter, which controls engine pollutant emissions, is also installed in the exhaust system. Exhaust pipes generally consist of a front pipe and a rear pipe. 2. Function: For the vehicle's body, the exhaust pipe serves to reduce vibration and noise, as well as extend the lifespan of the exhaust and muffler system. Its working principle involves diverting airflow through multiple channels, where these divided streams rub and collide with each other, gradually reducing the airflow's velocity. This cycle repeats, ultimately allowing the exhaust gases to be emitted through the vehicle's exhaust pipe, thereby reducing noise and achieving the daily noise reduction effect for automobiles.
20
2
Share

What is the Road and Bridge Ticket During Vehicle Inspection?

Road and bridge tickets during vehicle inspection are mandatory fees that must be paid during the use of a vehicle after it has been registered. Below are specific details about vehicle inspection: 1. Definition: The annual vehicle inspection process refers to the fixed procedure that motor vehicles must undergo each year. It is a mandatory test for every vehicle, equivalent to a physical examination for the vehicle, aimed at promptly eliminating potential safety hazards. 2. Notes: If all items pass at once, the process takes about 2 hours; the compulsory traffic insurance policy must be valid; bring all necessary documents and files that might be needed; do not forget to bring the triangular warning sign and fire extinguisher; if the vehicle body has been modified or has non-compliant stickers, please clean them up before going for the annual inspection.
17
3
Share

Is solid color paint 1k or 2k?

Solid color paint is 1k. Below are specific details about solid color paint: 1. Difference from metallic paint: Metallic paint gets its name from the metal powder mixed in it. Not only does metallic paint make the painted surface appear dazzling, but due to light refraction, the car color and even its outline can change when viewed from different angles. Cars that appear reflective under sunlight generally use metallic paint. Another reason many car enthusiasts commonly choose metallic paint is that the addition of metal powder increases the hardness of the paint, making the surface harder, more wear-resistant, and less prone to scratches, whereas solid color paint does not have this effect. 2. Application: Suitable for the surface protection of metals, wood, plastics, and building exteriors, it can also be used as a surface protection and decorative coating for epoxy, polyurethane, acrylic series, and other paints.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.