Where to Buy a Car Fire Extinguisher?

Why don't motorcycles use lithium batteries?

Motorcycles do not use lithium batteries because lithium batteries are not as adaptable to deep cycle charging and discharging as lead-acid batteries. The following are the signs and causes of battery failure: Warning signs of battery failure: The motorcycle can start, but the dashboard or system will emit a warning sound during the starting moment. Symptoms of insufficient voltage: One scenario is that low-current electrical devices such as remote door opening, dashboard, and radio can function normally, but the starter motor fails to work, producing only a motor sound. Another scenario is that the motor can run normally, but the motorcycle fails to start. The reason is that the battery voltage is too low, causing the modules to malfunction and the system to fail to unlock. Symptoms of complete power loss: The remote cannot open the door, and there is no response at all.

9

0

Share

Are there any procedures required after completing the motorcycle license probationary period?

No procedures are required after completing the motorcycle license probationary period; it automatically upgrades to a full license. Below are the specific details about the motorcycle license examination: Examination Content: The motorcycle license examination consists of four sections. Sections one and four are theoretical tests, covering knowledge related to road traffic safety laws and regulations, as well as safe and civilized driving practices. Section two assesses skills such as riding on a single-plank bridge, slalom around cones, and hill starts. Section three's content is determined by the local provincial traffic management authorities and does not have a unified standard. Retake Instructions: If you fail the motorcycle license examination, you must complete a minimum practice period before scheduling a retest. Current regulations stipulate a minimum practice period of at least 10 days.

17

4

Share

Why Does a Motorcycle Wobble When Hands Are Off the Handlebars?

Here are the specific reasons why a motorcycle wobbles when hands are off the handlebars: Loose Bolts: This includes bolts directly related to motorcycle stability, such as front and rear axle nuts, swingarm pivot nuts, steering stem nuts, and shock absorber mounting bolts. Excessive Clearance: Excessive clearance in the steering stem, front and rear wheel bearings, or rear swingarm can cause this issue. The main reasons for excessive clearance, apart from improper adjustment, are excessive wear on corresponding components. Component Deformation: Improper operation or other reasons during use can lead to deformation of the front and rear wheels, front shock absorbers, or the frame. Tire Pressure: The tire pressure of both front and rear tires must be appropriate. Too high or too low pressure can cause the bike to wobble. Additionally, loose wheel spokes can also lead to handlebar wobbling.

9

4

Share

What are the adjustment standards for motorcycle headlight high and low beams?

Here are the detailed standards for adjusting motorcycle headlight high and low beams: Adjusting the high beam: The high and low beams of a motorcycle are generally determined by two filaments within the same bulb, so adjusting one will affect the other. Typically, the high beam should illuminate a distance of about 100 meters. Alternatively, you can use a wall 10 meters away as a reference, with the high beam slightly below the parallel line. Directional angle requirements: According to the geometric visibility requirements in the "Regulations for the Installation of Motorcycle Lighting and Light-Signaling Devices," the vertical angle should be 15 degrees upward and 10 degrees downward. For a single lamp, the horizontal angle should be 45 degrees to the left and right. For paired lamps, the outward angle should be 45 degrees, and the inward angle should be 10 degrees.

2

3

Share

Will the front passenger be fined for not wearing a seat belt in urban areas?

Front passengers not wearing seat belts in urban areas will be fined. If traffic police on-site detect a front passenger not wearing a seat belt or if the violation is captured by an electronic monitoring system, the passenger will be fined, reprimanded, and required to rectify the behavior. Here is an introduction to car seat belts: Function: Car seat belts are safety devices designed to restrain occupants during a collision and prevent secondary collisions with the steering wheel, dashboard, etc., or to prevent occupants from being ejected from the vehicle, which could lead to injuries or fatalities. Car seat belts, also known as seat restraints, are a type of occupant restraint system. Working Principle: The retractor's function is to store the webbing and lock it when pulled out, making it the most complex mechanical component in the seat belt system. Inside the retractor is a ratchet mechanism. Under normal circumstances, occupants can pull the webbing smoothly and freely while seated. However, when the webbing stops being pulled out continuously or when the vehicle encounters an emergency, the ratchet mechanism engages, automatically locking the webbing to prevent further extension.

13

4

Share

Do You Need to Press the Brake When Shifting Gears While Driving an Automatic Transmission Car?

When shifting gears while driving an automatic transmission car, you do not need to press the brake. The gears of an automatic transmission include: 1. P (Parking) gear for parking and starting; 2. R (Reverse) gear for reversing; 3. N (Neutral) gear; 4. D (Drive) gear for forward movement; 5. L (Low) gear for low-speed driving; 6. S (Sport) mode; 7. OD (Overdrive) gear. The correct way to use an automatic transmission is: 1. Start the vehicle in P or N gear, shift out of P gear by pressing the brake, turn on the power while pressing the brake, shift to N gear, and after ignition, shift to D gear to move forward directly; 2. When switching between N, D, and L gears, there is no need to press the shift button. When shifting from L gear to lower restricted gears, press the shift button, but when shifting from lower to higher gears, there is no need to press the shift button; 3. Do not shift into N gear to coast while driving; 4. Do not push into P gear while driving; 5. After driving, you must turn off the engine and shift into P gear before you can remove the key.

8

2

Share

Where to Buy a Car Fire Extinguisher?

Why don't motorcycles use lithium batteries?

Are there any procedures required after completing the motorcycle license probationary period?

Why Does a Motorcycle Wobble When Hands Are Off the Handlebars?

What are the adjustment standards for motorcycle headlight high and low beams?

Will the front passenger be fined for not wearing a seat belt in urban areas?

Do You Need to Press the Brake When Shifting Gears While Driving an Automatic Transmission Car?

Is Motorcycle Accident Insurance Mandatory?

Which Vehicles Can Get Green License Plates?

Where is the Haima 8S transmission produced?

Can a Spoiler Be Registered?