Where to Add Windshield Washer Fluid in Volkswagen Lavida?

How to Lift Up the Wiper Blades on a Sylphy?

Sylphy's wiper blades can be lifted up by raising them from the windshield. The wiper is a blade structure installed in front of the windshield, consisting of: an electric motor, a reducer, a four-bar linkage mechanism, a wiper arm spindle, and a wiper blade assembly. Its function is to clear rain, snow, and dust that obstruct the view on the windshield. The Sylphy's body dimensions are: length 4631mm, width 1760mm, height 1503mm, with a wheelbase of 2700mm, a minimum ground clearance of 166mm, a fuel tank capacity of 50 liters, a trunk capacity of 510 liters, and the body structure is a 4-door, 5-seater sedan.

16

5

Share

What to Do If Your Driver's License Expires Without Renewal?

Prepare the original driver's license, original ID card, three one-inch white-background color photos, and a physical condition certificate. After arriving at the vehicle management office, obtain and fill out the "Motor Vehicle Driver's License Application Form," which requires pasting a photo. The driver should submit the original driver's license, physical condition certificate, and other required documents to the vehicle management office where the driver's license was originally issued to apply for renewal. The vehicle management office will process the renewal within one working day after approval. Before applying for renewal, the driver must resolve any traffic violations or unpaid fines; otherwise, the vehicle management office will not issue a renewed license.

14

3

Share

How to Drive a Rear-Wheel Drive Car After Snowfall?

If you're deeply stuck in a mud pit, avoid pressing the accelerator hard as the faster the tires spin, the deeper you'll sink. Instead, gently press the accelerator until the car can move forward or backward. If the car cannot move forward or backward after the wheels are stuck in mud, get out and carefully observe the situation, then take appropriate emergency measures. If you have tools on hand, you can shovel away the mud in front of and behind the wheels, shaping the pit into a slope. If there's water in the pit, try to remove it. If you don't have tools, try filling the mud pit with stones, bricks, branches, etc., to increase the tire's grip on the ground and help the car get out of the pit.

9

4

Share

How to remove H4 headlight bezel?

First, of course, remove the old headlight, but you need to take off the front guardrail first. Remove several screws at the top and bottom to take it off, along with the grille; then unplug the headlight assembly power supply; use the corresponding screwdriver to remove the headlight screws. Use the corresponding screwdriver to remove the headlight screws, usually four screws. There are several small screws on the bezel; after removing them, you can take off the panel. After opening, be sure to clean the residual glue on the rear cover groove, then apply new glue. Pay attention when applying the glue: apply more and ensure the glue line is continuous. Finally, install the new headlight according to the removal method.

8

3

Share

How to Drain Summer Windshield Washer Fluid?

First, open the front hood safety lock, extend your hand to release the front hood, lift the safety latch upwards, and open the hood. Open the windshield washer fluid reservoir cap, insert a roughly 2-meter-long hose into it, pushing it as deep inside as possible. Then, from the other end of the hose, siphon out the fluid from the reservoir. When the fluid level drops to about the height of the headlights, lower the hose. Wait until the reservoir is completely drained, lift the funnel upwards, and add a small amount of new windshield washer fluid concentrate into the reservoir. Activate the windshield wipers to draw up and spray the new windshield washer fluid concentrate, thereby clearing any residual fluid from the pipes.

16

3

Share

How to Replace Coolant

Wait at least 10 minutes after the engine is turned off before replacing coolant. The coolant temperature remains dangerously high immediately after driving and can cause burns. Check all pipes for signs of leakage or cracks, and inspect the five-way water pipe. If there's any coolant leakage, replace the hose or resecure the connection as needed. Use a jack to lift the vehicle. Loosen the radiator drain plug with a wrench and collect the old fluid in a waste container. Cover the expansion tank cap with a thick towel and slowly loosen it until pressure is fully released before completely removing the cap. Use compressed air blower or apply pressure with a thick towel at the expansion tank filler neck to purge residual coolant from the engine block. Then fill with new coolant up to the maximum level mark.

8

3

Share

Where to Add Windshield Washer Fluid in Volkswagen Lavida?

How to Lift Up the Wiper Blades on a Sylphy?

What to Do If Your Driver's License Expires Without Renewal?

How to Drive a Rear-Wheel Drive Car After Snowfall?

How to remove H4 headlight bezel?

How to Drain Summer Windshield Washer Fluid?

How to Replace Coolant

Can You Apply Car Window Film on Rainy Days?

What are the components of an automatic transmission?

How to Open the Trunk of an Atenza?

How to Release the Clutch Smoothly When Shifting Gears?