Where to Add Windshield Washer Fluid in the Magotan?
2 Answers
Windshield washer fluid in the Magotan is added to the washer fluid reservoir located in the engine compartment. The steps to add windshield washer fluid are as follows: 1. Open the hood and locate the washer fluid filler port; 2. Remove the cap and pour the washer fluid into the reservoir; 3. Observe the fluid level until it reaches the marked line. Taking the 2020 Magotan as an example, it is a mid-size sedan with the following dimensions: length 4865mm, width 1832mm, height 1471mm, and a wheelbase of 2871mm. The curb weight is 1445kg. The 2020 Magotan features a front McPherson independent suspension and a rear multi-link independent suspension. It is equipped with a 1.4L turbocharged engine, producing a maximum horsepower of 150PS, a maximum power of 110kW, and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
Adding windshield washer fluid to the Magotan is quite simple. Open the hood, stand facing the engine compartment from the front of the car, and look to the left. On the driver's side, below the windshield, you'll find a blue plastic cap with a windshield and water spray symbol. This is the windshield washer fluid filler port. Just unscrew the cap and pour the fluid directly in, but don't fill it too full—leave some space. Remember to buy good-quality washer fluid; choosing an anti-freeze type in winter is especially important. After use, make sure to tighten the cap securely to prevent dust and debris from getting in and clogging the spray nozzles. If the spray isn't clean, you may also need to check the nozzle angle and adjust it with a needle.
