Browse

Property For Sale Property For Rent

Used Cars Others

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Others Pet Supplies Sporting Goods Ticket Toys Games Transportation

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Vehicle rentals Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

···

Log in / Register

Where is the wiper fuse located in a BMW 5 Series?

1 Answers

SanGage

09/06/25 6:57am

BMW 5 Series fuse box is located inside the glove compartment on the passenger side. After opening the glove compartment, remove the interior trim panel to access the fuse box. There is also another fuse box located on the side of the trunk. Steps to replace a fuse: Locate the corresponding position of the fuse box, then carefully pry open the cover using a screwdriver or other tools. On the inner side of the cover, you can find the corresponding component fuse based on the information provided. When replacing with a new fuse, ensure that parameters such as current match those of the original fuse. Important notes regarding fuses: Installing a fuse with a current rating higher than specified can easily cause component overload and damage. Never attempt to repair a fuse that has already been damaged.

Was this review help?

3

1

Share

More Forum Discussions

What is the reason for the 'Check Engine' light appearing after starting the Bestune T77?

Possible reasons for the 'Check Engine' light appearing after starting the Bestune T77 are as follows: 1. Issues with the car's engine cooling system; 2. Thermostat failure; 3. Problems with the oxygen sensor; 4. The vehicle's exhaust emissions do not meet standards; 5. Issues with the gasoline, etc. Here are the solutions: 1. Determine if the engine is working properly by checking the long-term and short-term fuel trim values and the injection pulse width. 2. Determine if the engine is working properly by checking the oxygen sensor's output voltage and change frequency. 3. Diagnose car faults through exhaust emission test data.

What to Do When a Car Tire Blows Out?

Do not slam on the brakes; instead, gradually reduce speed. Here is relevant information: 1. When a tire suddenly blows out while driving at high speed, it can cause the vehicle to veer to one side. Slamming on the brakes can exacerbate this veering, potentially leading to a rollover. While gradually slowing down, firmly grip the steering wheel with both hands and turn it in the opposite direction of the blown-out tire to maintain straight-line driving. 2. If a tire blows out while driving on a highway, hold the steering wheel firmly, check the rearview mirror, and then move the vehicle to the right, ideally onto the right hard shoulder for safety. Note: Do not occupy the far-left overtaking lane, as it poses a higher risk.

What is the throttle body matching method for the Nissan Sylphy?

Nissan Sylphy throttle body matching method: 1. Turn off the ignition switch and wait for at least 10 seconds. 2. Ensure the accelerator pedal is fully released, then turn the ignition switch to the ON position and wait for 3 seconds. 3. Within 5 seconds, quickly repeat the following steps 5 times: a. Fully depress the accelerator pedal. b. Fully release the accelerator pedal. 4. Wait for 7 seconds, then fully depress the accelerator pedal and hold it for about 20 seconds until the MIL stops blinking and remains lit. 5. Within 3 seconds after the MIL light turns on, fully release the accelerator pedal. 6. Start the engine and let it idle for a while. 7. Allow the engine to idle for more than 20 seconds. 8. Rev the engine to high speed two or three times to confirm that the idle speed and ignition timing meet the specified requirements.

Is the Corolla equipped with independent suspension?

The front suspension of the Corolla is an independent suspension, using a MacPherson strut independent suspension, while the rear suspension is a torsion beam non-independent suspension. Below is some relevant information about the Corolla: 1. The Corolla features a combination of front MacPherson independent suspension and rear torsion beam non-independent suspension, which is the most commonly used suspension setup in compact cars. The chassis is not covered with plastic shields but is treated with a coating, which is evenly applied and covers a large area. 2. The front suspension lower control arm is connected to the subframe via regular bushings; the front suspension lower control arm is connected to the bearing housing via rubber bushings. The advantage of this non-bolt rigid connection method is that it reduces the impact force between the components.

Where is the turn signal fuse located in an Audi Q7?

Audi Q7 turn signal fuse is located on the left side of the main driver's steering wheel, below the foot pedal. The following is relevant information about turn signals: 1. Turn signals are important indicator lights that are activated when a motor vehicle turns to alert vehicles and pedestrians in front, behind, left, and right. The turn signal tube uses a xenon tube, and the microcontroller controls the circuit to work continuously with alternating left and right flashes. 2. The turn signal uses a flasher to achieve light flashing. It can be mainly divided into three types: resistance wire type, capacitor type, and electronic type. Among them, the resistance wire type can be further divided into thermal wire type or electric heating type and vane type or bouncing type, while the electronic type can be further divided into hybrid type (with contact type relay and electronic components) and fully electronic type (without relay).

Why does water drip from under the car when the air conditioning is on?

Because the car's air conditioning system is equipped with an evaporator inside the dashboard. When the air conditioning is turned on (A/C button ON), the surface temperature of the evaporator becomes very low. The moisture in the hot air inside the car condenses on the heat-absorbing fins of the evaporator, and the water droplets are collected by the plastic housing of the evaporator and drained out of the car through a pipe. The functions of the air conditioning system are as follows: 1. The air conditioner can control the temperature inside the cabin, heating or cooling the air to maintain a comfortable level; 2. The air conditioner can remove moisture from the air. Dry air absorbs sweat from the body, creating a more comfortable environment; 3. The air conditioner can intake fresh air, providing ventilation; 4. The air conditioner can filter the air, removing dust and pollen.

Trending Ranking

How to Open the Hood of a Buick GL8?

How to Remove the Gear Shift Knob on a Buick GL8?

How to Connect CarPlay in Buick GL8?

How to deactivate the transport mode on Buick GL8?

How to Connect Bluetooth in Buick Envision S?

What is the method for changing the transmission oil of the Buick Envision 1.5T?

Where is the transmission oil filler hole on the Peugeot 308?

How many cylinders does the BMW 740 have?

Does the Toyota Levin have a one-key start?

What is the wheel size of the Magotan?

More Forum Discussions

How to Turn Off the Sagitar with One-Key Start?

How many boxes can fit in the T-Roc's trunk?

Is 14L/100km Fuel Consumption Normal for a BMW 525 in City Driving?

How to Turn on the Rear Air Conditioning in the Buick GL8 Landlord?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.