Where is the windshield washer fluid reservoir located in the Sylphy?

1 Answers
VivianFitz
07/29/25 11:23am
The windshield washer fluid reservoir in the Sylphy is located at the filler port in the lower left corner of the engine compartment. Windshield washer fluid is primarily composed of water, alcohol, ethylene glycol, corrosion inhibitors, and various surfactants. The Sylphy has the following body dimensions: length 4631mm, width 1760mm, height 1503mm, with a wheelbase of 2700mm, minimum ground clearance of 166mm, fuel tank capacity of 50 liters, and trunk capacity of 510 liters. The Sylphy is equipped with a 1.6L naturally aspirated engine producing maximum power of 90kW and maximum torque of 155Nm, paired with a 5-speed manual transmission.
Was this review help?
15
4
Share
More Forum Discussions

How Long Can You Drive with Cracked Tires?

Tires with cracks can still be temporarily used for about a year, as the cracks are caused by natural rubber aging. Generally, small cracks may appear on tires after 3 to 5 years of use. If the tires have been used for more than 5 years, they become harder, produce more noise, and essentially lose their rubber properties, making them unsuitable for further use and requiring timely replacement. The most common sign of tire rubber aging is the appearance of cracks and numerous small fissures on the tire surface, a phenomenon known as tire cracking. Since tire rubber requires a certain level of hardness, a process called vulcanization is employed during manufacturing. Vulcanized rubber increases hardness but tends to age over time. These small cracks typically appear on the inner and outer sidewalls and the tread grooves. Severe cracking can cause the rubber to lose its inherent physical and chemical properties. Since tires are made of rubber, some degree of cracking is inevitable after prolonged use. Exposure to air, direct sunlight, exhaust fumes, and ozone pollution can all accelerate the cracking process. Long-term use of tire cleaners may inadvertently remove or damage additives such as antioxidants and anti-ozonants in the tires. Sun exposure or excessive cleaning are just minor causes of small cracks. Frequent driving can help prevent tire rubber aging, as the repeated stretching of the rubber during travel aids in preventing crack formation.
2
3
Share

Does the Boyue Pro have ambient lighting?

2021 Boyue models do not come with ambient lighting across the entire lineup. Ambient Lighting: Ambient lighting in a car serves as decorative illumination, typically in colors like red, blue, or green. If the Boyue had ambient lighting, it could make the cabin more vibrant at night, enhancing the atmosphere and creating a cozy interior ambiance. However, it's important to note that the lighting colors should not interfere with the driver's normal and safe operation of the vehicle. Boyue: The Boyue PRO, hailed as China's "Three-Good SUV," officially debuted in Changchun. The all-new Boyue PRO is available in six variants with two engine options: 1.5TD and 1.8TD, with an official price range of 98,800 to 156,800 yuan. As a "cloud-intelligent SUV," the Boyue PRO, following the Boyue's pioneering role in ushering in a new era of intelligent connectivity in Chinese automobiles, once again leads the forefront of automotive intelligence in China. It defines new standards for intelligent vehicles in China across four key areas: automotive-grade chips, intelligent interaction, cloud manufacturing, and intelligent safety. For its core components—chassis, engine, and transmission—the Boyue PRO benefits from technological empowerment by luxury brands Volvo and Lotus, achieving the highest standards among Chinese brands.
15
0
Share

What Causes the Sunroof Failure in Baojun 560?

Baojun 560 sunroof failure may be caused by circuit faults or blown fuses. Circuit Faults: Sunroof circuit malfunction or damage to the sunroof drive motor. Severe lack of lubrication in the sunroof tracks can cause the sunroof seal to adhere to the car body. Obstruction in Sunroof Track: It is recommended to first check if the sunroof fuse is blown. If the fuse is intact, inspect whether the sunroof switch is functioning properly. Press the switch to check if there is power. If there is, then examine whether the sunroof drive motor is operational. Listen for any sounds of the motor working. Additionally, if the sunroof doesn't close properly, it might be due to obstructions, deformation, rust, or poor lubrication in the sunroof track. Meaning of Sunroof: The two sides of the sunroof are sliding tracks that ensure the sunroof moves back and forth. At the front corners of these tracks are the sunroof drainage holes. Common Sunroof Issues: Blocked or broken drainage pipes can lead to water leaking from the sunroof seam into the interior. If the pipes are broken, it can also cause water seepage in the car's A-pillar or C-pillar. Another common issue is the aging of the sunroof's sealing strip, which can result in water leakage.
2
4
Share

How to Properly Touch Up Car Paint?

First, completely remove rust, dirt, and grease from the paint surface. You can start by using very fine water sandpaper dipped in water to gently sand away rust spots, then thoroughly clean the area to ensure the rust doesn't spread. Carefully apply masking tape above and below the scratch. This is mainly to avoid accidentally applying touch-up paint to other areas or causing paint runs. Shake the touch-up pen vigorously at least 30 times to mix the paint evenly. Then unscrew the cap, remove the pen, and scrape off excess paint at the bottle opening. Use the pen tip to carefully and evenly apply paint to fill the scratch. Apply a thin first coat, wait about 5 minutes for it to partially dry, then apply second and third coats until the touched-up area is slightly higher than the surrounding original paint. For better results, you can also use polishing compound to level the scratch and paint surface, improving paint adhesion. After waiting 3 days, remove the tape and inspect the paint. If the touched-up area is noticeably higher, use a single-edge razor blade to carefully shave off some of the excess paint, using the same technique as when modifying drawings to avoid damaging surrounding areas. Results show the paint remains soft and brittle, with some paint in the scratch possibly having come off. Reapply touch-up paint and wait another 2 days. Soak 2000-grit waterproof sandpaper in soapy water for 20-30 minutes to soften it and minimize damage to the original paint. Clean surface dust, secure the sandpaper with a sanding block, then lightly wet-sand the touched-up area until it's level with the surrounding paint.
18
4
Share

What tires come standard on the Compass?

This Jeep Compass comes with tires of the following specifications: 215mm/60R17. It uses Continental tires from Germany. Below is more information about the tire model: 1. Most tire model markings look like: 215mm/70R15. The meanings of these numbers are as follows: 215 represents the tire section width in millimeters, generally ranging from 145 to 285mm in increments of 10mm; 70 is the aspect ratio, which is the ratio of the tire sidewall height to the tire section width, with 70 representing 70%. Generally, tire aspect ratios range between 30% and 80%. Normally, ordinary sedans should not use tires with an aspect ratio >75%, while luxury cars and high-performance sports cars are recommended to use tires with an aspect ratio <60%; R stands for Radial, indicating the tire has a radial structure, and 15 is the rim diameter in inches. 2. The Compass uses Continental tires from Germany. The advantages of Continental tires include safety, reliability, and lower noise levels, with unique tread patterns on the tire surface that enhance vehicle handling performance. Additionally, Continental tires offer excellent braking performance on both dry and wet surfaces, higher water drainage protection, and are the only road tires globally approved for driving at speeds up to 360 km/h, earning a place in the Guinness World Records. They also boast an excellent product lifespan, making them a high-value product.
4
4
Share

What are the differences between Michelin 3st and 4st?

The differences between Michelin 3st and 4st are as follows: 1. Different drainage performance: Michelin Primacy 4 adopts Evergrip technology with a brand-new tread pattern design, increasing the drainage space by more than 50% compared to 3st, providing excellent drainage performance. During rainy days, a water film is easily formed between the tire and the road surface, significantly reducing the occurrence of hydroplaning to a certain extent. 2. Different rubber compound: Compared to 3st, Michelin Primacy 4 utilizes a new tread pattern design and a new rubber compound, improving the wet braking performance and rolling resistance for both new and worn tires, thereby enhancing safety.
15
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.