Where is the water temperature gauge of the new Bora?

2 Answers
IvanAnn
07/24/25 11:04am
The water temperature gauge of the new Bora is located in the LCD display in the middle of the instrument panel. When the water temperature warning light on the instrument panel comes on, it is not advisable to continue driving. You can stop the car and wait for the water temperature to drop before driving to a service station for inspection and repair. More information is as follows: 1. The normal operating temperature of the new Bora's radiator is 90°C. When the car engine is running normally, it requires a certain operating temperature. Too high or too low is not conducive to the normal operation and performance of the engine. On the other hand, the heat generated by the engine is difficult to meet the demand with conventional air cooling, so water cooling is widely used in car engines. The function of the cooling system is to keep the engine operating within the most favorable temperature range to improve engine power and reduce engine wear and fuel consumption. Too high or too low temperature will have adverse effects on the engine's operation. 2. If the water temperature warning occurs during high-speed driving, you should pull over safely, but do not turn off the engine immediately. Instead, let it idle for two or three minutes, open the engine hood, and then call for assistance. Because when the water temperature warning occurs, the engine is running at high speed, and a large amount of heat generated by the engine has not been dissipated. Therefore, it is necessary to let the water temperature drop slightly while idling to minimize the damage caused by high temperature to the engine.
Was this review help?
13
2
Share
AaronLee
08/11/25 6:03am
I've been driving my new Bora for several years, and the water temperature gauge is right on the dashboard in front of the driver's seat, very easy to locate. Look at that instrument cluster section – there's usually a thermometer icon or digital display on the left or middle, specifically indicating the engine coolant temperature. During normal driving, the temperature typically stays around 90°C; if the needle suddenly spikes, you should be cautious as it might indicate low coolant level or fan failure, signaling engine overheating risk. I once experienced slightly higher temperature during summer traffic jams – immediately pulled over to check coolant level and topped up with distilled water to solve it. For regular maintenance, don't forget to inspect the cooling system. Coolant should be replaced every six months, and using antifreeze in winter gives extra peace of mind. After all, engine overheating can damage internal components with costly repairs, so make it a habit to frequently glance at the temperature gauge – it's both safe and cost-effective.
Was this review help?
6
2
Share
Expand All
More Forum Discussions

What does the exclamation mark inside a triangle signify?

An exclamation mark inside a triangle represents a general vehicle malfunction indicator. Common vehicle malfunctions include overheating of the dry dual-clutch transmission, intervention or failure of the fuel cutoff system, parking sensor malfunction, exterior bulb failure, engine oil pressure sensor malfunction, and traction control system warning or malfunction. There are various warning or indicator lights with exclamation marks on the dashboard. The eight most common types are: handbrake warning light, brake system malfunction warning light, steering system malfunction warning light, abnormal tire pressure warning light, lighting system malfunction warning light, transmission malfunction warning light, windshield wiper malfunction warning light, and general malfunction indicator light.
14
0
Share

What is the range of the Polestar 2?

The Polestar 2 has a range of 450 kilometers. The Polestar 2 is a compact sedan under the Polestar brand, and it is a dual-motor all-wheel-drive vehicle with motors on both the front and rear axles. The motor on the front axle of the Polestar 2 has a maximum torque of 330 Nm and a maximum power of 150 kW, while the rear axle motor also has a maximum torque of 330 Nm and a maximum power of 150 kW. The Polestar 2 uses a MacPherson independent suspension at the front and a multi-link independent suspension at the rear. The vehicle is equipped with a ternary lithium battery across all models, which is commonly used in most pure electric vehicles and plug-in hybrid vehicles.
19
0
Share

What is the battery model for the Kia K4 key?

The battery model for the Kia K4 key is a CR2032 coin cell. The steps for key disassembly and battery replacement are as follows: 1. Separate the key by gently prying open the back cover with a flat-head screwdriver and removing it; 2. Separate the upper and lower panels, then remove the old battery; 3. Install the new battery by placing it into the slot; 4. Reassemble the panels and the key. When installing the battery, note that the positive side should face downward. The Kia K4 is a mid-size sedan from Dongfeng Yueda Kia, with body dimensions of 4720mm in length, 1815mm in width, and 1465mm in height, and a wheelbase of 2770mm.
4
5
Share

What are the Volkswagen car brands?

Volkswagen car brands include Bugatti Veyron, Lamborghini, Porsche, Audi, Skoda, SEAT, Bentley, MAN, Passat, Jetta, etc. Taking the Passat as an example, the Passat is a B-class car under Volkswagen, with a body size of 4870mm in length, 1834mm in width, and 1472mm in height, and a wheelbase of 2803mm. In terms of appearance, the Passat incorporates Volkswagen's minimalist style, with exterior design inspired by the Volkswagen Phaeton. The bumper design has been modified, and the shapes of the front and rear light clusters have been changed, featuring LED taillights and LED daytime running lights. The stable and dignified styling aligns with its business-oriented characteristics.
5
4
Share

Will a Car Be Scrapped If It Gets Flooded?

Whether a car will be scrapped after being flooded depends on the extent of the flooding. If the intake system is severely flooded, the car might be scrapped. Solutions for a flooded car: 1. Do not start the car if it has been flooded, as the intake system could draw water into the engine, causing damage; 2. Contact a towing company to transport the car to a repair shop; 3. After being flooded, the car's computer board and wiring harness must be thoroughly cleaned to prevent short circuits or damage to the computer board. The car's chassis must also be treated to prevent rust; 4. The car should be completely stripped, including removing the floor mats, to drain all water from the body. Rust-proofing measures should be reapplied, and it is recommended to replace the wiring harness and computer board to avoid safety hazards.
19
2
Share

What is the valve clearance for Cummins 2.8?

Cummins valve clearance is: intake valve 0.305mm, exhaust valve 0.559mm. Here is the relevant introduction: 1. Definition: Cummins valves are part of the Cummins engine. Cummins engines have a displacement range of 1.4 to 91 liters, with power outputs ranging from 31 to 3500 horsepower. They are widely used in heavy-duty trucks, medium-duty trucks, buses, recreational vehicles, light commercial vehicles, and pickup trucks for on-road applications, as well as in engineering machinery, mining equipment, agricultural machinery, marine, and railway applications for off-road equipment. 2. Advantages: Cummins engines are not only renowned for their top-tier reliability, durability, and fuel economy in the industry, but they also maintain a leading position in meeting increasingly stringent emissions standards for vehicles (such as U.S. EPA 2007/2010, Euro IV and V), non-road mobile equipment (Tier 3 and above), and marine engines (IMO standards).
20
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.