Where is the water pump located on a Toyota Crown?

[DelCaden]

Toyota Crown water pump is located on the engine block. Below is the replacement method: 1. Clean the pump shaft, gently sand if necessary, and wipe the shaft and static ring groove with a clean cloth, ensuring no debris or small particles remain; 2. Apply lubricant to the motor shaft and static ring groove, clean the new mechanical seal static ring with a clean cloth, apply lubricant to the outer ring and end face of the static ring, then embed the static ring with the end face outward into the groove, ensuring it is level; 3. Clean the moving ring, apply lubricant to the inner ring and end face, gently rotate with the end face inward to gradually press the moving ring against the static ring end face, then compress the moving ring spring; 4. Slide the impeller onto the pump shaft, place a small wooden block on the impeller, gently tap with a hammer to install the impeller in place, then tighten the impeller fixing screw; 5. Insert the motor and impeller into the pump body, being careful not to damage the O-ring on the end cover outer ring, adjust the impeller position, rotate the impeller to prevent jamming at the mouth ring, evenly tighten the end cover screws, check for impeller jamming, and make necessary adjustments.