···
Log in / Register

Where is the VIN number located on the JAC Refine?

5 Answers
SanCassidy
07/29/25 12:13am

JAC Refine's VIN number is located under the rear of the front passenger seat, covered by a small black lid that can be removed for visibility. The VIN is a 17-character alphanumeric code. Through its unique combination, this vehicle identification code ensures no duplication occurs within the same vehicle model for 30 years, serving as the car's unique identifier - essentially the automobile's ID card. The JAC Refine is equipped with either a 2.4L gasoline engine or a 2.5L turbocharged diesel engine. The gasoline engine delivers a maximum power of 100kW and peak torque of 193Nm, while the diesel engine produces 137kW maximum power and 197Nm maximum torque.

Was this review help?
16
4
Share
DeSabrina
08/12/25 3:26am

I drive a Jianghuai Refine model, and the VIN location is quite common. It's usually at the lower left corner of the windshield, and you can clearly see the numbers engraved on the glass when viewed from the front. After opening the door, there's a sticker label on the driver's side door pillar with the complete VIN, easily visible by just opening the door. Sometimes at repair shops, I've also seen small labels near the front bumper in the engine compartment, but you need to lift the hood to see them. This number is like the car's ID card and is very important—used for registration, insurance, or buying/selling the car. If you can't find it, don't panic; check the vehicle manual or registration documents, as they record the location. I recommend taking a photo and saving it on your phone for easy access and to avoid fading over time, making it hard to read.

Was this review help?
1
0
Share
Expand All
DiGemma
10/01/25 7:06am

As an automotive enthusiast, I've found that the VIN (Vehicle Identification Number) of Jianghuai Refine is usually engraved at the lower left corner of the windshield, clearly visible from outside the car with just a glance down. Checking the sticker on the inner side of the driver's door pillar is another reliable spot. I've also explored the engine compartment, where sometimes there are engravings near the front, though you'll need to lift the hood and search carefully. This 17-digit code contains information about the vehicle model and year, and decoding it can be quite enjoyable, while also serving important anti-counterfeiting and anti-theft purposes. I recommend carrying a small flashlight to illuminate and easily spot faint label locations, and to routinely check multiple times to ensure quick access during vehicle-related matters like maintenance or ownership transfers.

Was this review help?
16
3
Share
Expand All
MacBentley
11/15/25 2:05am

As a new driver, finding the chassis number of a Jianghuai Refine is quite simple. It's located on the lower left side of the windshield and clearly visible from outside the car. There's also a small label on the door pillar after opening the door, which can be found with a careful look. Don't worry, just take some time to confirm it. The chassis number is useful for routine car repairs or when selling the vehicle. I usually take a photo and save it on my phone for backup. If you can't find it, don't panic—refer to the manual or drive to a professional shop for assistance. As a beginner, handling this is completely stress-free.

Was this review help?
2
4
Share
Expand All
StAlexandra
01/05/26 3:42am

From my experience in vehicle handling, the primary locations to check for the JAC Refine VIN are the lower left corner of the windshield and the label on the driver's door pillar when opened. Follow this two-step process: First, inspect the windshield engraving from outside the vehicle for clear legibility; then open the door to verify the label's integrity. If not found, refer to the owner's manual or backup vehicle documents. Remember to verify the complete 17-digit code to avoid input errors affecting service. Park in well-lit areas for safe and accurate operation. The VIN is critical information - timely recording saves time and hassle.

Was this review help?
14
5
Share
Expand All
More Forum Discussions

Does Cleaning Wax Damage Car Paint?

Cleaning wax can damage car paint. Long-term use may thin the paint layer, and since cleaning wax contains organic solvents, frequent application can cause white car paint to discolor and turn yellow. Cleaning wax is designed for removing stains, rust, and scale, primarily used for cleaning and maintaining the vehicle's exterior. The application method is relatively simple: before waxing, ensure the car body is thoroughly cleaned and dried to avoid affecting the waxing results. Then, directly apply the cleaning wax to surfaces with stubborn stains that water cannot remove, and gently wipe them off with a soft towel. It's important to note that cleaning wax should not be used when the car's surface temperature is high, as this can reduce its effectiveness. Wait until the body temperature cools down to normal levels before use.
15
4
Share

What Causes the Fluctuation of the Car's Water Temperature Gauge?

The fluctuation of the car's water temperature gauge is caused by a faulty water temperature sensor, a damaged thermostat, or a cooling system malfunction. The car owner should check whether there is any leakage in the engine cooling system and whether the water pump is functioning properly. The car's water temperature gauge is considered normal as long as it remains within the standard range. The gauge ranges from C to H, where C represents 60 degrees Celsius. If the needle points to C, it indicates the water temperature has reached 60 degrees Celsius. The H red mark represents 110 degrees Celsius. If the needle enters the red zone, it means the water temperature is too high. Prolonged high water temperature can lead to 'boiling over,' which refers to the engine coolant boiling, potentially causing the radiator to expand and the engine to overheat and sustain damage.
10
1
Share

What Causes the Squeaking Sound When Braking a Car?

When a car makes a squeaking sound during braking, it is usually due to rust on the brake discs and brake pads. The owner needs to remove the brake discs and pads and sand off the rust layer with sandpaper. The brake is a mechanical braking device that can slow down the vehicle, also known as a decelerator. The car's brake pedal is located below the steering wheel. Pressing the brake pedal causes the brake linkage to be pressurized and transmitted to the brake pads on the brake drum, clamping the brake rotor to slow down or stop the vehicle. The manual brake (handbrake) in a car is located next to the gearshift and is connected to the brake lever. Common examples also include bicycle brakes, which rely on rod-shaped brakes fixed to the frame or disc caliper brakes to decelerate.
9
1
Share

Is the transmission of the Tiggo 8 dry or wet?

The transmission of the Tiggo 8 is a dry type. A dry transmission utilizes multiple friction plates and metal diaphragms connected to the input shaft for power transmission. Power is transferred when the friction plates and diaphragms are pressed together, and the transmission is interrupted when they are separated, which is the same method used in manual transmissions. The Tiggo 8 is a mid-size SUV under the Chery brand, with dimensions of 4700mm in length, 1860mm in width, and 1746mm in height, a wheelbase of 2710mm, and a body style of a 5-door, 5-seat SUV. The transmission is a 6-speed manual. The vehicle is equipped with a 1.5T L4 engine featuring turbocharged intake, delivering a maximum horsepower of 156ps and a peak torque of 230nm.
17
4
Share

What Causes No Response When Using the Key to Open the Trunk?

No response when using the key to open the trunk is due to insufficient battery power in the remote key. Below is the method for replacing the car key battery: 1. Take out the car key. There is a gap on the side of the key, near the key ring. Insert a flat-head screwdriver into the gap after unfolding the key. 2. Flip the Volkswagen logo upward and forcefully pull the key upward to open the key cover. Once opened, you can see a battery inside the key. 3. Use the screwdriver to pry out the battery, being careful with the force. Insert the new battery into the car remote key in the opposite order of removal. Pay attention to the positive and negative poles, ensuring the battery is not installed backward. Finally, snap the key's back cover back into place.
14
1
Share

What is the minimum ground clearance of the GAC Toyota Wildlander?

The minimum ground clearance of the GAC Toyota Wildlander is 170mm. The GAC Toyota Wildlander is a compact SUV with dimensions of 4665mm in length, 1855mm in width, and 1680mm in height, and a wheelbase of 2690mm. It is a 5-door, 5-seater SUV equipped with a CVT transmission (simulating 10 gears) and a top speed of 180 km/h. The vehicle is powered by a 2.0L L4 naturally aspirated engine, producing a maximum horsepower of 171ps and a maximum torque of 209nm. It features front-wheel drive, electric power steering, and a unibody structure.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.