Where is the VIN number located on a Nissan Patrol?

2 Answers
Marley
08/30/25 7:21am
The VIN number is located on the cover plate beneath the windshield wipers. You need to open the engine compartment to see it, at the position indicated by the arrow. Introduction to VIN: The VIN is a unique set of numbers on a vehicle that identifies the manufacturer, engine, chassis number, and other specifications. These numbers act like a vehicle's fingerprint, helping to track issues, ownership changes, and prevent theft. The location of the VIN may vary among different vehicle brands. Nissan Patrol VIN Introduction: The first digit identifies the country/region of origin. If the vehicle is assembled from parts produced in different countries/regions, this digit represents the assembly country/region. The second digit identifies the vehicle manufacturer. The third digit identifies the manufacturer's internal division or the general vehicle type.
Was this review help?
4
5
Share
NaomiMarie
09/12/25 4:20am
Buddy, the Nissan Patrol's VIN is something I've seen countless times in my over ten years in this business. It's usually found in a few standard locations. The most obvious spot is at the lower corner of the windshield on the driver's side – just stand in front of the car and look inward to spot that small metal plate engraved with a 17-digit alphanumeric combination. Another place is on the label attached to the inner side of the B-pillar (the door post on the driver's side) when you open the door, or sometimes on the information plate near the seats. After popping the hood, you might also find it stamped near the firewall in the engine bay or on the frame rail. Why do I always stress checking these spots? Because the VIN is like a car's ID card – you'll need to verify it when buying used vehicles or registering insurance to avoid stolen or salvaged cars sneaking through. My advice? Clean the area thoroughly before checking, and use a flashlight if the lighting's poor – don't miss any details.
Was this review help?
4
2
Share
Expand All
More Forum Discussions

How to Open a Chery Car Key?

There are two screws on the back cover of the car key. Use a screwdriver to remove each screw separately. After opening the back cover, you will see the battery board. Remove the old battery and install the new one. Reattach the back cover and tighten the screws to complete the process.
19
1
Share

How to Reset the Tire Pressure on Chery Jetour X70

Turn on the ignition, use the steering column switch or multifunction steering wheel buttons to navigate to the instrument cluster menu, and select the comfort system settings. Click on the tire pressure option, select pressure monitoring, and the instrument will display the tire pressure monitoring status. In the settings, choose 'Store Tire Pressure' and click confirm. After the inflation pressure is stored, the tire pressure reset is complete.
20
5
Share

How to Remove the Rear Taillight of Chery Tiggo 5x

Open the rear tailgate of the Tiggo 5X, remove the protective panel at the taillight assembly location, and unscrew the bolts securing the taillight assembly to detach the taillight cover. Then unplug the power cable connector, locate the brake light socket, rotate it counterclockwise to remove the bulb and socket, take out the old bulb, and replace it with a new one.
18
4
Share

How to adjust the high beam height of Chery Fengyun 2?

On the right side of the light switch on the center console below the steering wheel, find the adjustment switch. Find a wall about 10 meters away, turn on the headlights, and slightly adjust the switch up and down. Pay attention to the markings and adjust slowly as the response is relatively slow.
6
0
Share

How to Display Fuel Consumption on Chery Tiggo 8 Plus?

First, open the car door and power on the entire vehicle. There are two bidirectional arrow indicators on the left side of the multifunction steering wheel, which can be toggled back and forth. The fuel consumption display of Chery Tiggo 8 can be activated by pressing the button on the right side of the steering wheel. The fuel consumption is divided into average fuel consumption and instantaneous fuel consumption.
18
4
Share

How to Use the Wipers on a Chery Car?

Enter the driver's cabin to locate the vehicle's wiper control lever. Push the wiper control lever to the "O" position to turn off the wipers. Adjust the wiper control lever to the "---" position for intermittent wiper mode, and to the "LO" position for low-speed wiper mode. Set the wiper control lever to the "HI" position for high-speed wiper mode. The knob on the right controls the rear wiper switch of the vehicle.
5
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.