···
Log in / Register

Where is the VIN located on a Land Rover Range Rover?

1 Answers
DeSara
09/08/25 6:29am
The VIN (Vehicle Identification Number) of a Land Rover Range Rover is typically stamped on the front part of the right front suspension mount. You can find it by opening the hood near the engine or at the lower left corner of the windshield. It is also visible on the vehicle's registration certificate. Here are some relevant details about the Land Rover Range Rover: 1. The dimensions of the Land Rover Range Rover are 4999mm in length, 2073mm in width, and 1835mm in height, with a wheelbase of 2922mm. 2. The Land Rover Range Rover is equipped with a 3.0T twin-turbocharged engine, delivering a maximum power of 265 kW and a maximum torque of 495 Nm, paired with an 8-speed automatic transmission.
Was this review help?
12
4
Share
More Forum Discussions

How to Operate the Indicator Update?

Sell or scrap the vehicle first. Go to the traffic police vehicle management office to complete the vehicle transfer registration procedures. Apply for the update indicator after 7 working days. You can apply through the official website and regulation service window, or through self-service machines, 4S stores, etc.
6
2
Share

Which sports car has a logo similar to Wuling?

The sports car with a logo similar to Wuling is the Corvette, which is a sports car under Chevrolet. It has evolved through 8 generations, numbered from C1 to C8, consistently adopting a front-engine, rear-wheel-drive layout with two doors and two seats. The dimensions of the car are 4435mm in length, 1844mm in width, and 1245mm in height, with a wheelbase of 2685mm. It continues the design of the C5 with a front-mounted engine and rear-mounted transmission. In terms of power, the Corvette is equipped with a 6.0-liter V8 engine, delivering a maximum power of 400 horsepower and a maximum torque of 575 Nm, paired with an 8-speed dual-clutch transmission.
19
3
Share

What Are the Solutions for Mistaking the Accelerator for the Brake?

Solutions for mistaking the accelerator for the brake include: 1. Keep the heel on the ground and use the toes to press the brake or accelerator; 2. Place the foot at the same level as the brake; 3. Position the heel below the brake, press the brake straight down, and when pressing the accelerator, keep the heel stationary while tilting the toes to press the accelerator; 4. Keep the foot on the brake rather than the accelerator, so that in an emergency, pressing down directly can avoid panic-induced errors. The positions of the accelerator and brake are as follows: the accelerator is located on the far right, while the brake is in the middle. The accelerator is the car's speed control device, used to regulate speed, while the brake is the vehicle's stopping or deceleration mechanism.
1
1
Share

How to Turn on the Air Conditioning in a Volkswagen Bora?

The method to turn on the air conditioning in a Volkswagen Bora is as follows: 1. Press the AC button in the air conditioning control area to activate the air conditioning compressor for cooling; 2. The left knob in the air conditioning control area is for temperature adjustment, turning it clockwise increases the temperature, while turning it counterclockwise decreases the temperature; 3. The right knob in the air conditioning control area is for adjusting the air vent positions, including defrosting the front windshield; 4. The middle knob in the air conditioning control area is for adjusting the air flow volume. The body dimensions of the Volkswagen Bora are: length 4663mm, width 1815mm, height 1462mm, wheelbase 2688mm, fuel tank capacity 50l, trunk capacity 506l, and curb weight 1320kg.
3
1
Share

How to Perform a Complete Coolant Replacement?

Method for a complete coolant replacement: 1. Drain the fluid: Unscrew the radiator cap, open the radiator drain valve (usually located at the bottom of the car), and drain the coolant. 2. Flush the cooling system: Continuously pour clean water into the engine cooling system. During the flushing process, keep the engine idling to ensure the water circulates internally until clean water flows out from the radiator. 3. Remove residual water: Stop adding clean water, wait for it to drain completely, then close the drain valve. 4. Refill with new coolant: Add new coolant, start the car, and let it run for about 10 minutes. As some air is expelled from the cooling system, the coolant level will drop slightly. Top up with additional coolant as needed until full.
4
4
Share

When is the appropriate time for a car's first maintenance?

It is appropriate to perform the first maintenance when the car has driven 5000 kilometers or after 3 months. The first maintenance items include: 1. Changing the engine oil, oil filter, cleaning the air filter, and checking the generator belt; 2. Checking whether the levels of various fluids are normal; 3. Checking whether the tire pressure is normal and if there is any uneven wear, bulging, or damage to the tires; 4. Inspecting the car's chassis, brake pads, brake discs, connecting rods, ball joints, and CV joints for any scratches; 5. Checking whether all the switches and lights in the car are working properly. The first maintenance of a car refers to the first preventive work of inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car to eliminate hidden dangers, prevent faults, slow down the deterioration process of components, and extend the service life.
20
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.