Where is the USB port located in the 2019 Leiling?

What is the method to manually clear the ABS warning light?

Method to manually clear the ABS warning light: Locate the car's battery, remove the negative terminal, wait a few minutes, and then reconnect it. The ABS warning light should then turn off. Reasons for the ABS warning light to illuminate include: 1. The brake fluid level in the brake fluid reservoir is below the lower limit, triggering the brake fluid level indicator switch; 2. Poor contact or damage to the parking brake switch or brake fluid level indicator switch; 3. Poor contact or short circuit in the ABS warning light's wiring; 4. Fault in the ABS system's ECU or its power circuit; 5. Intermittent fault in the wheel speed sensor or its wiring; 6. Failure of the brake pressure sensor or poor contact/short circuit in its wiring; 7. Air in the conventional brake system or other faults.

16

1

Share

Where does the Erguang Expressway run from and to?

The Erguang Expressway runs from Erenhot City in Xilin Gol League, Inner Mongolia Autonomous Region, to Guangzhou City in Guangdong Province. The total length of the Erguang Expressway is 2,685 kilometers, passing through six provinces and regions: Inner Mongolia, Shanxi, Henan, Hunan, Hubei, and Guangdong. It is a major north-south transportation artery in China, facilitating information exchange and personnel movement between the north and south. Expressways are not only an important symbol of modern transportation but also a significant indicator of a country's modernization. Expressways are multi-lane roads designed exclusively for motor vehicles, with separate lanes for different directions and fully controlled access. The average annual daily traffic volume on expressways should ideally exceed 15,000 passenger car units, with a design speed ranging from 80 to 120 kilometers per hour.

18

4

Share

How Many Kilometers Should Transmission Fluid Be Changed?

Automobile transmissions mainly include manual MT transmissions, automatic AT transmissions, CVT continuously variable transmissions, and DSG transmissions. Below are the replacement intervals for each type of transmission fluid: 1. Manual MT transmission fluid is the cheapest to replace and has a relatively long replacement interval, generally usable for about 80,000 kilometers, with most models requiring approximately 3 liters. 2. AT automatic transmission fluid is typically changed every 40,000 kilometers, with the total fluid capacity being 6-8 liters. However, due to structural reasons, it usually cannot be completely replaced in one go. 3. CVT fluid is generally replaced based on the deterioration level indicated by the computer system, but it is recommended to replace CVT fluid preferably between 60,000 to 80,000 kilometers.

5

4

Share

What is the Standard for Headlight Adjustment?

Standard for Headlight Adjustment: Park the vehicle to be inspected on a level ground. Move the inspection device to the front of the vehicle, ensuring the lens surface of the device is (30±5) cm away from the headlight's diffuser lens. Adjust the height of the device box to match the height of the headlight center from the ground. Below are the standard steps for headlight adjustment: 1. Inspection and adjustment of beam direction: Turn on the low beam of the headlight to be inspected. The beam passes through the lens of the device box and projects onto the screen inside the box. Visually observe through the viewing window and rotate the beam direction selection knob until the horizontal segment of the cutoff line (i.e., the light pattern) aligns with the solid line on the screen. 2. Inspection and adjustment of beam intensity: After verifying the low beam direction, press the low beam button to inspect the luminosity of the dark area. The device sets the maximum luminosity of the dark area at 625cd. Values below this are in the green zone (pass), while values exceeding it are in the red zone (fail).

3

5

Share

What do the letters on tires represent?

Tires generally have two letters, the first letter represents the tire type, and the second letter represents the maximum speed the tire is allowed to reach. Taking the tire specification 245/45R1896Y as an example: 1. 45: Represents the aspect ratio of the tire. This value usually ranges between 30-80, with a lower number indicating a thinner sidewall. 2. R: Indicates the type of tire. 'R' and 'Z' represent radial tires, 'X' represents high-pressure tires, and '-' represents low-pressure tires. 3. 18: Indicates the wheel size the tire is suitable for. The number 18 means this tire is suitable for wheels with a diameter of 18. 4. 96: Represents the maximum load a single tire can bear. The higher the number, the greater the load the tire can withstand. 5. Y: The so-called speed rating, which is the maximum speed the tire is allowed to reach. Different numbers represent different speed levels. Exceeding the maximum speed of the tire may lead to dangers such as a blowout.

14

1

Share

Can I skip the scheduled Subject 1 exam?

Failure to attend the scheduled Subject 1 exam will be considered as voluntary abandonment and treated as a failing grade. Below are specific details about Subject 1: Consequences of absence: According to Article 36 of the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses" (Ministry of Public Security Order No. 123), applicants who cannot attend the exam at the scheduled time must apply to cancel the appointment one day in advance. If an applicant fails to attend the exam at the scheduled time without prior cancellation, the exam will be marked as a failure. Missing the exam after successful scheduling counts as abandonment, which is treated as a failing grade. You can reschedule the exam, but you will need to pay a retake fee. There is no limit to the number of retakes for Subject 1, so there's no need to worry about it, except for the retake fee. Introduction to Subject 1: The exam content includes the most basic knowledge of driving theory, road safety laws and regulations, traffic signals, traffic rules, and local regulations. The scheduling of the driver's theory exam is arranged by local vehicle management offices. Subject 1 is part of the teaching and examination outline for motor vehicle driver training. This outline divides the examination into three subjects, organized by the traffic management departments of public security authorities. The exams proceed in the order of Subject 1, Subject 2, and Subject 3. Passing the previous subject allows you to proceed to the next; failing the previous subject requires continuing with the next subject's exam.

14

0

Share

Where is the USB port located in the 2019 Leiling?

What is the method to manually clear the ABS warning light?

Where does the Erguang Expressway run from and to?

How Many Kilometers Should Transmission Fluid Be Changed?

What is the Standard for Headlight Adjustment?

What do the letters on tires represent?

Can I skip the scheduled Subject 1 exam?

When is the National Day highway toll-free period?

How to Report Traffic Violations?

What is the Volkswagen with letters?

How often should wheel alignment be done?