Where is the trunk switch on the 2019 Bora?

2 Answers
Peter
07/29/25 4:09am
The 2019 Bora does not have a trunk switch. There are two ways to open the trunk: 1. The driver stands outside the car and presses the button on the key to open the trunk; 2. If the doors are unlocked, the driver can stand near the trunk and lift it open by hand. The dimensions of the 2019 Bora are 4663 mm in length, 1815 mm in width, and 1462 mm in height, with a wheelbase of 2688 mm. The 2019 Bora features front-wheel drive, a front MacPherson strut independent suspension, a rear torsion beam non-independent suspension, and a unibody structure.
Was this review help?
20
3
Share
SabrinaDella
08/12/25 7:54am
On the 2019 Volkswagen Bora, the trunk switch is conveniently located in several places. Having driven this car several times, I can confirm there's a small button on the driver's door panel near the window switch with a luggage compartment icon - pressing it opens the tailgate. The key fob also has a trunk release button; just hold it down for two seconds. Sometimes there's a small button at the lower right corner of the exterior trunk lid that can open it when pressed. Remember to open the trunk after parking to avoid shifting items; if the key battery dies, use the manual lock cylinder to turn and open. During maintenance, check if the buttons are stuck due to dust accumulation - a simple cleaning should fix it.
Was this review help?
15
1
Share
Expand All
More Forum Discussions

Does the Volkswagen Tayron have a 7-seater option?

Volkswagen will launch a new large 7-seater SUV in the European market. Here are the specific details: 1. Vehicle introduction: According to FAW-Volkswagen's plan, it will later produce a B-main SUV at its Changchun base. It is expected that this model will be the same as the 7-seater SUV launched by Volkswagen in Europe and can be regarded as the 7-seater version of the Tayron. Currently, the entire Volkswagen brand has a gap in the 4.8-4.9 meter 7-seater SUV segment. After the launch of this B-main SUV, it will compete with mid-size 7-seater SUVs such as the Toyota Highlander and Ford Edge. 2. Dual-clutch transmission: The FAW-Volkswagen B-main SUV is built on the MQB B platform, with dimensions between the Tayron and B-SMV, and is relatively close to the SAIC Volkswagen Teramont X. In terms of power, the new car is equipped with a 2.0T high/low-power turbocharged engine, and the transmission system is a 7-speed dual-clutch transmission.
17
1
Share

What Does It Mean When the Elantra's Engine Warning Light Comes On?

The engine warning light may illuminate for the following 7 main reasons: Sensor malfunction: The sensors in question include those for coolant temperature, crankshaft position, air flow, intake air temperature, oxygen, etc. When these sensors are damaged, have poor connections, or their signals are interrupted, the vehicle's ECU cannot accurately obtain engine data, which can trigger the engine warning light. Fuel or oil quality issues: Failure to use the fuel or engine oil as specified by the manufacturer may cause engine wear, leading to the warning light illuminating. Poor combustion of the air-fuel mixture: Poor combustion can result in engine carbon buildup or knocking. Once detected by the oxygen sensor and reported to the ECU, the warning light will come on as an alert. Spark plug failure, ignition coil failure, fuel pump failure, or clogged fuel lines can all cause poor combustion of the air-fuel mixture. Turbocharger issues: Problems with the intake boost piping or turbocharger can also trigger the engine warning light. The most common issue is turbocharger damage, often accompanied by symptoms such as oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If the vehicle's intake system is compromised, it may lead to clogged engine piping, and in severe cases, the engine warning light will illuminate. A dirty or uncleaned air filter can cause intake problems. Exhaust problems: Exhaust system faults can also cause the engine warning light to come on. Common causes include issues with the rear oxygen sensor, catalytic converter, exhaust camshaft, or bearings, with the catalytic converter being the most frequent culprit. The use of leaded gasoline, lead- or silicon-based lubricant additives, physical damage to the catalytic converter, or faults in the engine's fuel supply system can all lead to catalytic converter failure. Anti-theft system malfunction: If the vehicle's electronic anti-theft system malfunctions, or if the anti-theft controller is incompatible with the engine's electronic controller, the anti-theft system can prevent the engine from operating normally, accompanied by the illumination of the engine warning light. If the engine warning light comes on, follow these steps: First, check if the engine is running normally and whether there are any issues such as shaking or smoke. If so, avoid restarting the engine. Note: Do not restart the engine if the red warning light is on. If the engine can be started, turn it off and wait 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the 'on' position without depressing the clutch. The vehicle will enter self-diagnosis mode upon powering up. Wait 5-10 seconds to see if the warning light turns off. If the warning light remains on, visit a service center as soon as possible. Technicians can use a portable diagnostic tool to read the fault codes, identify the issue, and perform targeted repairs.
1
5
Share

What is the wading depth of the Audi A6L?

The maximum wading depth of the Audi A6L is approximately 600mm. The wading depth of the Audi A6L is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, SUVs and off-road vehicles have obvious advantages. However, for most compact and small cars with low ground clearance, the position of the vehicle's air intake should be used as a benchmark when driving through waterlogged roads. If the air intake of the Audi A6L is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it can cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the air intake, and thus the maximum wading depth, can be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in the water, which could cause severe damage due to water intake. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, or reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, avoid entering the water and choose an alternative route.
12
3
Share

What is the appropriate freezing point for antifreeze?

Antifreeze generally has a freezing point of -35 degrees Celsius. Additional information: The functions of antifreeze are as follows: In cold weather, it prevents parts from system failures or cracking due to cooling issues. It also manages rust prevention and prevents excessive scale buildup that can lead to pipe blockages, offering functions such as anti-corrosion, anti-scale, anti-boil, anti-freeze, and anti-rust. Below are precautions when using antifreeze: 1. Try to use the same brand of antifreeze: Different brands of antifreeze use different metal corrosion inhibitors, so they should not be mixed. 2. The validity period of antifreeze is mostly two years: When adding, ensure the product is within its validity period. When replacing, drain the old fluid completely, clean the cooling system thoroughly, and then add the new fluid. 3. Avoid diluting with water: Traditional inorganic antifreeze should not be diluted with water, as it can produce sediment, severely affecting its normal functions. Organic antifreeze can be diluted with water but not excessively. 4. For vehicles using antifreeze, never directly add tap water; instead, use distilled or deionized water.
15
5
Share

Where is the USB port located on the Audi A6L?

The USB port of the Audi A6L is located inside the center armrest. Below is some related information about the Audi A6L: 1. Introduction: The Audi A6L was the first Audi model to enter the Chinese market, with its predecessor being the third-generation Audi 100 (code C3) introduced in 1988. The Audi A6L is a series developed by FAW-Volkswagen Audi based on the German new A6, serving as the successor to the A6. In June 2012, the new-generation Audi A6L was launched, equipped with a 35-TFSI powertrain, and its exterior design somewhat resembled the new version of the A4L. 2. Design: The new Audi A6L features a five-link front suspension design, balancing the necessary rigid connection for sportiness and comfort with low static stiffness. Among these, the hydraulic frame damping support significantly enhances driving comfort and effectively reduces the impact and jolt when passing over speed bumps or uneven road surfaces, thereby minimizing the impact on the lumbar spine.
18
3
Share

What does it mean when a Volkswagen displays tire pressure loss?

When a Volkswagen displays tire pressure loss, it means that one or more of the vehicle's four tires is in a state of low pressure. You need to use a tire pressure gauge to measure the pressure of all four tires and check if the pressure values are within the specified range. If they are not, you should inflate them to the required level. The standard tire pressure value can usually be found on the fuel tank cap or near the vehicle's B-pillar. Low tire pressure: If no damage is visible, you can simply inflate the tire to the normal pressure and reset the tire pressure system. If you find that the tire has been punctured during inspection, you should drive to a tire shop promptly for a repair and then reinflate the tire. If the tire pressure warning reappears some time after inflation, but there is no puncture, it may be due to air leakage caused by a deformed wheel rim. It is recommended to check the wheel rim and replace it if necessary. Hazards of low tire pressure: Increased friction coefficient with the road surface, leading to higher fuel consumption; causes the steering wheel to feel heavy and may lead to drifting, which are factors detrimental to driving safety; increases the movement of various parts of the tire, resulting in abnormal heat due to excessive rolling.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.