Where is the trunk switch of Volkswagen Bora?

1 Answers
RachelAnn
07/29/25 8:27pm
The trunk switch of the Volkswagen Bora is located on the main driver's door, and pressing it can open the trunk lid; there is also a button on the remote key that can open the trunk lid. The Bora is a compact sedan under the Volkswagen brand. In terms of body dimensions, the car has a length of 4663 mm, a width of 1815 mm, a height of 1462 mm, and a wheelbase of 2688 mm. In terms of power, the Bora is equipped with three engines: a 1.5-liter naturally aspirated engine, a 1.2-liter turbocharged engine, and a 1.4-liter turbocharged engine. The 1.5-liter naturally aspirated engine has a maximum power of 83 kW and a maximum torque of 145 Nm; the 1.2-liter turbocharged engine has a maximum power of 85 kW and a maximum torque of 200 Nm; the 1.4-liter turbocharged engine has a maximum power of 110 kW and a maximum torque of 250 Nm.
Was this review help?
19
3
Share
More Forum Discussions

How to replace the key battery of Zotye T300?

Detailed steps for replacing the battery of Zotye T300 key are as follows: 1. Press the rectangular button on the lower part of the key's front side to remove the silver mechanical key. 2. Use the mechanical key or a screwdriver to pry open the middle seam, then locate the circuit board and the button battery. 3. Remove the old button battery, replace it with a new one, and reassemble the key in the reverse order. 4. After replacing the battery, check to ensure all functions of the key are working properly. If not, timely repair is needed. 5. Note: If the indicator light on the key becomes dimmer or flickers, it indicates low battery power and requires immediate replacement.
6
3
Share

How to Check if Your Car is Lacking Antifreeze?

Methods to check if your vehicle is lacking antifreeze: 1. Observe the antifreeze warning light on the dashboard. If it lights up, it is likely due to a lack of antifreeze, though it could also be caused by excessive cylinder temperature. 2. Check the antifreeze reservoir. If the fluid level is below the minimum mark (MIN), do not continue driving and add antifreeze promptly. 3. Inspect the water level marks on the antifreeze bottle. The antifreeze level should normally be between the maximum and minimum marks. To determine if antifreeze is lacking, check these marks. If the antifreeze is below the minimum mark, it indicates a deficiency.
5
4
Share

Should You Depress the Clutch When Turning a Vehicle?

You should not depress the clutch when turning a vehicle, as this action will accelerate clutch wear. If the vehicle speed is too slow for the current gear, you can downshift instead of continuously depressing the clutch or riding the clutch. The clutch is located within the flywheel housing between the engine and the transmission, with the clutch assembly secured to the rear plane of the flywheel by screws. The output shaft of the clutch is the input shaft of the transmission. During driving, the driver can depress or release the clutch pedal as needed to temporarily separate or gradually engage the engine and transmission, thereby cutting off or transmitting the engine's power to the transmission.
20
4
Share

Can You Park on the Emergency Lane of a Highway?

Non-emergency vehicles are not allowed to park on the emergency lane of a highway. The regulations regarding highway emergency lanes are as follows: 1. According to Article 82 of the Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China, motor vehicles are prohibited from driving or parking on the emergency lane of a highway under non-emergency circumstances. 2. The emergency lane on a highway is reserved for emergency vehicles only, including police cars, fire trucks, ambulances, and engineering rescue vehicles when performing urgent tasks. Additionally, vehicles that experience sudden malfunctions and cannot operate normally, or vehicles with passengers suffering from sudden illnesses, may use the emergency lane. Other vehicles are prohibited from parking or driving on the emergency lane under non-emergency conditions. 3. Illegally occupying the emergency lane poses significant risks, especially during peak periods. In the event of a traffic accident, rescue forces may be unable to reach the scene promptly, accident vehicles may not be cleared quickly, and congestion may not be resolved immediately, directly affecting the life-saving treatment of injured parties.
2
0
Share

What Causes High Engine RPM in Cars?

The reasons for high engine RPM in cars are: 1. Fault in the intake system, sudden increase in throttle opening; 2. Insufficient cylinder pressure, check for piston ring and piston wear; 3. Issues with engine oil; 4. Slippage or damage to the air conditioning clutch, causing the engine to suddenly lose load and RPM to increase; 5. Forced downshift by the transmission computer or internal transmission failure; 6. Insufficient engine power output. The level of engine RPM relates to the number of work cycles per unit time or the effective power of the engine, meaning the effective power of the engine varies with different RPM levels. During idle, the engine RPM typically reaches around 700 RPM per minute, and during normal operation, it can reach up to 3000 RPM per minute.
9
2
Share

What to Do When the Power Steering Warning Light Comes On?

Solutions for the power steering warning light coming on: 1. Check the steering gear, steering pump control valve, oil cup filter, steering fluid, and clean the entire power steering system; 2. Check the tire pressure and replenish if necessary; 3. Inspect all connection points of the oil pipes and tighten all connecting bolts; 4. Replace the oil pipe, power steering pump, or power steering gear. Reasons for the power steering warning light coming on: 1. The power steering system contains a large amount of air, causing abnormal car steering; 2. Foreign objects in the steering hydraulic pipeline causing the steering pump flow control valve to stick; 3. Loose connections in the power steering system leading to steering fluid leakage; 4. Excessive wear of the steering gear piston cylinder, poor oil seal sealing, or control valve sticking or damage.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.