Where is the trunk switch located on the Cadillac XT4?

1 Answers
McDamian
07/30/25 4:33am
The trunk switch of the Cadillac XT4 is located below the driver's door, and pressing the button will open the trunk. The luggage compartment volume is 447-1334 liters (depending on the tilt of the rear seats). Other ways to open the Cadillac XT4 trunk: Use the car key to open the trunk. Press and hold the trunk unlock button on the key, and the trunk will automatically open after a few seconds; Press the unlock button to unlock the doors, then pull the trunk release button below the license plate frame to open the trunk. Ensure the trunk is properly closed before driving, as the trunk may suddenly open if it is not engaged properly even when the door locks are locked, which is a safety hazard during driving. Moreover, when the trunk lid is open, it can cause exhaust fumes to enter the vehicle, affecting the health of the driver and passengers.
Was this review help?
18
0
Share
More Forum Discussions

Does the Honda URV comply with China 6 emission standards?

Dongfeng Honda URV complies with China 6 emission standards. Below are the details about Dongfeng Honda URV and China 6 standards: Dongfeng Honda URV: It is a mid-size SUV with body dimensions of 4856mm in length, 1942mm in width, and 1670mm in height. It has a wheelbase of 2820mm, front track of 1652mm, rear track of 1671mm, fuel tank capacity of 57 liters, trunk capacity of 486 liters, and a curb weight of 1745kg. The 2020 Dongfeng Honda URV is equipped with a 1.5T turbocharged engine delivering a maximum horsepower of 193PS, maximum power of 142kW, and maximum torque of 243Nm, paired with a CVT continuously variable transmission. China 6: China 6 generally refers to the National Phase 6 Motor Vehicle Pollutant Emission Standards.
13
3
Share

What is the maximum number of points that can be added or deducted from a driver's license?

Up to 6 points can be added, while a maximum of 12 points can be deducted. Here are the specific details: 1. Regulations: This point addition system is currently only implemented in certain regions, such as Guangzhou, where car owners can report other drivers' traffic violations to add points to their own driver's license. However, it's important to note that each person can only report other drivers' violations a maximum of 5 times per year; the maximum number of points that can be added per person per year is 15, and these points cannot be combined with the 12 points in the scoring cycle. 2. Driver's License: The scoring cycle is 12 points. If all 12 points are deducted, the driver must undergo further training and pass an exam. Currently, the driver's license implements a point addition system, meaning that the scoring cycle for a driver's license is no longer limited to just 12 points.
5
2
Share

What is the Function of the Drive Axle?

Drive axle serves to alter the direction of power transmission and reduce rotational speed. Below are details about the drive axle: Components of the drive axle: The drive axle consists of the main reducer, differential, half-shafts, and drive axle housing. Specific functions of the drive axle: Located at the end of the power transmission system, the fundamental role of the drive axle is to transmit the engine torque from the universal transmission to the driving wheels via the main reducer, differential, and half-shafts, achieving speed reduction and torque increase. It changes the direction of torque transmission through the bevel gear pair of the main reducer, enables differential action between the two wheels via the differential to ensure inner and outer wheels turn at different speeds, and supports loads and transmits torque through the axle housing and wheels.
3
1
Share

What are the functions of the Mercedes-Benz GLK center console?

Here is an introduction to the functions of the Mercedes-Benz GLK center console: 1. Power on/off and volume adjustment buttons: Press once to turn on; press again to turn off. Rotate right to increase volume; rotate left to decrease volume. 2. Disc eject/insert button: When powered off, press briefly to eject the disc; press briefly again to insert the disc. In RADIO or USB mode, press briefly to eject the disc; press briefly again to insert and play the CD. 3. Mute button: Press briefly to enable mute; press briefly again to disable mute. 4. Sound effect menu selection button: Press briefly to enter the sound effect menu. Continuously pressing the button will cycle through the options in order.
19
4
Share

What are the trunk dimensions of the 2016 Bora?

The trunk dimensions of the Volkswagen Bora are as follows: height is 580mm, minimum depth ranges from 1050mm to 1920mm, maximum depth ranges from 1040mm to 1510mm, and minimum width ranges from 1040mm to 1510mm. The official trunk volume is 506 liters, which is quite good and ranks above average in its class. Below is some related information about the Bora: 1. Brand Introduction: The Bora is FAW-Volkswagen's first independently designed model, hailed as a car that 'inherits and surpasses the classics.' 2. Model Introduction: The Bora features a stable and elegant exterior, a long wheelbase, reasonable space, and exquisite interior. 3. Car Introduction: The Bora is robust, sleek, and stylish, with powerful performance and a comfortable driving experience that reflects its rich connotation. The perfectly designed control system allows for effortless driving pleasure. Its superior quality, comprehensive safety features, and advanced technology let you enjoy the thrill of driving with ease and control.
4
0
Share

How long after window tinting can ETC be installed?

Generally, you need to wait about a week after window tinting, until the moisture inside the tint has completely evaporated, before installing ETC. The ETC installation process is as follows: Upon receiving the device, first check whether the ETC card and electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU, and the red light will briefly illuminate. The OLED screen will display "Tag Invalid" or "Please Insert Card," indicating that the device is functioning normally. Clean the front windshield to ensure the glass surface is smooth, clean, and dry. Then peel off the adhesive backing of the OBU and attach it to the installation position. Press firmly for 2-3 minutes to remove any air bubbles. Insert the ETC card with the front facing the driver and the back facing the windshield, ensuring the chip is properly inserted into the OBU device.
10
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.