Where is the transmission oil filler screw of Baojun 630 located?
2 Answers
The transmission oil filler screw of Baojun 630 is located at the bottom of the transmission. Precautions for using the screw: Do not overtighten the screw, as excessive tightening may cause the screw to strip. The torque for the engine oil drain bolt is 35Nm; tighten it just enough to prevent oil leakage. If overtightened, the screw may strip, leading to oil leakage. In severe cases, overtightening may cause the screw to break, necessitating replacement of the oil pan to resolve the issue. Precautions when adding transmission oil: It is recommended to use the original ATF (Automatic Transmission Fluid). Do not mix or use incorrect ATF. Use the ATF type specified in the vehicle maintenance manual. Different ATF types have different friction coefficients. Some car manufacturers design specific oils based on the technical specifications of the vehicle's transmission. Using the correct oil helps maintain the transmission's mechanical performance and prolong its lifespan.
I remember last time helping a friend locate the filler plug for the Baojun 630 manual transmission - it was tucked away on the left side of the gearbox, around the middle-rear section. You'll need to either remove the left front wheel or jack up the car and peel back the inner fender liner to get a clear view. This plug usually takes a hex key and sits close to the axle area. Since older cars accumulate grime, it's best to spray some carburetor cleaner to degrease before attempting removal, otherwise your wrench might slip and strip the bolt head. Before removing, locate the inspection hole plug first - it's positioned slightly higher, don't mix up these two screws. Use a dedicated funnel when refilling transmission fluid to avoid spilling all over the undercarriage. After replacement, remember to check the fluid level again when the engine is warm to ensure no overflow, as overfilling can cause transmission distress.
