···
Log in / Register

Where is the transmission oil filler port of Changan CS35?

3 Answers
VonSara
07/29/25 5:36pm
The transmission oil filler port of Changan CS35 is located in the engine compartment. Below are detailed introductions about the transmission oil filler port of Changan CS35: 1. The official user manual recommends changing the transmission oil every 50,000 kilometers or every three years. 2. The transmission mainly refers to the car's gearbox. It is divided into manual and automatic types. The manual transmission mainly consists of gears and shafts, achieving speed and torque changes through different gear combinations. The automatic transmission (AT) is composed of a torque converter, planetary gears, and a hydraulic control system, achieving speed and torque changes through hydraulic transmission and gear combinations. 3. There are two oil ports on the transmission. The lowest one is the drain port, and the higher one is the filler port, which can only be seen when the car is lifted. Generally, unless the automatic transmission is overhauled, the oil inside cannot be completely extracted. Therefore, during replacement, usually only 70-80% can be replaced, requiring about 4 liters of oil. Transmission oils of different brands should not be mixed.
Was this review help?
13
5
Share
DiCaden
08/14/25 8:50am
I remember when I last changed the transmission fluid for my Changan CS35 myself, I found that its filler port is usually located on the side of the transmission near the chassis, typically a labeled plastic or metal plug, positioned below the engine compartment. You'll need to lift the vehicle or use a pit, otherwise, you won't find it. For most CS35 models, it's near the drive shaft when viewed from underneath. Be careful to avoid dust entering the oil port during the operation, and it's recommended to buy professional transmission fluid and filling tools. I also noticed that if the fluid level is low, the car will shift poorly, and long-term neglect of fluid changes may lead to wear. The method to check the fluid level is to measure the cold and hot fluid with a ruler, just keep it level. Regular maintenance can save a lot of money, after all, the transmission is the heart of the car—don't skimp and add random fluids.
Was this review help?
13
4
Share
Expand All
ColtonRose
10/13/25 7:53am
For DIY car enthusiasts, locating the transmission oil filler port on the Changan CS35 is actually quite simple: It's positioned on the upper side of the transmission housing, typically as a bolt-type plug. The exact location can vary—newer models might have it towards the rear of the engine bay, while older versions may place it closer to the bottom. I always keep a flashlight or phone light handy to peek underneath. Before starting, ensure the engine is off and cooled to avoid burns. Also, pay attention to oil compatibility—using OEM-approved ATF fluid is recommended. After refilling, check for leaks, as loosening the plug can sometimes cause issues. If you can't find it, consult the owner's manual or search for reference images online to avoid damaging wiring harnesses. Make it a habit to check every 50,000 kilometers to prevent transmission rust.
Was this review help?
17
0
Share
Expand All
More Forum Discussions

Where is the fuse box of the Volkswagen Lavida located?

The fuse box of the Volkswagen Lavida is located inside the instrument panel cover on the left side of the driver's seat. When replacing fuses, the following aspects need to be noted: 1. Turn off the ignition switch, lights, and all electrical appliances. There is a card and a fuse clip on the back of the removed cover, which can be used to remove the damaged fuse. 2. The fuse box has a white card indicating the positions of the fuses corresponding to various electrical appliances. The card can be removed. The front side of the card corresponds to the upper part of the fuse socket, and the back side corresponds to the lower part. When replacing fuses, always refer to this reference table to determine the name and function of each fuse to avoid incorrect replacement. 3. Use the clip to remove the relevant fuse. If the fuse is blown, only replace it with a new fuse of the same current rating and size. The Lavida uses blade-type fuses, which are commonly used in many vehicle models. They can be purchased at regular auto parts stores. Finally, use the clip to hold the new fuse and insert it into the correct position. After installation, remember to return the card and clip to their original places.
16
4
Share

How to Remove the Nissan Tiida Evaporator?

Steps to remove the Nissan Tiida evaporator are as follows: 1. Prepare a bottle of automotive air conditioning cleaner and an air filter. Tools required: one 5.5mm socket wrench and one Phillips screwdriver. 2. Since automotive air conditioning cleaners come with instructions, focus on removing and installing the air filter and dismantling the glove box. 3. Start with the bottom two of the five screws, then proceed to the top three. It's advisable to support the glove box with your hand or leg during removal to prevent excessive force on the screw holes that could cause deformation. 4. To remove the air filter, first locate the plastic cover panel under the front passenger side. Use a 5.5mm hex socket wrench to unscrew the three screws and remove the dirty filter. Then replace the plastic cover panel and secure it with screws. Normally, the car's evaporator should be cleaned before and after summer use. However, if there are issues like mold, it's advisable to clean it earlier to ensure proper cooling. There are various methods to clean the evaporator. If opting for disassembly cleaning, it's essential to visit a professional auto repair shop due to the high cost and technical nature of the process, which could easily damage other components. DIY disassembly cleaning is not recommended.
9
1
Share

How to Replace the Taillight of a Teana?

The steps to replace the rear taillight of a Teana car are as follows: 1. Open the trunk. 2. Remove the trunk's inner lining. After opening the trunk, first remove the inner lining on the side of the taillight. The lining is secured with several plastic clips. Use a small flathead screwdriver to gently pry these clips open, then pull the lining aside by hand. Be careful to pry gently to avoid damaging the plastic clips. 3. Remove the nuts securing the taillight. There are three nuts securing the rear taillight. Use a small ratchet with an 8mm socket to remove each of the three nuts one by one and set them aside. 4. Disconnect the taillight wiring harness. The taillight wiring harness has only one plug. Simply pull this plug out by hand. If it's difficult to remove, gently pry it with a small flathead screwdriver. 5. Replace the taillight. After disconnecting the wiring harness, hold both sides of the taillight with your hands and gently pull outward while slightly shaking it. This will allow you to remove the taillight. Be careful not to use excessive force.
10
2
Share

Where is the Citroen Air Filter Located?

The Citroen air filter is located inside the glove compartment on the passenger side. After removing the glove compartment, you can see the air filter. The main function of the car air filter is to separate solid impurities such as dust, pollen, and grinding particles from the air, ensuring that passengers and drivers do not experience allergic reactions that could affect driving safety. The specific functions of the air filter are as follows: 1. Ensure the air filter fits tightly against the housing, preventing unfiltered air from entering the cabin. 2. Separate solid impurities such as dust, pollen, and grinding particles from the air. 3. Adsorb moisture, soot, ozone, odors, carbon oxides, SO2, CO2, etc., from the air, with strong and long-lasting adsorption capabilities. 4. Prevent the car windows from fogging up, ensuring clear visibility for drivers and passengers and safe driving. 5. Provide fresh air to the cabin, preventing occupants from inhaling harmful gases and ensuring driving safety. 6. Maintain clean air in the cabin, preventing bacterial growth and creating a healthy environment. 7. Effectively separate solid impurities such as dust, core powder, and grinding particles from the air. 8. Effectively intercept pollen, ensuring that passengers and drivers do not experience allergic reactions that could affect driving safety.
6
5
Share

What is the brand of the transmission in the Haima S5?

Haima S5's transmission is a self-developed brand by Haima. The transmission model of the Haima S5 is VT3, with a maximum torque load of 220 Nm at 2200 rpm and a maximum power of 122 kW at 5700 rpm. The transmission comes in two types: manual and automatic. The manual transmission mainly consists of gears and shafts, achieving speed and torque changes through different gear combinations. The automatic transmission (AT) is composed of a torque converter, planetary gears, a hydraulic torque variation system, and a hydraulic control system.
17
5
Share

How to Identify the Production Date of a Seat Belt?

There is a label on the car seat belt that indicates the production date of the seat belt. More information about car seat belts is as follows: 1. A car seat belt is a device used in vehicles to ensure the safety of passengers and the driver by preventing them from being injured by the deployment of airbags when the vehicle body is subjected to a violent impact. 2. To prevent serious injuries in the event of a collision, public security departments require drivers of small passenger vehicles and front-seat passengers to use seat belts. In the event of a traffic accident, the seat belt acts as a buffer to prevent secondary injuries.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.