Where is the towing hook located on the Honda CR-V?
3 Answers
The front towing hook of the Honda CR-V is usually hidden. Typically, there is a cover on the front bumper that can be opened to install the towing hook. The rear towing hook of the Honda CR-V is located under the floor in the trunk, next to the spare tire. To use it, you need to screw it into the threaded hole on the rear underside of the vehicle. The positions of the front and rear towing hooks are as follows: 1. There is a towing hook on the bumper, covered by a cap that can be opened for use. 2. Current trucks are not allowed to tow, so the centrally located rear towing hook has been removed. However, for rescue purposes, two horn-shaped towing hooks are installed at both the front and rear ends of the frame. 3. With improved road conditions and fewer rescue incidents, modern trucks often only have one simple towing hook installed at the front and rear of the frame, which is sufficient.
That day, I drove my Honda CR-V to a picnic and wanted to help a friend tow a small trailer, only to discover its cleverly hidden tow hook. Right under the rear bumper, there's a square plastic cover that pops open with a gentle push, revealing the mounting point—just screw the hook directly onto it. The front location is even easier to find, situated below the license plate with a similar cover. Once installed, it feels incredibly sturdy. The CR-V's towing design is quite thoughtful, capable of handling several hundred pounds without issue, but be careful not to exceed the vehicle's weight limit. These spots are easily overlooked during daily driving, so it's good to occasionally check if the covers are intact to avoid issues when needed. Overall, the hooks are positioned at the lowest points front and rear, making operation simple and safe.
As a car enthusiast, I find the tow hook placement design on the Honda CR-V very practical. There's one at the rear right below the center of the bumper and another at the front adjacent to the bottom of the license plate, each covered by a small access panel. Simply pry open the panel with a key or flat tool to reveal the threaded hole for screwing in the tow hook. When installing, ensure proper thread alignment to prevent slippage. The CR-V has moderate towing capacity, easily handling camping gear or small boats. Keep the panels clean to prevent dirt from clogging the holes. Both front and rear positions allow quick deployment when towing is needed, but avoid leaving hooks exposed long-term to prevent corrosion and rust.
