Where is the tire pressure reset button on the 2018 Land Cruiser?

1 Answers
ZoeyLee
07/30/25 1:37am
The tire pressure reset button on the 2018 Land Cruiser is located next to the steering wheel hood switch. Press and hold it to reset. The 2018 Land Cruiser is a mid-to-large-sized SUV with the following dimensions: length 5095mm, width 1970mm, height 1930mm, wheelbase 2850mm, fuel tank capacity 138L, and tire size 285/60R18. It is equipped with a 4.0L naturally aspirated engine, producing a maximum torque of 376Nm at 3800rpm, paired with a 6-speed automatic transmission.
Was this review help?
5
0
Share
More Forum Discussions

How to Check if the Battery Has Power?

Methods to check if the battery has power: 1. Check the battery's charge indicator. A green indicator means the battery is fully charged, a black indicator indicates insufficient charge, and a colorless or light yellow indicator means the battery is nearly depleted. 2. Measure the battery's static voltage. If the voltage is below 11.5V, it indicates the battery is low on power. If the voltage is below 10.9V, it means the battery is almost completely discharged. When installing a battery in a vehicle, always connect the positive terminal first, followed by the ground terminal. When removing the battery from the vehicle, reverse the steps to prevent potential damage to the battery in case the wrench accidentally grounds.
1
5
Share

Is the Landwind X7 a domestic car?

The Landwind X7 is a domestic car with a body length of 4421mm, width of 1911mm, height of 1631mm, and a wheelbase of 2660mm. The dashboard features a three-color combination scheme and is equipped with a 1.5T engine. The Landwind X7 is a vehicle from the Landwind brand, codenamed E32. It comes with features such as one-key engine start, snow driving mode, sport mode, front radar, electronic parking brake, automatic air conditioning, Bluetooth phone, and navigation system. The minimum ground clearance is 168mm, and it is paired with an 8-speed automatic transmission.
13
2
Share

Should the Oil Filter Be Replaced During an Oil Change?

When changing the engine oil, it is necessary to replace the oil filter as well. The oil filter is designed to remove impurities, metal particles, sludge, and other contaminants from the oil, ensuring that the filtered oil remains clean. This helps extend the lifespan of both the oil and the engine. If the oil filter is not replaced during an oil change, the new oil will become contaminated as it passes through the old filter, which still contains trapped dirt and debris. Over time, a neglected oil filter will lose its filtering efficiency, becoming virtually ineffective. Prolonged use of a dirty filter can accelerate wear and tear on internal engine components and, in severe cases, lead to oil burning issues.
11
5
Share

Where is the tire pressure reset button located on the Baojun e100?

The tire pressure reset button on the Baojun e100 is located on the center console, marked with the letters "SET". Below is some related information: 1. Tire Pressure Monitoring System: This is a type of active safety device that can alert the driver in a timely manner when there are signs of danger in the tires, prompting the driver to take appropriate measures to avoid serious accidents. 2. Tire Pressure Monitoring Device: This system uses pressure sensors installed in each tire to directly measure the tire pressure. It then transmits the pressure information wirelessly from inside the tire to a central receiver module, which displays the tire pressure data for each tire. The system will automatically alert the driver if the tire pressure is too low or if there is a leak.
13
3
Share

How to bleed the coolant in an Audi A6?

Audi A6 coolant bleeding method is: 1. There is an iron water pipe on the engine with a bleed screw. Unscrew it when adding coolant until water comes out; 2. Bleed at the heater upper hose in the drainage channel. There is a bleed port on the hose. When bleeding, the coolant reservoir must be removed from its mounting bracket, and the coolant level in the reservoir must be higher than the heater upper hose. The Audi A6 is a luxury car produced by Audi, with body dimensions of 4886mm in length, 1810mm in width, and 1475mm in height. In terms of appearance, the radiator and intake grille on the front of the Audi A6, which were originally separated by the front bumper, have been integrated into a complete trapezoidal grille.
3
0
Share

Why is the Supra called the Bull Demon King?

Toyota Supra has outstanding power among its peers, with excellent acceleration performance, so many people simply call it the Bull Demon King. More information about Toyota Supra is as follows: 1. Exterior: The car's appearance is very close to the 2014 FT-1 concept car, but the formula racing-style nose has been modified to be more low-key. The car retains the FT-1's dual-bubble roof. Especially when the rearview mirrors are folded, it's hard to see the visual similarities between the new Supra and the BMW Z4. 2. Configuration: The car will be equipped with BMW's turbocharged 4-cylinder and 6-cylinder engines, with power and torque ranging from 145kW/320Nm to 250kW/500Nm. Both the new Supra and BMW Z4 will be produced at Magna Steyr's production line in Hungary.
1
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.