Where is the tire pressure reset button for Vios?

2 Answers
EzraMarie
09/07/25 7:21am
The tire pressure reset button for the 2020 Vios is located in front of the gear lever. First, restore the tire pressure to the normal level, start the vehicle, and then press and hold the SET button for tire pressure reset. The SET button is the black button in the center of the dashboard. Hold it until the tire pressure data refreshes and the tire pressure warning light on the dashboard disappears, indicating a successful tire pressure reset for the Vios. Related information is as follows: Tire pressure reset is the operation of resetting the tire pressure monitoring system after the tire pressure fault has been resolved. Cornering stiffness is an important parameter that determines the handling stability of a vehicle. Tires should have high cornering stiffness to ensure good handling stability of the vehicle. Tire pressure is a significant factor affecting its cornering stiffness; the higher the tire pressure, the greater the cornering stiffness. However, once the pressure exceeds a certain level, the stiffness no longer changes. Tire pressure is a crucial factor affecting the service life and economy of tires. Improper selection of tire pressure can cause power cycling, leading to increased tire wear and reduced service life. Considering the impact on performance, it is essential to choose the appropriate tire pressure to extend the service life of tires and improve economy.
Was this review help?
14
4
Share
MacKaleb
09/19/25 6:28am
I've been driving the Vios for a while now, and I remember when the tire pressure light came on right after I bought the car, I didn't know what to do. The reset button is located on the lower right side of the steering wheel, marked with TPMS or a tire pressure symbol. If there's no button, you might need to look for the tire pressure reset option in the multifunction steering wheel's instrument panel menu. The steps are: first, park and turn off the engine to ensure all four tires have normal pressure. Use a tire pressure gauge to double-check and avoid mistakes, then start the engine but don't drive. Hold the reset button for a few seconds until the light goes off. Sometimes the system is slow, so wait a moment to confirm. If you can't find the button, open the instrument panel settings, use the steering wheel's up and down buttons to navigate to the tire section, and select a reset-like option. Remember, different models and configurations may vary slightly, but the reset function is generally located in the cockpit area for easy access. It's best to always carry a tire pressure gauge in case the light comes on unexpectedly.
Was this review help?
14
0
Share
Expand All
More Forum Discussions

Does the Wuling Hongguang Mini have fast charging?

Wuling Hongguang MINI does not have fast charging, as the slow charging method is safer than high-power DC fast charging and avoids potential safety hazards. The following is an introduction to the Wuling Hongguang Mini model: 1. Configuration: The Hongguang MINIEV comes with a remote control key and a mechanical key, as well as practical configurations such as hill start assist, EPS electronic power steering, electric windows, and adjustable front seats. 2. Safety: The Hongguang MINIEV comes standard with ABS anti-lock braking system, EBD brake force distribution system, tire pressure monitoring, rear parking radar, low-speed pedestrian warning system, hill start assist, EPS electronic power steering, and other practical configurations. The rear seats are also equipped with 2 ISOFIX child safety seat interfaces. 3. Intelligence: In front of the steering wheel of the Hongguang MINIEV, there is a small screen that can connect with a mobile phone via an APP.
13
5
Share

What is the difference between Nardo Gray and Crystal Nardo Gray?

Crystal Nardo Gray has a density of 1000, while Nardo Gray has a density of 1100. The difference lies in their varying densities. Below is a detailed introduction to both: Nardo Gray: Nardo Gray is the original factory color of the Audi RS series, and many people tend to confuse it with cement gray. In fact, there are some differences between the two. Compared to the deep tone of cement gray, Nardo Gray appears brighter and more vibrant. Gray easily creates a sense of simplicity and subtlety, and Nardo Gray is a shade within the gray spectrum that doesn’t feel oppressive, making it a favorite among many car owners. Crystal Nardo Gray: Crystal Nardo Gray clearly outlines the original body lines, bringing a low-key yet luxurious beauty, effortlessly creating a cool and premium color sensation. The crystal-like film effect makes this unique gray appear particularly bright, elegant, pure, and refined, giving the car surface a slightly rational, cold industrial style, making the entire vehicle look both soft and pleasing to the eye.
2
2
Share

Does stopping midway during Subject 3 result in point deduction?

Stopping midway will directly result in a 100-point deduction, leading to disqualification. Except for stopping at red lights during intersections in Subject 3, stopping is not required at other times. Below are the point deduction criteria for roadside parking during the Subject 3 road test: Deduction of 100 points (disqualification): Failure to observe the traffic conditions behind and to the right through the interior and exterior rearview mirrors before parking results in disqualification. If the examinee fails to park within the specified distance after the examiner issues the roadside parking instruction, it results in disqualification. After parking, if the vehicle body exceeds the right edge line of the road or the sidewalk edge line, it results in disqualification. Deduction of 10 points: Failing to use or incorrectly using the turn signal before parking results in a 10-point deduction. Turning the steering wheel before the turn signal has been on for at least 3 seconds before parking results in a 10-point deduction.
5
2
Share

What does the sawtooth lane on the highway represent?

The sawtooth lane on the highway is a longitudinal speed bump, also known as a deceleration marking. As the name suggests, the main purpose of this lane is to prompt drivers to slow down in advance. This type of lane is usually set up before bridges, toll plaza areas, exit ramps, curves, slopes, and other locations. Additionally, some accident-prone areas may also feature this type of lane. Additional information: 1. Purpose of the sawtooth lane: Due to its unique design, the sawtooth lane creates an illusion for drivers that the lane is narrowing, inducing a sense of pressure and prompting them to slow down automatically in advance. By slowing down early, the probability of accidents caused by sudden braking or inadequate avoidance is significantly reduced. 2. Classification of deceleration markings: Deceleration markings are divided into horizontal deceleration markings and longitudinal deceleration markings. Horizontal deceleration markings consist of a set of parallel white dashed lines, while longitudinal deceleration markings consist of a set of diamond-shaped dashed lines parallel to the lane boundary lines, starting at the beginning of the longitudinal deceleration markings.
6
0
Share

Is it dangerous to charge an electric vehicle in direct sunlight?

Apart from the rise in interior temperature, there are no other dangers associated with charging an electric vehicle in direct sunlight. The high temperatures generated under direct sunlight only affect the surface temperature inside the vehicle and do not directly interact with the battery pack, nor do they cause the internal temperature of the battery pack to rise. Therefore, there is no risk of spontaneous combustion. Additionally, before electric vehicles leave the factory, all battery packs undergo national safety certifications, providing a certain level of assurance. Moreover, most pure electric vehicle battery packs are equipped with thermal management systems that can autonomously regulate the temperature of the battery pack, ensuring it operates within an appropriate range. Thus, even when charging in high temperatures, there is no danger. However, the interior temperature can reach up to 50 degrees Celsius, so flammable items such as alcohol should not be left inside the vehicle. Charging precautions: Turn off the vehicle's power while charging; master the correct charging time; avoid overcharging or over-discharging the battery.
11
1
Share

What does it mean when the online application for Subject 2 is successful?

Subject 2 online application success means the system has received the registration information and is scheduling the exam. The items included in the Subject 2 test are as follows: Reversing into a garage: Compared to the original electronic pole test, the 'moving garage' skill has been removed. It only tests the skill of entering a vertical garage from both left and right sides while driving horizontally. Stopping and starting on a slope: This is the hill start from the old nine-choose-three test. The examinee must drive to the hill start test point, with the front wheels stopping exactly on the line. After passing this, the hill start is tested, and the car must not roll backward. Any mistake will result in points deduction or even failure. Parallel parking: This is identical to the parallel parking in the nine-choose-three test. The vehicle must be driven to a position parallel to the garage, then reversed into the garage to the right rear without any pauses. Curve driving: This involves driving through a lane with two turns greater than 40 degrees in one go, without stopping, crossing, or leaving the line. Right-angle turn: This is the same as the right-angle turn in the nine-choose-three test, but no stopping is allowed during the maneuver.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.