Where is the three-way catalytic converter located on the Wuling Rongguang?

1 Answers
DeBryce
07/30/25 9:53am
The three-way catalytic converter of the Wuling Rongguang is installed on the exhaust manifold. Below are specific details about the three-way catalytic converter: 1. Function: The three-way catalytic converter serves as an emission control device for the engine. Its proper operation directly affects the engine's fuel consumption, power output, and emission performance. 2. Malfunction symptoms: If clogged or malfunctioning, it will cause excessive exhaust emissions and impair engine performance, commonly manifested as increased fuel consumption, sluggish acceleration, abnormal exhaust noises, and foul-smelling emissions. 3. Maintenance interval: Generally, the three-way catalytic converter should be cleaned every 30,000 kilometers. It's also recommended to clean it before annual vehicle inspections to ensure passing the emissions test.
Was this review help?
13
0
Share
More Forum Discussions

How many liters of engine oil should be added to a Volvo S60L?

Volvo S60L requires 3.6 liters of engine oil. The method for adding engine oil is as follows: 1. Lift the vehicle, remove the underbody panel, and place a container of about 10 liters under the oil drain plug; 2. Unscrew the oil drain plug, use an air gun to blow for two minutes at the oil filler port, then tighten the oil drain plug after draining and wipe it with a tissue to check for leaks; 3. Reinstall the underbody panel and lower the vehicle, then use a funnel to add engine oil through the oil filler port. Taking the 2021 Volvo S60L as an example, it belongs to the mid-size car category, with body dimensions of: length 4761mm, width 1850mm, height 1437mm, a wheelbase of 2872mm, and a trunk capacity of 391 liters.
16
3
Share

What to Do When the Vehicle Has No Power?

Solutions for a vehicle with no power are: 1. Push-starting the vehicle; 2. Jump-starting with cables, ensuring the positive terminal connects to positive and negative to negative; 3. Promptly recharging the battery; 4. Using a portable emergency power bank to charge and start the vehicle. The functions of the battery are: 1. Providing power to the engine starting system, ignition system, and other car electronics; 2. Supplying power to the vehicle's electrical equipment when the engine is off or idling at low speed; 3. Assisting in power supply when the demand exceeds the generator's capacity; 4. Acting as a voltage stabilizer for the vehicle's electrical system, mitigating voltage spikes and protecting electronic devices in the car.
11
2
Share

Is Volvo's Fuel Consumption High?

Volvo's fuel consumption is relatively high. Taking the Volvo S90 as an example, here is a detailed introduction to the Volvo S90: Model Positioning: The Volvo S90, as a minor annual facelift model, has added two new sport versions. Configuration: Significant improvements have been made to the mid-to-high-end models. Taking the Zhiyuan version as an example, compared to the current models, it adds practical configurations such as leather-wrapped dashboard, electric adjustment for the length of the front seat cushions, enhanced air purification system, electric side window sunshades, rear windshield sunshades, and an automatic parking system. Powertrain: It continues to use the low/high-power Drive-E series 2.0T turbocharged engine, where the T4 corresponds to low power, outputting 139kW (190PS), and the T5 corresponds to high power, outputting 186kW (254PS), paired with an Aisin 8-speed automatic transmission.
16
2
Share

How to adjust the handbrake of the Cruze?

The adjustment method for the Cruze's handbrake is as follows: 1. Release the handbrake completely; 2. Remove the air vent behind the center console or the armrest box; 3. Loosen the handbrake screw to a tension-free state, then gradually adjust this screw until the handbrake makes 5 to 6 clicking sounds when pulled up; 4. Test the car on a slope. Taking the 2018 Cruze as an example, its front suspension is a MacPherson independent suspension, the rear suspension is a torsion beam non-independent suspension, equipped with a 1.5L turbocharged engine, with a maximum horsepower of 114ps, maximum power of 84kW, maximum torque of 146Nm, and matched with a 6-speed manual transmission.
5
4
Share

How to Use the Crawl Mode of Land Cruiser?

The method to use the crawl mode of Land Cruiser is as follows: First, stop the vehicle and shift into P gear, then shift into N gear, turn on the low-speed four-wheel drive function, engage the central differential lock, shift into D gear, and press the auxiliary button. Taking the 2016 Land Cruiser as an example, its body dimensions are: length 5170mm, width 1975mm, height 1930mm, with a wheelbase of 2850mm. The 2016 Land Cruiser features a front suspension with a spiral spring double-wishbone independent suspension and a rear suspension with a four-link non-independent suspension. It is equipped with a 4.0L naturally aspirated engine, delivering a maximum horsepower of 275PS, a maximum power of 202kW, and a maximum torque of 385Nm, paired with a 5-speed automatic transmission.
16
0
Share

How to turn on the headlights of the Lavida?

The method to turn on the headlights of the Lavida is: rotate the light adjustment lever on the left side of the steering wheel to the headlight position. Taking the 2019 Lavida as an example, it belongs to the compact car category, with body dimensions of: length 4613mm, width 1765mm, height 1460mm, and a wheelbase of 2610mm. The curb weight is 1210kg. The 2019 Lavida features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a 1.5L naturally aspirated engine, producing a maximum horsepower of 112PS, a maximum power of 82kW, and a maximum torque of 145Nm. It is paired with a 5-speed manual transmission.
6
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.