Where is the sunroof drain pipe of the 2013 Bora?

2 Answers
OSawyer
07/28/25 11:50pm
The sunroof drain pipes are usually located inside the A-pillars and C-pillars of the vehicle. When water enters the sunroof channel, it flows to the drain holes and then exits the vehicle through the drain pipes. If the sunroof drain holes or pipes are blocked by debris, water will accumulate in the sunroof channel and eventually overflow into the interior, soaking the headliner. Below is an introduction to the Bora's sunroof drain outlets: 1. Total number of drain outlets: The Bora's sunroof has four drain outlets, one at each corner (front left, front right, rear left, rear right). The two rear drain outlets are the easiest to locate, positioned under the chassis near the rear wheels, one on each side. 2. Location of drain outlets: The front drain outlets are inside the A-pillars on both sides. Normally, water drains directly through the gaps in the vehicle. 3. Drain outlet maintenance: Improper maintenance of the sunroof can easily lead to clogged drain outlets. Once the sunroof drain outlets are blocked, water may leak into the car during rain. 4. Drain outlet cleaning: If the vehicle is parked for a long time, it's best to thoroughly clean the sunroof with talcum powder to prevent the rubber seals from chemically reacting with the air and aging naturally. 5. Drain outlet sealing: Pay attention to the sunroof's sealing strips. Check if the strips show signs of aging or poor sealing. If there are issues with the sealing strips, they should be replaced.
Was this review help?
1
2
Share
DeValerie
08/12/25 4:08am
As an owner of an older-generation Bora, I've driven this car for almost a decade and know the sunroof drain tube locations like the back of my hand. The front ends are hidden in small holes at the four corners of the sunroof opening—just open the sunroof to feel the rubber tube mouths. The rear sections run downward through the gaps between the A-pillars and C-pillars, eventually emerging from beneath the door sill trim panels, where you can spot the drain holes along the chassis edge. Last time I cleaned them, I found the tubes half-clogged with leaves, which caused water accumulation under the passenger footwell. My advice: use compressed air to blow them out before every rainy season—a ¥10+ air gun from Taobao does the trick.
Was this review help?
1
4
Share
Expand All
More Forum Discussions

How to Remove the Door Handle of a Besturn B50?

Insert a small flathead screwdriver into the small square hole and gently pry it open to remove the lock cylinder decorative cover. Open the car door and locate a rubber pad on the door edge. Use a small flathead screwdriver to pry off the rubber pad, then remove the door handle lock block screw. Take out the small flathead screwdriver and use it to pry off the small round cover at the door handle's fixed screw position. Use the small flathead screwdriver to pry the door handle lock block from the gap between the lock block and the door panel, then disassemble the door handle lock block. Hold the door handle with your left hand and pull it backward to separate the door handle from the door panel.
10
3
Share

How to Add Windshield Washer Fluid to MG6?

Locate the filler port. The windshield washer fluid filler port is located on the left side of the engine compartment, near the edge. After locating the filler port, open the filler cap. Pour in the windshield washer fluid. Be careful not to overfill, as excess fluid may spill out and cause unnecessary waste. The washer fluid reservoir has a capacity of 3 liters. High-quality windshield washer fluid has properties such as non-stickiness, anti-static, anti-corrosion, dust-proof, cold resistance, acid rain resistance, anti-freeze, and UV protection.
14
3
Share

How to Remove the Airbag in Chery Ant?

Turn off the ignition key. If you proceed with removal without turning it off, accidental deployment may occur, or error codes might be generated, causing the ECU to malfunction. There are two bolts on the back cover of the steering wheel. Remove the bolts and gently lift the cover. Then, take off the steering wheel. Disconnect the clock spring connector attached to the inflator. Typically, the connector has a locking mechanism—some require pressing to release, while others need to be pulled out. Unclip the yellow safety latch behind the airbag, then pull out the airbag connector to remove the airbag.
11
1
Share

How to Adjust the Rearview Mirror of the Boyue Million Edition

First, you can find the rearview mirror adjustment switch on the left side of the center console. After locating the adjustment switch, park the vehicle. Once the vehicle is stationary, you can electrically fold the rearview mirrors. After folding the rearview mirrors, turn the knob to different angles to adjust the rearview mirror's orientation. Adjust the horizon reflection inside the rearview mirror to the center of the mirror, and position the reflection of the left side of the vehicle to occupy the right 1/4 area of the mirror. Adjust the horizon reflection inside the rearview mirror to the 2/3 height of the mirror, and position the reflection of the right side of the vehicle to occupy the left 1/4 area of the mirror.
6
1
Share

How to Lock the Steering Wheel of a BMW 3 Series?

Before locking the steering wheel, make sure the car is parked steadily. After turning off the engine, remove the key. For cars with a manual transmission, the steering wheel will automatically lock when the driver's side door is opened without any additional steps. After removing the key, turn the steering wheel half a turn to the left until you hear a sound similar to a door closing. At this point, the steering wheel is locked. Pull the lever downward, then adjust the steering wheel in both the vertical and height directions to a comfortable position. Finally, flip the lever back up to complete the process.
4
4
Share

How to Open the Hood of a Mercedes-Benz GLB200?

Locate the hood release lever, which is typically found on the lower panel on the driver's side, resembling a handle. Once found, simply pull the hood release lever to unlock it. Lift the hood upwards by hand to open it. Many models now feature a hood release button instead of a lever; a light press will open the hood. To prevent accidental opening due to vibrations while driving, the hood is equipped with a safety latch at the front. When the doors are locked, the hood should also be secured.
9
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.