Where is the sunroof drain hole of the Buick Excelle?

2 Answers
GrahamRose
07/25/25 2:26am
The sunroof drain holes are located at the small holes in the two corners of the sunroof, and there are rubber tubes descending from the hinge of the front door frame. Below is the relevant content introduction: Finding method: If you can't locate them, you can slowly pour a bottle of mineral water and observe the direction of the water flow to spot the drain holes. Drainage structure: The sunroof drainage structure is not complicated. It consists of hard plastic and drainage rubber tubes, with the path passing through the A-pillar. Reasons for leakage: Blockage of the sunroof outlet by debris: This prevents rainwater from draining out, causing it to gradually seep into the car.
Was this review help?
2
1
Share
DiIsabella
08/10/25 4:33pm
Over the years of driving my Buick Excelle, I've encountered sunroof drainage issues, so I know the locations well. The drainage holes are typically located in the corners of the roof frame, with both front and rear openings near the sunroof tracks. Water flows through these small holes into tubes that drain near the wheel wells. The holes are quite hidden—you can see the front ones by opening the sunroof and looking along the inner roof, while the rear ones require peering toward the back of the car. Clogging is common, especially during heavy rain, when leaves and debris block the holes, causing leaks into the cabin. I learned this the hard way when my interior got soaked and took forever to dry. Now, I make it a habit to vacuum the roof area quarterly and gently clear the holes with thin wire. A good tip is to pour water over the closed sunroof to test drainage speed—address any issues promptly. Though the tube locations don’t change, aging can cause deformation, so don’t skip maintenance to avoid bigger headaches.
Was this review help?
19
5
Share
Expand All
More Forum Discussions

What is the wheelbase of the new Santana?

The wheelbase of the new Santana is 2603 mm, with a length, width, and height of 4475 mm, 1706 mm, and 1469 mm respectively. The new Santana is equipped with a 1.5-liter naturally aspirated engine across the entire lineup, paired with either a 5-speed manual transmission or a 6-speed automatic transmission. It features a MacPherson independent front suspension and a torsion beam non-independent rear suspension. The new Santana is a model launched by Shanghai Volkswagen, featuring a family-style front fascia similar to the design of models like the new Lavida. Compared to the previous generation, it better aligns with the aesthetic preferences of the modern era. The car's overall lines are smooth and regular, with a simple yet enduring design style.
16
1
Share

What suspension does the new Weiling use?

The new Weiling uses a MacPherson independent suspension for the front, which is a common independent suspension in cars. It has only one L-shaped control arm, is compact, and occupies little space, so it is widely used in many front-wheel-drive cars with transversely mounted engines. The rear suspension is a torsion beam non-independent suspension, consisting of a crossbeam and two longitudinal arms, which also occupies minimal space under the chassis, thereby expanding the rear seating and trunk space. The new Weiling is a compact car and Volkswagen's first A-class crossover station wagon, combining the attributes of a sedan, station wagon, and SUV. It not only offers the comfortable handling of a sedan but also the large, easy-to-load space of a station wagon and the off-road capability similar to an SUV.
19
2
Share

What does OBD stand for in cars?

OBD in cars stands for On-Board Diagnostics, a system that continuously monitors the engine's operating conditions to check if the vehicle's emissions exceed standards, and immediately issues a warning if they do. When a system malfunction occurs, the malfunction indicator lamp or check engine warning light will illuminate, while the powertrain control module stores the fault information in memory. The fault codes can be read from the PCM through a specific procedure. Based on the fault codes, maintenance personnel can quickly determine the nature and location of the fault. The OBD interface is generally a 16-pin female connector, trapezoidal in shape. Some vehicle models have a protective cover over the OBD port, and common OBD interfaces are black, white, or blue.
8
4
Share

Is the new Levin compliant with China 6 emission standards?

The new Levin is compliant with China 6 emission standards. The China 6 emission standards, the sixth stage of national standards for pollutant emissions from motor vehicles, are established to implement the Environmental Protection Law and the Air Pollution Prevention and Control Law, aiming to prevent pollution from exhaust emissions of compression-ignition and gas-fueled ignition engines, protect the ecological environment, and safeguard human health. The new Levin is a vehicle launched by GAC Toyota, built using the new TNGA architecture. It features a family-style front design, with the headlights connected to a black mesh grille, giving the front a more upscale appearance. In terms of power, the new Levin is equipped with a 1.8L hybrid system paired with a CVT transmission.
10
2
Share

Does the new Renegade have four-wheel drive?

The new Renegade is equipped with four-wheel drive, adopting a front-engine, four-wheel-drive layout with an on-demand four-wheel-drive system. The new Renegade was launched in September 2019, with all models meeting the China VI emission standards. A total of five variants were introduced: the 220T Auto Standard Edition, 220T Auto Leading Edition, 220T Auto Elite Edition, 220T Auto Night Eagle Edition, and 220T Auto 4WD Elite Edition. The all-new Jeep Renegade combines the 75-year heritage of American professional SUV four-wheel-drive technology represented by Jeep within the FCA Group with the 117-year European sports car handling genes represented by Fiat, creating a professional-grade SUV with exceptional driving fun.
12
0
Share

What kind of suspension does the new Excelle use?

The new Excelle uses a MacPherson strut independent suspension at the front and a compound torsion beam non-independent suspension at the rear. The suspension refers to all the force-transmitting connection devices between the car's frame and axle. Depending on the type, car suspensions are categorized into independent and non-independent suspensions. Different suspension types affect the car's comfort and handling differently. The new Excelle is a compact sedan produced by SAIC-GM Buick, equipped with a 1.3-liter turbocharged engine across the lineup. Transmission options include a 5-speed manual and a CVT continuously variable transmission. The vehicle features multiple body reinforcement measures, which not only enhance safety but also significantly increase chassis rigidity, improving the sporty feel and providing better road feedback for the driver, thereby enhancing the driving experience.
8
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.