···
Log in / Register

Where is the sunroof drain hole located on the Magotan B8?

3 Answers
VonJack
07/28/25 11:43am

The drain holes for the doors are located at the bottom of the doors, with two holes on the inner edge of the door outer panel. During vehicle use, owners should regularly check the drain holes to ensure they are clear and avoid blockages. Below is relevant information: Distribution of drain holes on the vehicle: 1. Depending on their location, drain holes on a vehicle can be categorized as door drain holes, sunroof drain holes, air conditioning drain holes, fuel filler drain holes, and drain holes beneath the front windshield. 2. If a drain hole becomes blocked, water will accumulate inside the door, leading to rust and corrosion of the door's metal panel. In cases of excessive water accumulation, it may even seep out through the gap between the door inner panel and the metal panel, flowing into the cabin.

Was this review help?
10
5
Share
Tamara
08/11/25 4:36pm

I've been driving this Magotan B8 for three years, so I'm very familiar with the location of the sunroof drainage holes. They're at the four corners of the sunroof tracks, two on each side. The front two holes are near the A-pillar where the sunroof curves, and you can usually spot the small black holes by shining a flashlight downward. The rear two holes are hidden at the roof angle near the C-pillar, requiring you to lean out to see them. The drainage tubes run along the roof and drain near the door hinges, with the front door drainage outlets being particularly concealed. If you often find the A-pillar carpet wet when parked, it's likely that these drainage holes are clogged with leaves—I just use compressed air to blow them clear.

Was this review help?
15
0
Share
Expand All
DiMartin
09/28/25 5:42am

Last time I went to the repair shop to replace the wipers, I specifically asked the mechanic about the sunroof drainage locations on the Magotan B8. The mechanic said they are all at the four corners of the sunroof glass: the front two are at the corners where the windshield meets the sunroof, and the drainage pipes run down along the A-panel sheet metal. The rear two are on both sides at the back of the roof, hidden inside the headliner trim. When the mechanic demonstrated with an air gun, I noted that the drainage outlets are all on the inner side of the fenders near the front and rear wheel arches. For cleaning, you need to fully open the sunroof first, use a small brush to sweep away the dirt in the channels, and then pour water to test.

Was this review help?
20
5
Share
Expand All
More Forum Discussions

Should You Engage the Handbrake or Neutral First When Parking?

The correct parking procedure for an automatic transmission vehicle should be: press the brake → shift into gear → engage the handbrake → turn off the engine → shift into parking gear. In other words, after stopping, engage the handbrake first before shifting into neutral. Below is relevant information: 1. Auxiliary Brake: The professional term for the handbrake is the auxiliary brake. Unlike the main braking system, it uses a steel cable connected to the rear brake shoes to apply braking force to the vehicle. Prolonged use of the handbrake can cause the steel cable to undergo plastic deformation. Since this deformation is irreversible, long-term use will reduce its effectiveness and increase the handbrake's travel distance. 2. Neutral Gear: Neutral gear typically refers to the state where the vehicle's gear lever is not engaged in any forward or reverse gear, completely disconnecting the transmission from the drive wheels. For manual transmissions, the neutral position is in the middle, while for automatic transmissions, it is marked with an "N".
4
5
Share

What are the types of car engines?

Types of car engines are as follows: 1. According to the working method of the intake system: They can be divided into four types: naturally aspirated, turbocharged, mechanically supercharged, and twin-charged. 2. According to the piston movement method: They can be divided into reciprocating piston internal combustion engines and rotary piston engines. 3. According to the cylinder arrangement: They include inline engines, V-type engines, W-type engines, and horizontally opposed engines, etc. 4. According to the number of cylinders: They can be divided into single-cylinder engines and multi-cylinder engines. Modern cars mostly use three-cylinder, four-cylinder, six-cylinder, and eight-cylinder engines. 5. According to the cooling method: They can be divided into water-cooled engines and air-cooled engines. Water-cooled engines have uniform cooling, reliable operation, and good cooling effect, and are widely used in modern automotive engines. 6. According to the number of strokes: They can be divided into four-stroke internal combustion engines and two-stroke internal combustion engines. Four-stroke internal combustion engines are widely used in car engines. 7. According to the fuel supply method: They include carburetor engines, electronic fuel injection engines, and direct injection engines.
15
1
Share

What Are the Reasons for Windshield Washer Not Spraying Water?

Common causes for windshield washer not spraying water include: insufficient washer fluid level; incorrect washer fluid selection leading to freezing in cold weather, which may crack the washer fluid reservoir; malfunction of the washer pump causing it to stop working; or faults in the washer tubing and nozzles preventing water spray. When the windshield washer fails to spray, consider the following aspects: 1. Washer pump burnout: The washer pump might be burnt out. To check this, keep the vehicle stationary, turn on the washer switch, and listen for the pump's sound in a quiet environment. If the pump doesn't operate, it certainly won't spray water to clean the windshield. 2. Empty washer reservoir: Pay attention to simple maintenance or operations. In fact, car manufacturers have detailed in the user manual some basic "issues" that owners can maintain themselves. If individuals learn and master these, such "unnecessary" "mistakes" can be avoided. 3. Wiring issues: Possible causes include wiring faults, blown fuses, or other circuit-related problems preventing the washer pump from functioning, hence no water spray. 4. Nozzle blockage: Nozzles may get clogged due to dust ingress, poor water quality, among other reasons. Of course, poor nozzle quality can also lead to no water spray.
9
2
Share

What brand is CENTARA tires?

CENTARA is the Speedline tire brand of Shandong Zhongyi Rubber Co., Ltd. Shandong Zhongyi Rubber is a research and manufacturing enterprise specializing in the production of high-performance semi-steel radial tires, all-steel radial tires, steel wire rope core and fabric core rubber conveyor belts. It owns tire brands such as Leluchi, Speedline, JOYROAD, CENTARA, and ARDENT. The company's radial tires cover more than 500 models across 18 series, with SUV, UHP, and snow tires as the main products. The products are characterized by high cost performance, low carbon and environmental protection, quietness and comfort, and safety and reliability. The company possesses run-flat tire production technology and patented puncture-proof and leak-proof safety tire production technology. The products are sold throughout China and exported to more than 130 countries and regions, including Europe, America, Africa, Southeast Asia, the Middle East, the United States, Japan, Australia, and India. When using CENTARA tires in daily life, pay attention to the following points: Regularly check the tire surface for cracks, deformations, and other defects. Due to driving wear, the tread pattern grooves gradually become shallow. If the pattern is worn flat, it will lose its drainage and anti-slip functions, and the car's performance will be greatly reduced. Small cracks may seem insignificant, but they can be a hidden danger for tire blowouts at high speeds. In addition, immediately remove pebbles from the grooves. Try to park on flat ground. Avoid parking the car on roads with thick, sharp, or pointed stones. The car should not be parked near or in contact with petroleum products, acids, or other materials related to rubber deterioration. After parking, the driver should not turn the steering wheel, as this will accelerate tire wear. Do not splash water for cooling. In hot weather or during high-speed driving, tires are prone to overheating, and the air pressure will increase. At this time, you should stop to dissipate heat. It is strictly forbidden to deflate for pressure reduction or to splash water for cooling, as this may cause abnormal aging of the tread rubber. Avoid sudden braking. Try to minimize frequent use of brakes and sudden braking to prevent accelerated tread wear caused by dragging between the tires and the ground.
8
2
Share

What is the Critical Inspection of Motor Vehicles?

Vehicle approaching annual inspection (safety technical inspection) means that small and micro non-operating passenger vehicles must be inspected once every 2 years within 6 years; operating passenger vehicles must be inspected once every year within 5 years. If an operating motor vehicle passes the safety technical inspection within the specified inspection period, it will not be subject to repeated safety technical inspections. Below is Article 16 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China": Motor vehicles shall undergo safety technical inspections according to the following periods from the date of registration: (1) Operating passenger vehicles must be inspected once every year within 5 years; after 5 years, they must be inspected once every 6 months. (2) Trucks and large and medium-sized non-operating passenger vehicles must be inspected once every year within 10 years; after 10 years, they must be inspected once every 6 months. (3) Small and micro non-operating passenger vehicles must be inspected once every 2 years within 6 years; after 6 years, they must be inspected once every year; after 15 years, they must be inspected once every 6 months. (4) Motorcycles must be inspected once every 2 years within 4 years; after 4 years, they must be inspected once every year. (5) Tractors and other motor vehicles must be inspected once every year.
16
5
Share

Can passenger car ETC lanes be used by small vehicles?

Passenger car ETC lanes can be used by small vehicles because ETC tags do not distinguish between passenger cars and small vehicles. However, when registering an ETC tag, you will need to select whether the vehicle type is a passenger car or a small vehicle. Benefits of installing ETC: Time-saving: Eliminates the hassle of waiting in queues; Green and eco-friendly: Promotes low-carbon travel, as vehicles can pass through toll stations without stopping, reducing noise and exhaust emissions and minimizing pollution; Reduced wear and tear: Saves costs by decreasing the frequency of vehicle starts and stops, lowering wear and fuel consumption. Users can also enjoy a 5% discount on toll fees; Improved efficiency: ETC lanes can theoretically increase vehicle throughput by 2-3 times, making traditional ETC systems more updated, faster, and more technologically advanced. Compared to license plate payment, ETC technology is more mature and advantageous. The installation process for ETC devices is as follows: Upon receiving the device, first check whether the ETC card and the electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU; a red light will briefly illuminate, and the OLED screen will display "Tag Invalid" or "Please Insert Card," indicating the device is functioning properly. Clean the front windshield to ensure the surface is smooth, clean, and dry. Then, peel off the adhesive backing of the OBU and attach it to the installation position. Press firmly for 2-3 minutes to remove any air bubbles. Insert the ETC card with the front side facing the driver and the back side facing the windshield. The chip should be inserted into the OBU device.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.