Where is the reversing camera installed on the Baojun RC6?

1 Answers
OHolden
07/28/25 6:19pm
The reversing camera of the Baojun RC6 is generally installed at the position of the license plate light. Below is a detailed introduction to the meanings of different colored trajectory lines in the reversing camera: 1. Red trajectory: Indicates the warning line, with a distance of 30cm from the rear of the car. When the car reaches near this line, the parking space is just right, and no further reversing is needed. 2. Yellow trajectory: Indicates the deceleration line, with a distance of 60cm from the rear of the car. You can continue to reverse, but pay attention to decelerating and checking the distance. 3. Green trajectory: Indicates the normal safety line, where the distance between the obstacle and the rear of the car is relatively large, allowing you to reverse with confidence.
Was this review help?
11
5
Share
More Forum Discussions

Why does the water temperature rise sharply when parked?

Because when the vehicle is parked, there is no flowing air coming in to cool the engine radiator, so the water temperature will rise. Below are the relevant introductions: 1. Car radiator: The car radiator is mainly composed of a radiator core, water pipes, cooling air fins, an upper water tank, and a lower water tank. The upper water tank is located on the radiator, and water pipes connect it to the lower water tank below the radiator. Hot water flows from the upper to the lower water tank and turns into warm water. 2. Coolant: Coolant, whose full name should be antifreeze coolant, means coolant with antifreeze function. Antifreeze can prevent the coolant from freezing and expanding the radiator or freezing the engine cylinder block when the car is parked in cold seasons. Antifreeze is not only used in winter; it should be used all year round. In normal car maintenance, the engine antifreeze should be replaced every year.
4
1
Share

What are the causes of transmission failure in the Ford Mondeo Zhisheng?

Ford Mondeo Zhisheng transmission failure causes: 1. Fault in the power electronic control system: It may be due to a faulty connection line of a certain transmission sensor. Auto repair shops can perform computer diagnostics and identify the specific fault based on the error codes. 2. Lack of automatic transmission fluid: This can lead to overheating of the automatic transmission or failure to increase speed due to slipping of the one-way clutch. Below is a brief introduction about transmissions: 1. Classification of transmissions: Transmissions are divided into manual transmissions and automatic transmissions. Manual transmissions consist of gears and shafts, while automatic transmissions are composed of hydraulic torque converters, planetary gears, etc. 2. Development and reform of transmissions: With the continuous development of the automotive industry, transmissions have evolved from manual transmissions in the past to automatic transmissions today. Transmissions allow the car to reverse while keeping the engine rotation direction unchanged, and shifting into neutral can interrupt power to enable engine start and gear shifting. Owners using automatic transmissions can easily drive the car, and compared to manual transmissions, automatic transmissions are less prone to failures.
20
1
Share

What is the top speed of the Shadow S450?

The top speed of the Shadow S450 is 100m/5.1S. Below is some information about the Shadow S450: 1. Positioning: Mercedes-Benz officially launched the EQC model in Stockholm, Sweden. As the first mass-produced SUV under the electric sub-brand EQ, it is positioned as an electric mid-size SUV. Production will begin in Germany in early 2019, with production and launch in China by the end of the same year. 2. Powertrain: In terms of the most anticipated powertrain, the new vehicle is equipped with dual front and rear motors, a full-time four-wheel-drive system, and an 80kWh battery pack, delivering a maximum power of 300kW and an NEDC range of over 450km.
15
4
Share

What does 'water motorcycle' mean? Can a water motorcycle be registered?

No, 'water motorcycle' refers to a smuggled vehicle. Although motorcycles have a simple structure and are easy to ride, they must still go through the proper registration process. Motorcycles are considered vehicles and have the potential to cause accidents. Registering a motorcycle is also a measure to prevent illegal use and ensure accountability in case of traffic accidents. Smuggled vehicles are those that have not been imported through the country's official channels and have not paid the required taxes. Motorcycle registration must follow the proper legal procedures. Below is an introduction to motorcycle driver's licenses D, E, and F: 1. License D: License code: D, Age requirement: 18-60 years, Vehicle type: Regular two-wheeled motorcycle, Allowed vehicles: Three-wheeled motorcycles with an engine displacement greater than 50ml or a maximum design speed greater than 50km/h, Other allowed vehicles: E, F, Annual physical exam: Not required for those under 60 years old, Test vehicle requirements: At least a four-speed regular three-wheeled motorcycle (either front or side configuration). 2. License E: License code: E, Age requirement: 18-60 years, Vehicle type: Regular two-wheeled motorcycle, Allowed vehicles: Two-wheeled motorcycles with an engine displacement greater than 50ml or a maximum design speed greater than 50km/h, Other allowed vehicles: F, Annual physical exam: Not required for those under 60 years old, Test vehicle requirements: At least a four-speed regular two-wheeled motorcycle. 3. License F: License code: F, Age requirement: 18-70 years, Vehicle type: Light motorcycle, Allowed vehicles: Motorcycles with an engine displacement less than or equal to 50ml and a maximum design speed less than or equal to 50km/h, Other allowed vehicles: Only F, no other vehicle types allowed, Annual physical exam: Not required for those under 60 years old, Test vehicle requirements: To be determined by the provincial traffic management authorities.
16
3
Share

How to Determine if the Car is in the Middle During an S-Turn?

Subject 2 S-turn is a mandatory test item. To determine if the vehicle is in the middle during an S-turn, observe the angle between the A-pillar and the lower edge of the windshield. If this angle aligns with the left edge of the S-turn, maintain this alignment by steering accordingly, ensuring the vehicle stays in the center of the lane. The method for navigating an S-turn in Subject 2 is as follows: 1. Drive to the right: As the vehicle approaches the curve driving test area and the in-car voice prompt begins, position the vehicle at the entrance of the curve, adjusting it to the center of the road. Try to keep the outer front wheel close to the right edge of the curve. 2. Turn left: Once the vehicle enters the curve area, drive along the right side. When the left corner of the car aligns with the right edge line, turn the steering wheel one full turn to the left while making minor adjustments. Monitor the distance between the wheel and the curve edge via the right rearview mirror. 3. Turn right: As the left corner of the car gradually completes the right edge line of the left turn, keep the steering wheel steady. When the right vertex of the car hood touches the left edge line of the right turn, straighten the steering wheel and proceed slowly. 4. Continue turning right: When the left 1/3 of the car hood meets the left edge line of the right turn, turn the steering wheel one full turn to the right while making minor adjustments. Ensure the right corner of the car aligns with the left edge line of the right turn, following the S-curve to the right without crossing or leaving the line. 5. Exiting the curve: Do not rush to straighten the wheel. Many drivers hastily straighten the wheel after completing the right turn, resulting in crossing the left curve line. At this point, be cautious and slightly straighten the wheel first, then fully straighten it once the car is aligned.
17
4
Share

Should the first line be pressed during the uphill start in Subject 2?

It is not necessary to press the line; just stay close to it. The right front and rear wheels of the vehicle should be within 30 centimeters of the sideline. Below are the relevant details: 1. Subject 2: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment. It refers to the field driving skill test. For small cars (C1/C2), the test items include five mandatory components: reversing into a parking space, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through curves (commonly known as the S-curve). 2. Uphill Start: The uphill start is a field test in the driver's license Subject 2 exam, which involves starting a vehicle parked on a steep slope upwards.
1
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.