···
Log in / Register

Where is the radio fuse located in the Volkswagen Magotan?

3 Answers
Philip
09/04/25 4:12am
The radio fuse in the Volkswagen Magotan is located above the wiring harness connector on the back of the radio. The blowing of a fuse is a warning signal: If there is a short circuit or overloaded electrical equipment in the vehicle, replacing a fuse alone cannot completely solve the problem. It is possible that the fuse in this location will blow again, as the blowing of a fuse is a warning signal indicating that there are factors in the circuit causing the fuse to blow. Factors that can cause a fuse to blow include: Overload: Multiple electronic products sharing the same circuit simultaneously, exceeding the main circuit load, or a malfunction in an electronic product causing an increase in current; Short circuit: Incorrect connections of the battery or generator, insulation failure, or incorrect placement of tools can all lead to a short circuit. Sometimes, the failure of a component in the circuit, manifested as an increase in resistance, can cause the current in the subsequent circuit to rise during normal operation, thereby blowing the fuse.
Was this review help?
13
1
Share
Shane
09/16/25 5:19am
On my Volkswagen Magotan, the radio fuse is usually located in the cabin fuse box, which can be found either on the side of the dashboard below the driver's seat or behind the glove compartment on the passenger side. Open that small plastic cover, and you'll see a bunch of colored fuses along with a legend label. Look for the fuse labeled as 'Radio' or 'Infotainment,' typically numbered F25 or similar. I've experienced this several times—when the fuse blows, the radio stops working, often due to circuit overload or improper wiring from aftermarket installations. When replacing it, make sure to turn off the engine and remove the key, then carefully extract the old fuse using a fuse puller and replace it with a new one of the same amperage. Don’t forget to check if the radio connector is loose or worn out, as this can also cause the new fuse to blow quickly. I recommend keeping spare fuses handy for emergencies—after all, having music while driving is important, but safety always comes first.
Was this review help?
18
5
Share
Expand All
LilahLee
10/30/25 5:53am
Last month, my Magotan's radio suddenly went silent, so I went to check the fuse box. It's located on the inner side of the glove compartment on the passenger side—just flip open the small cover to reveal an array of fuses. The legend indicated the fuse for the entertainment system, and I easily located the corresponding position, like F30. You can pull it out effortlessly using a key or your fingernail. To check if it's blown, look at the thin metal wire inside the transparent plastic—if it's intact, it's fine; if it's melted, you'll need to buy a replacement of the same specification from an auto repair shop. The cause might have been overloading from plugging in too many phone chargers. Handling such minor issues yourself saves time and hassle, but avoid using metal tools to prevent short circuits that could damage the car. During routine maintenance, take a quick glance at the fuses to prevent the radio from suddenly cutting out.
Was this review help?
12
5
Share
Expand All
More Forum Discussions

How to Reset the Maintenance Light on the 2020 Buick Excelle?

Press and hold the reset button "A" while stepping on the brake. Turn the ignition switch to "on" without starting the car. The characters "INSP" will flash or the display will blink. Continue holding the reset button "A" until "..." appears on the display. Release the reset button "A" and take your foot off the brake. Turn the ignition switch back to the "Off" position. The reset process is complete. Note that not all models can be reset manually; some models require code clearing.
11
3
Share

How to restart the Audi MMI system?

Press the car button at the bottom left, the large knob in the middle, and the button at the top right next to the large knob to restart the MMI. Hold for about 6 seconds, and the system screen will turn off and then automatically restart. If you find that it cannot restart smoothly each time, it is related to these buttons. Hold for about 2 seconds to forcibly shut down the MMI system. After shutting down, press and hold the power button to turn it on again. If the above methods cannot restart the system smoothly, it is time to go to the 4S store for replacement and repair in a timely manner.
9
0
Share

What to Do When the Car Key Fob Won't Open the Door?

Here are the solutions when the car key fob fails to open the door: 1. Replace the battery; 2. Use the mechanical key to open the door; 3. Inspect and repair the sensor module. The steps to replace the key fob battery are: 1. Remove the mechanical key; 2. Insert a flat-head screwdriver into the "open" slot at the bottom and gently pry upwards and downwards; 3. Once a gap appears, use the screwdriver to carefully pry open the key fob along the gap; 4. Remove the old battery and replace it with a new one. The reasons why the car key fob may not open the door include: 1. Insufficient battery power in the key fob; 2. The car battery is dead, preventing the key fob from being detected; 3. Issues with the key fob or sensor module.
18
4
Share

How to release the windshield washer fluid in Haval M6?

To release the windshield washer fluid in Haval M6, pull the lever on the right rear side of the steering wheel toward the driver's direction and hold for two seconds. The Haval M6 is a compact 5-door, 5-seat SUV with the following dimensions: length 4664mm, width 1830mm, height 1729mm, and a wheelbase of 2680mm. It is equipped with a 1.5T turbocharged engine and a 6-speed manual transmission, delivering a maximum power of 110 kW at 5600-6000 rpm and a peak torque of 210 Nm at 1800-4400 rpm. The drivetrain configuration is front-engine, front-wheel drive. The front suspension uses MacPherson strut independent suspension, while the rear suspension employs double-wishbone independent suspension.
15
5
Share

How to Repair a Dented Car Rocker Panel?

Insert the hot melt glue stick from the back of the glue gun, ensuring the stick is fully inserted. Plug the glue gun into a power outlet, set the temperature to the highest level, and preheat for 3-5 minutes until the hot melt glue is completely melted. Select a suitable traction washer based on the diameter of the dent, then pull the glue gun trigger to coat the traction washer with melted glue. Gradually, the dent will rise. If any raised areas appear after pulling, use a rubber hammer and a specialized wooden pen to gently tap until the dent blends into the car paint.
12
5
Share

What to do if the roof light of the Lavida stays on and cannot be turned off?

First, open the rear door of the car and sit in the middle of the back seat. Look up, and you will find the switch for the roof light directly above the seat. The button generally has three modes: ON (always on), DOOR (on when the door is open and off when closed), and OFF (off). OFF means the light is turned off; selecting this mode will keep the roof light off and it will not illuminate.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.