Where is the production base of Great Wall WEY?

Is the BMW X5 equipped with a timing belt or chain?

The BMW X5 uses a timing chain, not a belt. Characteristics of chain drive system: The chain drive system offers reliable transmission, excellent durability, and space-saving benefits. The entire system consists of gears, chains, and tensioning devices. The hydraulic tensioner automatically adjusts the tension force to maintain consistent chain tension. This design ensures the chain lasts as long as the engine itself, enhancing safety and reliability while reducing engine maintenance costs—a win-win solution. Timing chain maintenance notes: The sprocket should be mounted on the shaft without tilting or wobbling. For two sprockets in the same transmission assembly, their end faces must lie on the same plane. When the center distance between sprockets is below 0.5 meters, a deviation of 1mm is permissible; for distances exceeding 0.5 meters, up to 2mm deviation is allowed. However, friction against the sprocket tooth sides must be avoided, as excessive misalignment may cause chain slippage or accelerated wear. During sprocket replacement, always check and adjust offset values. Chain tension should be properly adjusted—excessive tightness increases power consumption and bearing wear, while excessive looseness causes chain skipping or disengagement. The optimal tension allows approximately 2-3cm vertical movement at the midpoint between two sprockets.

16

1

Share

How many liters of engine oil should be added to a BMW X5?

BMW X5 requires 6.5 liters of engine oil. Here is some relevant knowledge about adding engine oil: Standard for adding engine oil: Generally, it is best to add engine oil to the middle level between the upper and lower limits on the dipstick. Try not to go below the middle level because high-speed driving can cause the engine oil to become thinner due to the high temperature of the engine. If the oil level is too low, it will reduce the lubrication effect. It is acceptable to have a little more than the middle level, but never exceed the upper limit on the dipstick. Effects of overfilling engine oil: Excessive engine oil will increase the internal rotational resistance of the engine, leading to higher fuel consumption. Additionally, too much oil will raise the internal oil pressure of the engine, putting extra pressure on the oil seals and piston rings inside the engine. This can cause premature damage to the crankshaft and valve seals, resulting in engine oil leaks. Moreover, the high pressure and excessive oil can prevent the piston rings from sealing the upward-moving lubricating oil in the cylinder, causing oil to enter the combustion chamber and leading to oil burning.

1

2

Share

How to Solve the Sudden Failure to Start a Mercedes-Benz C180?

Check whether the live wire entering the ignition switch has electricity. If yes, the part before the ignition switch is normal; if no, there is a fault before the ignition switch. Check whether the wire connections are loose, fallen off, corroded, or have poor contact. Fault inspection: Insert the key and turn it to the ignition position without moving it. Check whether the live wire of the starter motor solenoid has electricity. If no, the ignition switch is faulty; if yes, continue to check whether the solenoid is faulty—inspect whether the solenoid coil is open, whether the wires and connections are loose, corroded, or have poor contact, etc. Inspection steps: At the moment of powering on, check whether the dashboard, indicator lights, especially the test switch on the machine, have any response. If not, inspect the switch, battery, wiring harness, etc. If yes, proceed to the next inspection. When attempting to start, check whether the starter makes a clicking sound. If yes, inspect the starter and power supply; if no, check the wiring harness, fuse, key switch, etc. If the starter rotates normally, inspect the fuel system, high-voltage circuit, fuse, spark plugs, timing components (including the distributor, etc.), or even whether the engine requires an overhaul.

11

2

Share

Where is the tire pressure reset for the BAIC X35?

The tire pressure reset for the BAIC X35 is located on the center console. Below is the method to reset the tire pressure warning light for the Senova X35: 1. Tire pressure warning light triggered by a punctured tire: Usually, there is a very slow leak, making it difficult to identify which tire is affected immediately. In this case, use a tire pressure gauge to measure the pressure—2.3 bar for the front tires and 2.5 bar for the rear tires. If any tire is underinflated, refill it to the correct pressure and then observe the tire pressure warning light. If the light comes on again after a few days, it may be necessary to remove the tire for inspection. At 4S shops, maintenance personnel typically adjust the front tire pressure to 2.3 bar and the rear tire pressure to 2.4 bar, then reset the tire pressure warning and test drive for 3-4 days. If the warning does not reappear, there is no issue; if it does, there may be a punctured tire requiring further inspection at the 4S shop. 2. Sometimes, the tire pressure warning light is triggered by overinflation: According to the international standard GBT-2978-2008, the recommended inflation pressure for passenger car tires is as follows: Standard tires: 2.4-2.5 bar; Reinforced tires: 2.8-2.9 bar; Maximum pressure: should not exceed 3.5 bar. Therefore, if any tire exceeds 3.0 bar, it will trigger the tire pressure warning light. 3. Tire pressure warning light triggered by prolonged driving with low tire pressure: This usually occurs when a tire is significantly underinflated, causing the tire temperature to rise during high-speed driving, which in turn increases the tire pressure. In such cases, stop the vehicle immediately to rest or replace the tire with the spare.

5

Share

What is the battery model for the Mercedes-Benz S-Class key?

The battery models are CR2032 and CR2025-3V. These are lithium manganese dioxide batteries, named according to the IEC standard. Among them: C - indicates a chemical battery system with lithium metal as the negative electrode and manganese dioxide as the positive electrode; R - indicates that the battery is cylindrical in shape, with F used if it is square; 20 - indicates the battery diameter is 20mm; 32 - represents a battery height of 3.2mm; 25 represents a battery height of 2.5mm; The nominal voltage is 3.0V, the endpoint voltage is 2.0V, and the rated capacity is approximately 200mAh. CR2032 typically has a lifespan of 5 years. If the manufacturer's production level is low or quality control is poor, its lifespan may be significantly shortened. Domestic first-tier brand batteries can generally guarantee this lifespan. Under ideal conditions (sealed, room temperature, no moisture interference, etc.), the lifespan can be extended to 8 years or even 10 years. The usage time of a car remote key battery is closely related to the frequency of use. The more frequently it is used, the shorter the battery life will be. If the remote key battery runs out, you can use the mechanical key to open and start the vehicle. Car remote keys use button batteries, mainly in models such as CR2016, CR2025, CR2032, and CR2450. For the specific model used in each key, owners can refer to the battery model in the user manual for replacement. Button-type CR2016 battery: This is one of the most commonly used remote key batteries. The battery voltage is 3V, and most car key batteries operate at 9V, so three batteries need to be replaced each time. Examples include Honda, Toyota, Volkswagen, Mazda, etc. CR2016 specifications: battery diameter is 20mm, thickness is 1.6mm. Button-type CR2025 battery: Its usage rate is much lower than CR2016, but it is still used in some car keys. It is thicker than the 2016 model but has a relatively higher storage capacity. CR2025 specifications: battery diameter is 20mm, thickness is 2.5mm. This type of battery is also commonly used in audio remotes. Button-type CR2032 battery: Its thickness is twice that of CR2016. The 3V-CR2032 lithium manganese battery belongs to the lithium-manganese dioxide structure. The positive electrode material is chemically stable manganese dioxide, the negative electrode is lithium metal, and the electrolyte is a lithium battery electrolyte. The main components of the electrolyte are dimethoxyethane, propylene carbonate, and lithium perchlorate. Its shape resembles a button, hence the name button lithium battery or lithium manganese button battery. Button-type CR2450 battery: Compared to the other three models, it is thicker and larger, with a diameter of 24.5mm and a height of 5.0mm. The rated current value for CR2450 is 0.2mA, mainly used in low-power electronic products. Generally, such batteries can provide an output current of 0.001mA to 5mA, with a continuous output current of up to 15mA and a flash output current of up to 30mA, meeting the requirements of most small electronic products for lighting, sound, and RF output.

9

1

Share

What car brand is smart?

smart is the brand of Smart Car, which is an ultra-micro compact car. Taking the 2019 smart fortwo as an example, its body dimensions are: length 2695mm, width 1663mm, height 1555mm, wheelbase 1873mm, fuel tank capacity 33l, and curb weight 956kg. The 2019 smart fortwo features a McPherson strut independent front suspension and a torsion beam non-independent rear suspension. It is equipped with a 0.9l turbocharged engine, delivering a maximum horsepower of 90ps, maximum power of 66kw, and maximum torque of 135nm, paired with a 6-speed dual-clutch transmission.

4

5

Share

Where is the production base of Great Wall WEY?

Is the BMW X5 equipped with a timing belt or chain?

How many liters of engine oil should be added to a BMW X5?

How to Solve the Sudden Failure to Start a Mercedes-Benz C180?

Where is the tire pressure reset for the BAIC X35?

What is the battery model for the Mercedes-Benz S-Class key?

What car brand is smart?

Will leaving a small gap in the car window during rain have any impact?

What Causes the Yellow Triangle with Exclamation Mark Warning Light to Illuminate in the Magotan?

What is the RPM of the Baojun 510 at 120 mph?

Differences Between Cast Iron and Aluminum Alloy Engine Blocks