Where is the production base of Dongfeng Honda Civic located?

1 Answers
OmarFitz
07/29/25 8:41pm
Dongfeng Honda Civic's production base is located in the Wuhan Economic and Technological Development Zone. It is an A-segment car. Taking the 2021 Civic 1.5T as an example, it belongs to the compact car category with body dimensions of: length 4517mm, width 1799mm, height 1434mm, a wheelbase of 2700mm, a fuel tank capacity of 47L, and a curb weight of 1343kg. The 2021 Civic 1.5T features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.5L turbocharged engine delivering a maximum horsepower of 177PS, maximum power of 130kW, and maximum torque of 220Nm, paired with a continuously variable transmission (CVT).
Was this review help?
4
3
Share
More Forum Discussions

What are the time requirements for the Subject 2 test items?

The specific time requirements for the Subject 2 test items are as follows: 1. No overall time limit: There is no stipulated overall time limit for Subject 2. 2. Reverse parking in a garage: The completion time for reverse parking must not exceed 210 seconds (starting from engaging the reverse gear), otherwise it will be considered a test failure. 3. Parallel parking: The completion time for parallel parking must not exceed 90 seconds, otherwise it will be considered a test failure. 4. Hill start: After stopping on the slope, you must start and move uphill within 30 seconds. 5. Special circumstances: Subject 2 generally takes about 10 minutes from start to finish, though this is based on most areas currently testing only 5 items. For areas that require testing 9 items, the time will be slightly longer.
20
3
Share

Should I replace the tire if there is a cut on it?

If there is a bulge or cut on the car tire, it is recommended to replace the tire. The specific reasons are as follows: 1. Broken steel wires: A bulge indicates that one or more steel wires inside the tire have broken, causing the rubber to be unable to withstand the internal pressure of the tire, resulting in a bulge. A cut on the tire sidewall is also dangerous because the sidewall is the weakest part of the tire. A cut can compromise the strength of the sidewall, making the rubber thinner in that area. Thinner rubber may not withstand the internal pressure of the tire, potentially leading to a blowout. Generally, bulges and cuts are caused by external damage to the tire. 2. Recommendation: When parking, try not to get too close to the curb to prevent the tire sidewall from rubbing against the road and causing a bulge. If there is a bulge or cut, the tire should be replaced to avoid the risk of a blowout during continued use.
2
1
Share

How to Open a Locked Urea Tank Cap?

If you have the key, press it firmly and turn counterclockwise. If you don't have the key, there is a notch at the top or bottom; align it, press down, and turn. There will definitely be a rotation arrow on the cap. Additional Information: 1. Automotive Urea: Automotive urea is an essential product for heavy-duty diesel vehicles to meet the China IV emission standards. It refers to a urea aqueous solution with a urea concentration of 32.5% and a solvent of ultra-pure water, made from urea crystals and ultra-pure water. Heavy-duty trucks, buses, and other diesel vehicles must use an appropriate SCR system in their exhaust treatment to meet the China IV emission standards. This system requires the use of a urea solution to treat nitrogen oxides in the exhaust. 2. SCR System: SCR is the optimal choice for emission reduction. Currently, China's diesel standard GB19147-2009 requires a sulfur content ≤350ppm, while ECR-DOC technology requires fuel with a sulfur content below 10ppm. SCR can tolerate diesel with a sulfur content of 350ppm, making it technically feasible for widespread adoption. SCR-equipped China IV engines offer better fuel economy than EGR technology, require fewer modifications to the engine, have lower demands on fuel and oil, and have advantages in the continuity of technological upgrades. SCR catalysts also have good durability and do not risk clogging.
16
2
Share

How Much Does Using Air Conditioning Affect Fuel Consumption?

Using air conditioning increases fuel consumption by approximately 20%. Relevant details are as follows: 1. Contributing factors: The car's air conditioning system consumes about 20% of the engine's power. Therefore, using the AC utilizes a portion of the engine's power, leading to increased fuel consumption. The exact increase depends on the vehicle's engine displacement and speed. For a car that typically consumes 10 liters per 100 kilometers, using the AC can increase fuel consumption by around 2 liters. The impact of air conditioning on fuel consumption is quite noticeable, though different fan speeds have a smaller effect. 2. Heating system: The heating system works quite differently. Since the engine generates heat, this warmth serves as the source for the heating system, essentially recycling energy. As a result, using the heating system generally does not consume additional fuel. Many people prefer to set the AC to the lowest temperature for maximum cooling, which further increases fuel consumption.
10
1
Share

Where is the Low Beam Switch Located?

The low beam switch of a car is located on the control lever on the lower left side of the steering wheel. Below are the usage methods and precautions for low beams: 1. Driving sections: When driving in areas without streetlights at night, or during dusk when it's darker or at dawn when light first appears, the low beams must be turned on. 2. Special weather conditions: In case of heavy fog, snow, or heavy rain where visibility is obstructed, the low beams must be turned on even during the day. 3. Insufficient brightness: On some roads where there are lighting facilities but the brightness is inadequate, the low beams should also be turned on. When driving on urban roads, do not use high beams as they can affect the normal driving of oncoming vehicles.
17
3
Share

What season is 15w50 engine oil used in?

15w50 engine oil is used in summer. Here are the specific details about motor vehicle engine oil: 1. Introduction: Engine oil serves functions such as lubrication, cleaning, cooling, sealing, and friction reduction for the engine. It can be roughly categorized into three types: mineral oil, semi-synthetic oil, and fully synthetic oil. Generally, fully synthetic oil has a longer replacement interval, a wider temperature range, and is less volatile compared to semi-synthetic or mineral oil. 2. Maintenance: Change the engine oil every 5000 kilometers, replace the engine oil and clean the carburetor every 15000 kilometers, inspect and clean the air filter, replace the gear oil, adjust the valves every 30000 kilometers, replace the engine oil and gear oil, clean the carburetor, replace the air filter, after the break-in period, clean the carburetor every 2000 kilometers, replace the filter and engine oil, and the gear oil can be replaced every 3000 kilometers.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.