Where is the Peugeot 4008's Cabin Air Filter Located?

1 Answers
HarperDella
07/29/25 10:55pm
The cabin air filter of the Peugeot 4008 is located at the lower left side of the glove compartment on the passenger side. The cabin air filter can absorb dust particles, alleviate respiratory discomfort for occupants, reduce irritation for allergy sufferers, and enhance driving comfort. The Peugeot 4008 is a compact SUV with the following dimensions: length 4340 mm, width 1800 mm, height 1625 mm, wheelbase 2670 mm, and a fuel tank capacity of 53 liters. The Peugeot 4008 is equipped with a 1.6-liter turbocharged engine, delivering a maximum power of 125 kW at 5500 rpm and peak torque between 1750 and 4500 rpm.
Was this review help?
3
3
Share
More Forum Discussions

What to Do If Car Keys Are Locked Inside the Car?

Methods to deal with car keys locked inside the car are as follows: 1. If the car keys are locked inside, you can use a spare key. 2. If there is no spare key, you will need to call a professional locksmith or the after-sales service of a 4S store to unlock the car. 3. If you are in a remote location where the above two methods are difficult to implement, you may resort to a more drastic measure, such as breaking a window to open the door. Here are some brief tips to avoid locking car keys inside: (1) Before leaving the car, always check if the keys are in your hand. (2) For owners of cars that start with a physical key, remember to remove the key and take it with you after turning off the engine. (3) For owners of cars with a push-button start, it is best to keep the key in a pocket or a bag at all times. Use the keyless entry function to open and close the car door, and avoid holding the key in your hand casually to prevent misplacement.
12
3
Share

How to Turn Off the Car Heater?

To turn off the car heater, follow these steps: 1. First, locate the vehicle's control buttons, usually found below the center console screen. 2. Find the OFF button and press it to turn off the heater. Alternatively, press the AC button to turn off the air conditioning system. Below are the components responsible for heating in a car: Compressor; Electrically controlled clutch; Condenser; Evaporator; Expansion valve; Receiver drier; Hoses; Condenser fan; Vacuum solenoid; Idler; Control system.
20
3
Share

What does 'folder' mean in a car?

The 'folder' button in a car means 'folder' in Chinese, referring to switching between folders. Here is a brief introduction: The 'folder' button is located on the radio player, which is a general term for radios and single players. Nowadays, it has evolved into the audio equipment in cars, including radios (FM, AM), tape players, CD players, and MP3 players. Here is an introduction to the function of the 'folder' button: When you have created two or more song folders, pressing the 'folder' button will automatically jump to the second folder.
18
0
Share

How to Deal with Carbon Monoxide Exhaust?

There are three methods to deal with carbon monoxide exhaust: 1. Clean the three-way catalytic converter: Use a drip bottle to inject cleaning solution into the vacuum tube of a running engine, similar to an IV drip. The solution burns off carbon deposits in the combustion chamber, enhancing engine power. It then cleans the contaminated three-way catalytic converter in the exhaust pipe, restoring its original function of energy saving and emission reduction. 2. Spray nano-precious metal platinum-rhodium-palladium liquid into the aged three-way catalytic converter: If the rare metals platinum, rhodium, and palladium inside have deteriorated and cleaning fails to restore the exhaust purification effect, spraying nano-precious metal platinum-rhodium-palladium liquid into the removed three-way catalytic converter can effectively treat carbon monoxide exhaust. 3. Use a Fire Lotus three-way catalytic metal soft carrier: If the three-way catalytic converter is empty, insert the Fire Lotus three-way catalytic metal soft carrier into the exhaust pipe to act as the original converter's carrier, purifying carbon monoxide exhaust.
5
2
Share

How to Tighten a Loose Steering Wheel?

Steering wheel too loose adjustment steps are as follows: 1. First, check if there is any gap in the steering ball joint, and tighten the ball joint screw slightly. 2. If there is no gap, then adjust the steering gear. 3. If it still doesn't work, it may be that the steering system is broken. It is best to go to a repair shop for professional inspection and repair by a mechanic. The following are possible causes of a loose steering wheel: (1) Severe wear of the steering gear and tie rod ball joint, the steering universal joint wear produces a gap, there is a gear-shaped shaft where the steering wheel horn is pressed, it is estimated that the teeth on the gear-shaped shaft are worn off. (2) The steering gear is without power assistance, the actual failure caused by damage to the steering system.
6
1
Share

Does the Transmission Filter Need to Be Replaced?

The transmission filter needs to be replaced, typically when the transmission fluid is changed. Common types of automatic transmission filters include those for dual-clutch transmissions (DCT), automatic transmissions (AT), and continuously variable transmissions (CVT). Here is a brief introduction to the three types of transmissions: (1) Dual-clutch transmissions (DCT) are currently very popular due to their fast gear-shifting speed and high transmission efficiency. The structure of a DCT is similar to that of a manual transmission, but it features two sets of clutches—one for odd-numbered gears and the other for even-numbered gears. (2) Automatic transmissions (AT) are the most widely used, technologically mature, and have the highest production and R&D costs. They offer excellent gear-shifting smoothness and durability. (3) Continuously variable transmissions (CVT) have a simple structure, compact size, and lightweight design. Their production cost is relatively low, making them a common choice for many affordable family cars.
15
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.