Where is the Peugeot 301's Air Conditioning Filter Located?

1 Answers
JayceLee
07/25/25 10:36am
Peugeot 301's air conditioning filter is located inside the left glove compartment. Open the cover panel near the passenger's left foot area, press inward at the center of the glove compartment, and the lower corner will pop out. Then, pull it firmly to remove. The Peugeot 301 is the first new model under Peugeot's new naming system to end with '1', primarily designed for emerging markets while adopting Peugeot's new naming strategy. In terms of exterior design, the Peugeot 301 features a sedan body style with a length of 4440mm and a wheelbase of 2650mm. The overall design is compact, with a short and powerful rear styling. The trunk capacity of this vehicle is 506L.
Was this review help?
4
3
Share
More Forum Discussions

What is the battery model for the Geely Borui car key?

Geely Borui car key uses CR2025 battery. The method to replace the battery: 1. Turn the remote key upward and slowly insert a flat small screwdriver into the middle of the gap; 2. The key will separate by about 2mm; 3. Gently separate the key along the middle gap, remove the old battery, and replace it with a new one. The Geely Borui is the first model under Geely to incorporate Volvo's safety technology concepts, equipped with a 1.5-liter turbocharged engine and a 1.8-liter turbocharged engine. In terms of body dimensions, the Geely Borui measures 4986mm in length, 1861mm in width, and 1513mm in height.
7
1
Share

How to Clean Carbon Deposits on Spark Plugs?

Methods to clean carbon deposits on spark plugs: 1. Remove the spark plugs from the engine; 2. Take a square beverage bottle and cut four holes slightly larger than the spark plug threads on it; 3. Lay the bottle flat, pour white vinegar into it, then place the spark plugs into the holes, ensuring the white vinegar just covers the spark plug electrodes; 4. Depending on the severity of the carbon deposits, determine the soaking time, generally 3 to 5 hours, for particularly severe cases, it can be extended but should not exceed 12 hours; 5. Remove the spark plugs and scrub them with a soft-bristled brush like a toothbrush to clean off the carbon deposits.
12
0
Share

Where is the fog light located on the Panamera?

The fog light on the Panamera is located near the control panel. The functions of fog lights are: Front fog lights are used to improve illumination when the road conditions ahead are unclear and can alert oncoming drivers; rear fog lights allow vehicles behind to spot the car in low visibility conditions. How to turn on car fog lights: Locate the light control lever below the steering wheel, find the fog light symbol, rotate the control ring, and align the front fog light symbol to the "on" position. When to use fog lights: Heavy rain when the driver's visibility is blurred and it's difficult to assess surroundings; foggy weather; when driving at night with no streetlights or poor illumination.
9
3
Share

What Causes the Electronic Parking Brake Failure in the New Mondeo?

The causes and solutions for the electronic parking brake failure in the New Mondeo are as follows: Rear Brake Pad Malfunction: If this issue occurs after replacing the rear brake pads, it is recommended to re-learn the matched electronic brake. If the fault appears without rear pad replacement, check the fuse. Parking Brake Switch Circuit Failure: Inspect whether the electronic parking brake switch circuit is functioning normally. Professional diagnostic equipment can also be used for testing and decoding. First, use a scanner to identify the specific fault—whether it's the actuator, sensor, or control module. The control module may only require reprogramming to resolve the issue.
12
4
Share

How many cylinders does the Yixuan engine have?

Yixuan engines come in both three-cylinder and four-cylinder versions. The three-cylinder engine is a 1.0-liter turbocharged engine with the specific model DFMC10TDS, delivering a maximum horsepower of 125 hp, a maximum power of 92 kW, and a maximum torque of 196 Nm. The four-cylinder engine is a 1.5-liter turbocharged engine with the specific model DFMA15T, producing a maximum horsepower of 150 hp, a maximum power of 110 kW, and a maximum torque of 230 Nm. The Yixuan is a compact sedan produced by Dongfeng Passenger Vehicle, with dimensions of 4660mm in length, 1812mm in width, 1490mm in height, and a wheelbase of 2680mm.
2
3
Share

Why does the Audi A1 shake during cold start?

The reasons for the Audi A1 shaking during cold start include insufficient engine temperature and excessive internal carbon buildup. The specific causes and solutions are as follows: Insufficient engine temperature: When the engine temperature is low, the temperature inside the engine is insufficient, and the fuel and lubricant temperatures are also inadequate, making cold starts difficult. Solution: Keep the engine warm to help it heat up. Excessive internal carbon buildup: Carbon deposits on the engine valves and intake passages can absorb an appropriate amount of fuel, failing to achieve the required power performance, resulting in shaking during cold starts. Solution: Perform a system cleaning.
11
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.