Where is the oil filter located in the Geely Boyue manual transmission?

1 Answers
QuinnMarie
07/30/25 2:33am
Geely Boyue's oil filter is located at the upper right front of the engine. Method to check the oil filter model: Check the manufacturer's part number on the oil filter housing, then refer to the vehicle maintenance manual. Method to replace the oil filter: First, turn off and cool down the vehicle, open the engine hood, unscrew the engine oil filler cap, then lift the vehicle. After confirming the lifting safety, start working by unscrewing the oil pan drain plug and collecting waste oil with an oil bucket. After draining completely, let it sit for ten minutes before tightening the drain plug. Introduction to the oil filter: The oil filter is used to remove debris, gum, and moisture from the oil, delivering clean oil to various lubrication points.
Was this review help?
19
2
Share
More Forum Discussions

Should the BMW 3 Series use 95 or 92 octane gasoline?

BMW 3 Series uses 95 octane gasoline. If 95 octane gasoline is unavailable, 92 octane gasoline can be used as an emergency measure, but this is only permissible when driving at medium engine speeds and under low engine load. Here is some additional information: 95 octane gasoline consists of 95% isooctane and 3% n-heptane. High-octane gasoline should be used in engines with high compression ratios. BMW is a German luxury car brand, with model series including i, X, Z, and pure numeric models, as well as the M series, which is based on improvements to these series. The BMW 3 Series has a body weight of 1,465 kilograms, is equipped with an inline 4-cylinder gasoline engine, and has dimensions of 4,734mm in length, 1,811mm in width, and 1,455mm in height. BMW was founded in 1916 and is headquartered in Munich, Bavaria, Germany.
20
1
Share

How many seconds does the BMW 530 take to accelerate from 0 to 100 km/h?

BMW 530 takes 7.18 seconds to accelerate from 0 to 100 km/h. Factors affecting the 0-100 km/h acceleration time: The influencing factors of 0-100 km/h acceleration time include: engine power and torque, engine power output curve characteristics, transmission, vehicle weight, tuning orientation, tuning capability, drag coefficient, tires, etc. Differences in these factors will all affect the 0-100 km/h acceleration time. The 0-100 km/h acceleration time is one of the main indicators of a vehicle's dynamic performance, but it is not an indicator of the engine's performance alone. Vehicle 0-100 km/h acceleration: 0-100 km/h acceleration refers to the time it takes for a car to accelerate from 0 km/h to 100 km/h, which is the most intuitive reflection of a car's power. Together with the maximum gradeability and maximum speed, it constitutes the evaluation indicators of a vehicle's dynamic performance.
15
1
Share

What are the reasons for the weak airflow from the air vents in a BMW 3 Series?

The reasons for the weak airflow from the air vents in a BMW 3 Series are as follows: Incorrect air direction selection: If the air direction is set to blow towards the front windshield, it will significantly reduce the airflow. Blower motor malfunction: Common issues with the blower motor include failure to operate, abnormal noise, short circuit, or insufficient power. When the blower motor malfunctions, the cold air from the vehicle's evaporator cannot be distributed, leading to evaporator icing and ultimately affecting the normal operation of the car's air conditioning. Condenser or evaporator blockage: If the condenser's exterior or evaporator is clogged with debris such as catkins or dust, it will impair the condenser's efficiency, ultimately affecting the car's cooling performance. Additionally, excessive dirt on the evaporator's surface can easily degrade the air conditioning's cooling effect. Dirty air filter: If the car's air filter is excessively dirty, it can obstruct the airflow, allowing only a portion of the air to enter the cabin, which naturally results in a noticeable reduction in airflow.
13
5
Share

Why is the BMW 535i Rarely Seen?

BMW 535i is priced high. The following is additional information: Currently, the price of the BMW 5 Series is much lower than that of the BMW 535i. At the price of a 535i, one could consider the BMW 7 Series. The cost-performance ratio is relatively low, and the exterior of this car is no different from that of the Brilliance BMW. It features the same angel-eye headlights and kidney grille, with identical body dimensions, making it hard to distinguish without looking at the rear badge. The 535i is an imported model, while the 535Li is the extended version produced by Brilliance. Apart from both being part of the 5 Series, the two models differ in length, wheelbase, craftsmanship, quality, and configuration. Comparatively, the domestic version offers more configurations than the imported one. Moreover, the cost of owning an imported car is significantly higher than that of a domestic one, including expenses like insurance, maintenance, and repairs.
12
4
Share

What are the reasons not to buy the Magotan GTE?

Reasons not to buy the Magotan GTE are as follows: Oil-to-electric conversion model: Oil-to-electric conversion refers to modifying a fuel-powered car into a pure electric or plug-in hybrid model based on the original structure of the fuel vehicle. The Magotan GTE is modified from the fuel-powered Magotan, making it an oil-to-electric conversion model. The reason people dislike oil-to-electric conversion models is that, to reduce costs, significant modifications are not made to the original structure. This results in large batteries and motors having no proper place to be installed, forcing them to be 'inserted' in a scattered layout, which to some extent is detrimental to battery temperature control. Small trunk volume: To accommodate the battery and motor, the Magotan GTE sacrifices some trunk space. The luggage compartment volume is only 457L, far less than the 533L of the fuel-powered version. Additionally, the biggest issue with the Magotan GTE's trunk is its low height, making it difficult to fit large-sized luggage.
6
4
Share

What is the ground clearance of the BMW 3 Series?

110mm to 150mm. Below is extended content: This mid-size car from BMW Brilliance adopts a double-joint spring strut front suspension at the front axle and a multi-link independent suspension at the rear, with a chassis height (minimum ground clearance) of 138mm. The minimum ground clearance of a car, often referred to as chassis height, is the distance between the car's chassis and the ground when the vehicle is at maximum load capacity. The minimum ground clearance reflects the car's ability to pass over obstacles or uneven terrain. In previous standards, chassis height was regulated to be approximately between 150mm and 160mm, but current standards have eliminated this mandatory requirement. Theoretically, the minimum ground clearance of a sedan, commonly known as chassis height, typically ranges between 110mm and 150mm. From the characteristics of sedans, a larger ground clearance (exceeding 130mm) generally improves off-road capability, but at the cost of slightly reduced stability at higher speeds. Conversely, a ground clearance below 110mm enhances high-speed stability but compromises performance on complex road surfaces. Nowadays, some cars are equipped with air suspension systems that can automatically adjust chassis height in real-time, perfectly balancing both stability and off-road capability.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.