Where is the OBD port on a Haval?

1 Answers
StDerek
07/29/25 10:14am
Haval's OBD port is located under the steering wheel, above the brake pedal. It is a rectangular 16-pin interface. The Honda Civic's OBD port is positioned in the driver's footwell, concealed under the dashboard near the right side of the accelerator pedal. OBD System: OBD stands for On-Board Diagnostics, which translates to a detection system extended for automotive fault diagnosis. Principle of the OBD System: The OBD system continuously monitors the engine's operating conditions to check if the vehicle's emissions exceed standards. If they do, it immediately issues a warning. Function of the OBD System: After the implementation of the OBD II program, any technician can use the same diagnostic tool to diagnose any vehicle manufactured according to the standard.
Was this review help?
19
4
Share
More Forum Discussions

How to adjust the audio system in Lavida?

Increase the bass equalizer BASS by 1-2 notches, and leave other settings unchanged. If unsatisfied with the sound field, you can shift the sound field positioning one step forward. Generally, the factory audio system merely produces sound.
19
2
Share

How to replace the battery in an Audi A6 key?

Use a screwdriver to open the back cover and unscrew the three screws. You will see the remote control split into two halves—one with the circuit board and the other with the casing. Take the half with the circuit board and pry it open. You will find a gray component in the upper right corner. Lift it to reveal the encryption chip. Behind the button rubber, there are screws. Open it to see the battery inside. Remove the old battery and replace it with a new one.
11
3
Share

How to Adjust Car Audio Settings?

Reset all additional functions of the car audio system to factory settings, then set the treble, midrange, and bass to the middle position, and do the same for the left-right balance. Set the amplifier volume to the lowest position, FILTER to OFF, and CROSSOVER to the lowest setting.
1
3
Share

How to Activate Cruise Control in the Elysion?

Press the "CRUISE" button on the right side of the steering wheel, and the display will show this English text, indicating the program is activated. Accelerate to over 40 km/h, then press the "SET" button to lock the speed, after which you can release the accelerator. While the speed is locked, each press of the "SET" button slightly decreases the speed by about 2 km/h, and each press of the "RES" button slightly increases the speed by about 2 km/h.
7
5
Share

How to Identify the Safety Line on Tire Sidewalls?

Tire sidewall patterns feature a small triangular indicator every 60 degrees, which serves as a positional marker. Run your fingers along this triangle towards the tread surface. Typically, there are two grooves on the tread where you can feel a transverse line. This transverse line is the tire safety indicator. When the tread's raised portion wears down to this line, the tire should be replaced.
2
0
Share

How to judge the distance in the rearview mirror?

When the car on the left side of the rearview mirror has part of its front no longer visible, it indicates that the distance between the following vehicle and your car is approximately five meters. If the front of the car is no longer visible in the rearview mirror, it means the distance between the cars is less than 3 meters.
4
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.