Where is the OBD interface of Chery A3?
4 Answers
The OBD interface of Chery A3 is located in the small storage compartment below the left side of the steering wheel. Information about OBD is as follows: OBD: Chinese translation is "Vehicle Diagnostic System", the OBD diagnostic socket is the bridge (interface) connecting the computer and the human diagnostic system. Function: Fault codes can be read from the PCM through specific procedures. Information about Chery A3 is as follows: Engine: Equipped with Chery 1.6L, 1.8L, 2.0L and other engines, paired with a continuously variable transmission and a five-speed manual transmission. Features: Four airbags (dual front airbags, dual side curtains), ABS+ESP, EPS electric power steering system, GPS global positioning navigation system, DVD audio/video navigation system, electric sunroof, intelligent anti-theft system, etc.
When I used to drive a Chery A3, I often helped friends locate the OBD port, which was in the area under the driver's seat, at the very bottom of the dashboard. After getting into the car, you just need to look down, and it's roughly above the left side of the accelerator pedal. You can easily find the square-shaped port by feeling around or using a flashlight. The position is quite standard, unlike some cars where it's hidden too deep. The design is user-friendly, making it convenient to plug in diagnostic equipment to check for trouble codes anytime. I remember one time when my engine light came on, I scanned the code myself using the OBD and found it was a sensor issue, saving me a trip to the repair shop. Just be careful not to let water or debris splash into it while driving. During maintenance, technicians also use this port, and since it's easy to find, it's not much of a hassle.
My Chery A3 has been in use for several years, and the OBD interface is right next to the driver's foot area. Just look down below the dashboard, near where your left foot rests. It's actually not too hard to find—I located it in a dim garage using my phone's flashlight. Normally, it doesn't get in the way, but it's super convenient when you need to read fault data. Last time I went for a vehicle inspection, the technician plugged right into it to check emissions and other data. The placement is well thought out and not complicated. For new drivers, I’d advise taking your time—crouch down and look carefully. There might be wiring near the interface, so be careful not to kick it. Knowing this location is quite practical, especially if a warning light comes on, allowing you to address it promptly.
As a car enthusiast, I really appreciate the OBD interface layout of the Chery A3. It's positioned at the lower end of the dashboard on the driver's side, right above the footwell area. The location is clear and straightforward, making it super quick to plug in diagnostic equipment for troubleshooting. I often use it to adjust parameters when modifying my car. The standardized design ensures no interference during daily driving while maintaining efficiency during maintenance. Keeping the area around the interface clean and unobstructed is crucial.
