Where is the OBD interface located on the MG3?

Does the new Qashqai have front and rear anti-collision beams?

The new Qashqai is equipped with front and rear anti-collision beams. Here is the relevant information: Nissan Qashqai front anti-collision beam: The front anti-collision beam is made of a double-layered bow-shaped rolled steel plate with a thickness of 1.22 mm. This thickness is not particularly high and ranks among the lowest for rolled steel plate anti-collision beams. Although it meets safety standards, in actual crash tests, this thickness is insufficient to protect the radiator. The anti-collision beam bends while the energy absorption box shows no significant deformation. Nissan Qashqai rear anti-collision beam: Generally, the rear anti-collision beam is of a lower grade than the front one, but its structure is very similar to the front anti-collision beam. It also comes with thick pedestrian protection foam. The tested thickness of the rear anti-collision beam is also only 1.22 mm, but it is slightly longer overall, covering 70.06% of the rear area.

16

2

Share

How to Drive an Automatic Transmission Car Down a Long Slope?

Automatic transmission car down a long slope method is: 1, Start: Put the gear lever in P gear (transmission lock gear), only in P gear can the car be started, step on the brake and start the engine, let the engine run for a while when the car is cold, put the gear lever in D gear, release the handbrake and turn on the left turn signal, you can honk twice according to the situation, finally release the foot brake and slowly step on the accelerator to start the car; 2, Normal driving: Switch to L gear or M gear; 3, After going downhill, switch back to D gear and step on the accelerator directly. The gears of an automatic transmission car are: 1, P is the parking gear; 2, R is the reverse gear; 3, N is the neutral gear; 4, D is the drive gear; 5, S gear or L gear is in the low gear range, which can be used in situations such as slopes.

14

3

Share

Do automatic transmission cars have idle speed?

Automatic transmission cars do have idle speed, which is one of the five basic operating conditions of an engine, representing a working state when the car engine is running without load. Idle speed refers to the engine running without any load, only overcoming the internal friction resistance of its components without delivering power output. In other words, when the engine is running and the accelerator pedal is released, it enters idle speed state. The idle speed can be adjusted by modifying the throttle opening size and idle fuel supply quantity. As long as the engine doesn't vibrate within the idle speed range and maintains good acceleration performance, the setting is appropriate. It's important to note that when adjusting idle speed, the RPM should not fluctuate excessively, as this could cause wear to the engine.

10

3

Share

Which car brand does the Leapmotor S01 belong to?

Leapmotor S01 belongs to the Leapmotor brand, which was jointly invested by Zhejiang Dahua Technology Co., Ltd. and its major founders. It is an innovative intelligent electric vehicle enterprise with complete independent R&D capabilities for intelligent electric vehicles. The dimensions of the Leapmotor S01 are 4075mm in length, 1760mm in width, and 1380mm in height, with a wheelbase of 2500mm, and it is equipped with a fixed gear ratio transmission. The body type of the Leapmotor S01 is a 3-door, 4-seat hatchback, with a top speed of 140 km/h, a luggage compartment volume of 237 to 690L, and tire specifications of 205/45R17.

12

4

Share

Does driving through a yellow light count as running a red light?

Driving through a yellow light is also considered running a red light, as both running a yellow light and running a red light fall under the same traffic violation—driving a motor vehicle in violation of traffic signal regulations. According to Article 10 of the "Road Traffic Safety Law of the People's Republic of China," this offense is punishable by a fine and a deduction of 6 points from the driver's license. The "Road Traffic Safety Law of the People's Republic of China," Article 26, stipulates: Traffic signals consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light indicates permission to proceed, and a yellow light serves as a warning. Article 26 of the "Road Traffic Safety Law" further states: A yellow light serves as a warning, and motor vehicles should slow down when approaching an intersection. If the vehicle has already crossed the stop line when the yellow light turns on, it may continue through the intersection. If the vehicle has not yet crossed the stop line, it must stop. Article 38 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China" specifies the meanings of motor vehicle and non-motor vehicle traffic signals: When the green light is on, vehicles are permitted to proceed, but turning vehicles must not obstruct the passage of through vehicles or pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. When the red light is on, vehicles are prohibited from proceeding. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the motor vehicle traffic signals. When the red light is on, right-turning vehicles may proceed if they do not obstruct the passage of through vehicles or pedestrians. Electronic traffic enforcement cameras capture red-light violations based on the following three images, which are reviewed by traffic police to determine whether a violation occurred: An image of the vehicle not having passed the stop line when the red light is on. An image of the vehicle's front wheels crossing the stop line. An image of the vehicle's entire body having crossed the stop line. If these three images show that the vehicle moved beyond the stop line while the red light was on, the traffic police may determine that the vehicle ran a red light. To avoid running a yellow light: Slow down when approaching an intersection, maintain a speed of 20–30 km/h, keep a safe distance from the vehicle ahead, and avoid tailgating or rushing through the yellow light. Alternatively, observe the traffic signal timing in advance—if the green light has been on for a long time and traffic is light, prepare to slow down.

10

2

Share

Reasons for the Buzzing Sound When Turning on the Car Air Conditioner

Reasons for the buzzing sound when turning on the car air conditioner include: 1. Damaged air conditioner blower bearing, the blower should be replaced; 2. Problem with the air conditioner compressor, the compressor should be replaced; 3. Damaged motor of the exhaust fan inside the air conditioner, the motor or the entire fan should be replaced; 4. Deformed blades of the exhaust fan inside the air conditioner, the fan should be replaced; 5. Excessive dirt inside the air conditioner, cleaning the air conditioner is sufficient. The car air conditioner is an air conditioning device installed in vehicles, capable of cooling, heating, ventilating, and purifying the air inside the cabin, providing a comfortable environment for passengers, reducing driver fatigue, and improving driving safety.

3

4

Share

Where is the OBD interface located on the MG3?

Does the new Qashqai have front and rear anti-collision beams?

How to Drive an Automatic Transmission Car Down a Long Slope?

Do automatic transmission cars have idle speed?

Which car brand does the Leapmotor S01 belong to?

Does driving through a yellow light count as running a red light?

Reasons for the Buzzing Sound When Turning on the Car Air Conditioner

Why Does the Sylphy's Shock Absorber Make Noise?

How to turn off and park a Mercedes-Benz C260L?

How to reset the maintenance light on Citroen C3?

What is the tire size for Honda Accord?