Where is the OBD connector of BAIC Huansu S3?
3 Answers
The OBD interface of BAIC Huansu S3 is located under the glove box on the passenger side. After adjusting the passenger seat, you can see it by putting your head in. The OBD interface of the car can be connected to the diagnostic computer. After connecting to the diagnostic computer, the technician can read the fault codes of the car. The fault codes can help the technician quickly determine the cause and location of the fault. The following is an introduction to the car OBD: The meaning of car OBD is "On-Board Diagnostics". OBD is the abbreviation of On-Board Diagnostics. The OBD system mainly monitors the operating status of the engine and the working status of the exhaust gas treatment system in real time. Once the engine and exhaust gas treatment system fail or the data is abnormal, the OBD system will store the fault code and light up the fault lamp.
I've encountered the issue of locating the OBD port before. On the BAIC Huansu S3, it's typically found in the left dashboard area below the steering wheel. Having driven many cars, it's usually there—just crouch down and look near the pedals for a 16-pin connector. This makes it convenient to connect a diagnostic tool for reading trouble codes, such as those related to the engine or emissions. If you can't find it, check above the driver's footwell, but avoid pulling forcefully to prevent damaging the wiring. It's a good habit to familiarize yourself with its location while driving, as it saves time during safety checks or troubleshooting. Regularly cleaning the port to remove dust and debris is recommended to prevent poor contact from affecting diagnostics. If you still can't locate it, refer to the user manual or visit a 4S store for free advice to ensure worry-free driving.
The OBD port of my Huansu S3 is located above the driver's footwell area, close to the lower edge of the steering wheel. As a car enthusiast, I often connect it to mobile apps to monitor fuel consumption and vehicle status, which is quite fun. The location is easy to find—just open the door and look for a small plastic cover near the floor mat. Remember to plug and unplug devices gently to avoid loose wiring or short circuits. Using it for diagnostics can save repair costs and prevent minor issues from escalating. If your car is older, the position might vary, so checking the manual with the diagram is always accurate.
